Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Conyers
Gate access control in Conyers means keeping two very different kinds of properties working: the 1990s and 2000s HOA subdivisions with ornamental iron driveway gates, and the horse farms running heavy slide gates off SR-138. We service both from the same truck, and we’ve been doing it long enough that we know which legacy boards can be rescued and which ones belong in the scrap bin. If your keypad, phone entry, or video intercom is acting up in Conyers, call (877) 610-2993 and a real person answers, day or night.
Here’s the short version: most access control failures around Conyers are repairable without replacing the whole system. Red clay shifts the posts, the photo-eyes get knocked out of alignment, and boards lose programming after storms. We fix the root cause first, then get the electronics talking again.
Why Gatewood Fence & Gate Is Conyers’s Preferred Gate Access Control Company
Hal Gatewood started this shop in 2001, and he still answers the phone himself more often than not. His name is on the truck, the invoice, and the building, and his address is published so you can drive over and look him in the eye if you want to. That’s not a marketing line. That’s how a local business in Conyers should work.
We’ve worked on ornamental gates in neighborhoods off Flat Shoals Road, Salem Road, and throughout 30012, 30013, and 30094 long enough to know the patterns. We know which subdivisions were built with which operator brands, and we know which ones are now hitting the 20-year mark where control boards stop holding programming. Our customers in Conyers don’t call a national outfit and pray. They call someone who lives down the road.
Every job gets the 90-Day Done Right Promise in writing. If something’s not right, one call brings us back. No runaround, no fine print. That’s the whole point.
Our Gate Access Control Services in Conyers
We handle the full range of Gate Access Control work, from legacy retrofit to new install. Here’s what that looks like in Conyers specifically:
Keypad Entry
A keypad that worked fine for 15 years in a HOA entrance off Salem Road will eventually lose its programming. Sometimes it’s the membrane wearing out. Sometimes it’s an old DoorKing or Linear board that dumps its memory after a storm. We replace the keypad, the board, or both, and we test it against a freshly aligned gate so you’re not entering codes twice because the strike binds.
Phone Entry
Phone entry systems on Conyers gates take a beating from summer heat, which cooks surface-mounted enclosures on brick pillars. If your 2005 phone entry keypad stopped recognizing codes after a heavy storm, the board may be salvageable, or it may need replacing. We’ll tell you honestly which one it is, and the price is agreed before we touch anything.
Video Intercom
Video intercoms on Conyers driveways face a specific problem: dust. The red clay fines get into outdoor units, cloud lenses, and block the mic. We clean, reseal, and upgrade where it makes sense. If the gate is in a shaded oak line along a horse farm entry, we mount the unit where afternoon glare won’t blind the camera.
Card Reader
Card readers on equestrian property gates near the Georgia International Horse Park see more weather exposure than their suburban cousins. We see readers with UV-cracked housings, corroded terminal strips, and RFID modules that fail silently. We stock replacement readers and we wire them into existing operators without forcing you into a whole new access system.
We emphasize keypad entry, phone entry, and video intercom on our Conyers routes because that’s what this market demands. Older gates, legacy operators, and owners who need dependable access without ripping out the whole driveway.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Conyers
We service nine major gate brands including Linear, Viking, and DoorKing, which happen to be the names we see most often on Conyers gates from the late 1990s and early 2000s. A Viking slide operator on a horse farm off Sigman Road, a DoorKing board in a McDaniel Mill subdivision entry, a Linear actuator on an ornamental swing gate in 30094. We stock common boards, remotes, and photo-eyes for these brands locally, so we’re not telling you to wait a week while parts ship from somewhere else. If we don’t have it on the truck, we can usually get it same day through our local suppliers.
Common Gate Access Control Problems We See in Conyers Homes
- Photo-eye misalignment from clay-heaved posts. Every spring, the red clay swells and pushes gate posts out of plumb. The photo-eye still looks aligned, but it’s off by a quarter inch, and the gate reverses every time you try to close it. We reset the post or shim the photo-eye and re-sync the operator.
- Obsolete control boards losing keypad programming. Thunderstorms roll through Rockdale County all summer, and old DoorKing and Linear boards from the 1990s wipe their keypad codes. We either replace the board with a current model or reprogram and add a surge protector if the board still has life.
- Slide gate binding on tilted footings. Rack and pinion slide gates on equestrian properties need straight, stable post footings. In dry autumn weeks, the clay shrinks and the post leans. The operator keeps pulling until the motor burns out. We reset the footing, then address the operator.
- Worn phone entry wires in old conduit. Gates installed 20 years ago in Conyers often have phone entry wiring in undersized conduit that’s now cracked and full of water. The phone entry acts dead, but the problem is the wire run, not the board. We pull new wire where the conduit allows, or surface-mount a sealed run where it doesn’t.
Pricing for Gate Access Control in Conyers, GA
A replacement keypad on a Conyers gate typically runs $180 to $320 installed, depending on whether we’re matching a legacy panel or installing a new entry box. Phone entry board replacement runs $250 to $450. A new video intercom system starts around $700 and goes up depending on camera count and whether the gate is wired or you want wireless integration. Retrofitting a 1990s ornamental swing gate with modern access controls, without replacing the gate, usually falls between $500 and $1,200.
The price we quote is the price you pay. We agree on it before any work starts, and we put the 90-Day Done Right Promise in writing. Standing offers: $40 off any repair over $200, no trip charge inside Rockdale County, free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. Call (877) 610-2993 for an exact quote, free.
We Also Serve Cities Near Conyers
Our Gate Access Control in Conyers service area reaches Stonecrest, Redan, Snellville, and Stockbridge as well. If you’re just outside the city line in 30094 or a few miles east on 138, we will still come out, and we’ll still answer the phone with a real person when you call.
Serving Conyers, GA - Our Local Coverage Area
We’re based in the Conyers area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Conyers
The red clay under your gate expands when the spring rains soak it, and the post heaves sideways just enough to make the gate leaf bind against the strike post. The real repair is resetting the post deeper with proper compaction, not just grinding the latch or bending the bracket. We see this every year across Conyers, especially in 30094. Call (877) 610-2993 for an exact quote.
In most cases, yes. The gate leaf itself is usually fine, because the iron from that era is heavy and well-built. What fails is the post footing, the hinge hardware, and the operator. We reset the post, replace the bearings and hinges, and mount a current operator onto the existing gate. That’s the smart money in this market. We’ll tell you honestly when the gate itself is too far gone.
Horse farm slide gates need agricultural-grade hardware, not residential door hardware. The posts are bigger, the gate is heavier, and the operator has to pull through dust, mud, and temperature swings. We source the right component and reset the footings to handle red clay movement. If the current operator burned out because the gate was binding, just replacing the motor will get you another six months. Fix the binding first.
Any automatic gate installed or significantly modified in Rockdale County must have working safety edges and photo-eyes that meet current UL 325 standards. Older gates, especially from before 2000, often lack a monitored safety edge. We inspect and bring the gate current as part of any access control retrofit. It keeps people safe and it keeps you out of liability trouble.
Not necessarily. The storm likely took out the control board or the wiring, not the whole system. We test the board first, then the keypad itself, then the wire run. A surprising number of these failures in Conyers are just a water-filled conduit or a corroded terminal strip. One repair visit usually brings it back without a full replacement. Call us at (877) 610-2993 and we’ll walk you through what to check before we head out.
If you’re dealing with a gate access issue in Conyers, call (877) 610-2993 for a free estimate. Hal Gatewood’s name is on the truck, the invoice, and the building. We show up when we say we will, and we fix it right the first time.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Conyers and surrounding communities since 2001.