Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Crowley
Gate access control in Crowley usually means one of three things: adding a keypad or intercom to a gate the builder left manual, repairing a builder-grade operator that’s failing on a subdivision gate, or replacing an entry system that won’t read codes anymore. For homes across 76036, a properly installed and wired system typically runs $600 to $2,800 for hardware and labor, depending on what’s already there and what you’re trying to control. We show up with the right parts the first trip, and we answer the phone when you call (877) 610-2993.
Crowley sits at the southern edge of Fort Worth’s growth line, where new subdivisions off FM 1187 and Crowley Road meet older ranch lots closer to old town. That split changes everything about how gate access control gets installed and repaired here. A system on a 2022 tract home near the high school has different wiring, different failure points, and different fix requirements than a swing gate on a 1980s acreage parcel off Rendon Road. We work both. Hal Gatewood has been at this since 2001, and he’s the one whose name is on the invoice.
Why Gatewood Fence & Gate Is Crowley’s Preferred Gate Access Control Company
We’re a local, owner-operated shop, not a regional outfit that runs crews through town. That matters in Crowley because the soil here is not like the soil ten minutes north. Blackland Prairie clay expands and contracts through every wet-dry cycle, and it heaves gate posts out of plumb faster than anywhere else in Tarrant County. We know that because we dig in it. We know what a post collar looks like after the clay has pulled the conduit apart, and we know how to fix it so it doesn’t happen again in a year. That’s not something a phone rep in another state can promise you.
Every call to (877) 610-2993 gets a live person. Not a queue. Not a callback list. That’s not a gimmick, it’s how Hal has run the shop since the day it opened. If a keypad quits the morning you’re trying to get out for work, someone answers and gets it handled. We also put the 90-Day Done Right Promise in writing on every job: if it’s not right, one call brings us back. That promise has a name behind it, and the name matches the shop down the road.
The reviews from Crowley homeowners tell the same story we hear at the parts counter: they called three companies, got two voicemails and one quote that changed at the door, then called us. We quote the price first, we show up inside the window, and we fix what’s actually wrong. No trip charge inside Tarrant County. Seniors and veterans get 10% off, same as they have for years. That’s the whole model, and it works because we live here.
Our Gate Access Control Services in Crowley
Keypad Entry
Keypads on Crowley subdivision gates fail at the post collar more than anywhere else, because the clay heave pulls the low-voltage wire apart inside the PVC jacket. It looks fine from the outside and the keypad looks fine, but the wire inside is broken. We fix that by replacing the broken run with a properly sized expansion loop so the clay can move without tearing the wire again. Most keypad systems in Crowley run $300 to $900 installed, including the hardware and the wiring repair. Call for a firm price before we start, not after.
Video Intercom
A video intercom on a Crowley driveway gate makes sense when you can’t see the gate from the house, which is common on the larger lots off FM 1187 and in older sections near old town. We install and program video intercom systems for brands like LiftMaster, DoorKing, and Viking. On a newer Crowley home with an existing operator, you can usually add a smart video intercom without replacing the whole gate system, as long as the operator has an accessory input. Expect to pay $800 to $2,200 for a quality video intercom install in Crowley, depending on power and conduit conditions.
Smart Access
Smart access means opening and monitoring your gate from your phone. It works with most LiftMaster and Viking operators on Crowley homes, and it’s a good fit for the newer subdivision gates where the builder installed an operator but nothing to control it remotely. We set it up, get it paired, and show you how to use it before we leave. The job never ends with a manual and a wave.
Phone Entry
Phone entry systems let you open the gate from a call, which is useful on longer driveways where a visitor shouldn’t be waiting at the road. We install and service phone entry units from DoorKing, Elite, and Viking. On a Crowley lot with an existing gate and a power source at the post, you’re looking at $700 to $1,800 for a dependable phone entry setup. If the power run isn’t there, we’ll quote the conduit and wire separately, up front.
Remote Control
When a remote on a newer Crowley home stops working but the battery is fresh, the fault is almost always at the operator’s receiver board or at a bad splice in the low-voltage line. The clay movement pulls wires apart inside the jacket, the operator loses signal, and the remote gets blamed. We test at the operator first. Repairs on remote issues in Crowley run $150 to $500, depending on where the break is. It’s usually not the remote.
Card Reader
Card readers make sense on gates that see multiple users: family, ranch hands, delivery drivers, you name it. We install and service reader systems from DoorKing and Linear, and we match the card format to what the operator already uses. On a Crowley ranch gate or a subdivided property off Rendon Road, a card reader install typically runs $600 to $1,500. We’ll wire it clean and seal it against the clay movement that kills cheap installs.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Crowley
We’re certified to service nine major gate operator and access control brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. For Crowley specifically, we stock the parts we see fail most often in this soil: hinge post brackets, photocell wiring kits, receiver boards, and keypad cable assemblies. We don’t have to order your part from a warehouse and come back next week. If we don’t have it on the truck, we know where to get it same day. If your builder put in a DoorKing or Viking and it’s acting up, that’s what we work on. If the gate came with a contractor-grade unit we’ve never heard of, we’ll tell you honestly whether it’s worth repairing or whether you should spend the money once on something that’ll last. That’s the Gate Access Control conversation we have with Crowley homeowners all the time.
Common Gate Access Control Problems We See in Crowley Homes
- Builder-grade operators burning out on shared circuits. The subdivision contractor never ran a dedicated 120V circuit to the gate, so the operator is pulling from an overloaded garage circuit that trips under actuator load. We see it on tract homes across 76036, especially in the developments off Crowley Road.
- Keypads shorting out after rain. The clay heave separates the low-voltage conduit at the post collar, water gets in, and the keypad dies without any visible damage. Crowley’s wet-dry cycles make this a regular call, not an occasional one.
- Slide gates binding on tilted pads. Larger ranch-style lots in Crowley often have slide gates where the concrete pad has tilted with the clay swell. The rack and pinion gear mesh goes out of tolerance, the operator faults, and the gate won’t travel. The fix is pad correction, not a new operator.
- Manual gates homeowners want automated. Builders across the newer Crowley subdivisions leave many driveway gates manual. The post was never trenched for power or low-voltage wire, so adding an operator means running conduit, setting a proper footing, and installing the operator correctly. Skip one of those and you get a callback. We do all three.
On a cul-de-sac off FM 1187, we replaced a builder-grade LiftMaster LA400 swing gate operator that was straining against a hinge post heaved out of plumb in under three years. We set a new bell-bottom post footing below the active clay zone, corrected the sag at the hinge post, and wired a keypad entry with a safety photocell. Now the gate swings clean and the operator no longer faults on every cycle. That job needed post work, wiring, and hardware. We did all of it in a day.
Pricing for Gate Access Control in Crowley, TX
Gate access control pricing in Crowley is not a mystery, and it shouldn’t feel like one. A keypad install runs $300 to $900. A video intercom runs $800 to $2,200. Smart access add-on work runs $400 to $1,200 depending on the operator. A full new operator with keypad and safety edges runs $1,500 to $3,500 on a standard subdivision gate. The biggest cost drivers in 76036 are whether the builder left a usable power source at the gate, whether the post is still in plumb, and how far the conduit has to run from the house panel. We quote every job before we touch it, and the price does not change at the door. Free estimates, no trip charge in Tarrant County, $40 off any repair over $200. Call (877) 610-2993 and you’ll get the real number, not a guess.
For a broader look at what Gate Access Control in Crowley involves and how we approach the work, this is the same crew and the same standards on every job in the county.
We Also Serve Cities Near Crowley
We work all through southern Tarrant County and into the neighboring towns. If you’re in Burleson, Everman, Rendon, or Benbrook, the same local crew covers your area. The soil changes a little, but the way we work doesn’t: answer the phone, show up inside the window, fix it right, and stand behind it for 90 days in writing.
Serving Crowley, TX - Our Local Coverage Area
We’re based in the Crowley area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Crowley
In Crowley, rain after a dry spell makes the Blackland clay under your gate swell, and that movement separates the low-voltage conduit at the post collar. The wire inside the PVC jacket breaks without visible damage, and the keypad loses connection to the operator. That’s the single most common cause of keypad failure in 76036. We replace the broken run with an expansion loop so the clay can move without tearing the wire again. Call (877) 610-2993 and we’ll schedule a time to test it at the post.
Yes, in most cases you can add a smart video intercom to a builder-installed LiftMaster operator, as long as the operator has an accessory input and a reliable power source. The bigger issue on many Crowley subdivision homes is that the builder ran the operator on a shared circuit, so the intercom gets a dedicated low-voltage run when we install it. We handle the wiring, the programming, and the phone pairing on the same trip. Call (877) 610-2993 for a firm quote on your specific gate.
The remote is usually fine. The problem is a broken low-voltage wire between the operator and the receiver, caused by the clay pulling the wire apart inside the jacket at the post collar or the conduit joint. We test at the operator first, not at the remote. Repairs on remote control systems in Crowley run $150 to $500 depending on where the break is. Call (877) 610-2993 and we’ll diagnose it at the gate, not over the phone.
On a standard subdivision gate in Crowley, a photo-eye is enough for safety. A loop detector makes more sense on a longer driveway or a gate that sees a lot of vehicle traffic, like a ranch gate or a subdivided property off Rendon Road, because it holds the gate open while a car is sitting on the loop. The soil movement in 76036 can tear up improperly installed loops, so we put them in with slack and seal them like a post collar. We’ll tell you honestly which one fits your setup without upselling.
A solar gate opener on a manual Crowley gate needs three things: a properly sized operator for the gate’s weight and length, a solar panel with a battery bank that can handle North Texas heat, and a post that is still sitting straight in the clay. On many 76036 gates, the post is already leaning, so we set a bell-bottom footing first. Then we mount the operator, run the low-voltage control wire, install the keypad and photocells, and program everything. A typical solar opener install on a wrought-iron drive gate in Crowley runs $1,800 to $3,500. Call (877) 610-2993 and we’ll come measure it for free.
Contact Gatewood Fence & Gate in Crowley, TX
If your gate keypad is dead, your remote won’t open the gate, or you want to add real access control to a gate the builder left manual, call (877) 610-2993. You’ll get a live person, a straight answer, and a price that doesn’t change at the door. We work all over 76036, from the new subdivisions off FM 1187 to the older ranch lots near old town. Free estimates. $40 off any repair over $200. 90-Day Done Right Promise in writing. That’s how it works in Crowley.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Crowley since our first job there and standing behind every gate we touch.