Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Motor & Opener Across Weatherford
If you’re searching for gate motor and opener work in Weatherford, TX, here’s the straight answer: Hal Gatewood has been running Gate Motor & Opener jobs throughout Parker County since 2001, and most Weatherford calls get a truck out same-day or next-morning. We work on the heavy 16 to 20-ft welded pipe gates that ranches out here depend on, not just the ornamental driveway units common in Fort Worth. Call (877) 610-2993 and a live person answers. No voicemail, no call center three states away.
Why Gatewood Fence & Gate Is Weatherford’s Preferred Gate Motor & Opener Company
Weatherford isn’t a side market for us. We know the difference between a subdivision gate in Silverado Hills and a cattle gate out off Peaster Highway. Hal’s name is on the shop, his address is published, and his license number is there for anyone to look up. That matters to homeowners from 76085 to 76088 who have been burned by a national outfit quoting one number on the phone and charging another at the door.
We answer calls around the clock. Not a voicemail box. A person. When you call about a gate motor that died at 9pm and you’ve got horses that need to stay in, you get an answer, not a menu tree. Our standing offers don’t require haggling either: $40 off any repair over $200, free second opinion on any written estimate, no trip charge inside Parker County, and a permanent 10% discount for seniors and veterans.
Every job comes with our 90-Day Done Right Promise in writing. If it’s not done right, we make it right. One call brings Hal back, no runaround. We’ve been doing this owner-operated for over 29 years, and that promise is stamped on every invoice, not buried in fine print.
Our Gate Motor & Opener Services in Weatherford
Motor Installation
Putting a new operator on a Weatherford gate often means dealing with a span and weight that standard residential motors were never built for. A 20-ft pipe gate built for horse trailers weighs far more than the 12-ft ornamental steel gate typical in a Fort Worth subdivision. We size the operator to the gate, not the other way around. If the post is out of plumb from clay heave, installing a motor on it without fixing the post first just means you’ll be calling us again in eight months.
Motor Repair
Most gate motor failures in Weatherford don’t start inside the motor. They start at the post. Parker County’s expansive clay swells and shrinks with every wet-dry cycle, slowly pulling hinge posts off axis. The operator then has to work against a binding gate, trips its safety sensor, and eventually burns out. We repair the motor, but we also check the post alignment, gear rack, and safety edges in the same visit. That’s the difference between a fix that lasts and a fix you’ll pay for twice.
Linear Motor
Linear arm operators are common on Weatherford’s ornamental iron driveway gates, particularly in the post-2000s subdivisions around Tin Top Road and Bethel Road. These units get punished by North Texas wind and hail, which is routine in this stretch of the I-20 tornado corridor. We service and replace Linear actuators, check the mounting plate for stress cracks, and realign the arm so it isn’t fighting the gate.
Slide Motor
Slide gates are the workhorse of Weatherford ranch entrances. They handle wide openings, they’re less affected by wind, and they hold up to livestock pressure better than swing gates. But the rack and pinion on a slide gate takes abuse. Cattle lean on the gate, the rack bends, and the pinion gear chews itself up. We replace slide motors, weld broken rack sections, and re-square frames that cattle have pushed off axis. We weld on site, so your gate stays in your driveway.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Weatherford
We’re certified to service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. For Weatherford customers, that means we’re not reading a manual when we show up. On a rural property off Zion Hill Road, our crew replaced a burned-out Linear actuator on a 20-ft pipe swing gate that had been field-welded three times. We cut out the old bead welds, re-squared the racked frame, poured new post footings, and set a heavy-duty LiftMaster operator with solar power because the nearest mains were 400 ft away. We carry common parts for Viking, Ghost Controls, and DoorKing units on the truck, so there’s no week-long wait for a part to ship from a warehouse.
Common Gate Motor & Opener Problems We See in Weatherford Homes
- Clay heave pulls posts out of plumb every spring. The wet-dry cycle in Parker County’s expansive clay makes hinge posts shift, the gate binds against the operator, and the motor trips its safety sensor repeatedly. Homeowners often think the motor is failing when the real issue is the post footing.
- Cattle and horse pressure racks heavy pipe gates. Livestock lean, push, and rub against gates constantly. Over time the frame twists, the rack bends on slide gates, and the operator stalls. We see this on acreage properties in the 76087 and 76088 ZIPs far more than any suburban neighborhood.
- High wind and hail damage exposed actuators. Rural posts don’t offer the shelter that suburban columns do. Actuators mounted out in the open take direct hail hits during spring storms, and lightweight aluminum infill panels bend in high-wind events. If your operator was fine before a storm and dead after, hail damage to the control board or actuator housing is usually the culprit.
- Solar panels that can’t keep up with the motor’s draw. We see a lot of solar-powered gate openers on Weatherford acreage where running conduit to the nearest panel would mean trenching 300 feet or more. The problem is that many systems were undersized from the start. A heavy 20-ft gate needs more panel wattage and battery capacity than a standard driveway gate. We calculate the actual load before recommending a solar setup, not after.
Pricing for Gate Motor & Opener in Weatherford, TX
Here are honest numbers for the Weatherford market. A standard gate motor repair in Weatherford runs $180 to $340, assuming the operator itself is salvageable. Replacing a burned-out actuator on a ranch gate typically lands between $450 and $900 depending on the weight of the gate and whether we need to weld the frame back square. A full slide motor replacement with new rack and post footings runs $1,200 to $2,600 for the heavier 16 to 20-ft gates common out here. Solar gate opener packages with battery backup start around $1,400 and go up based on gate span and panel needs.
We quote the price before any work starts. You agree to it, we do the work, that’s the number on the invoice. No “it needed more parts” surprise at the door. Call (877) 610-2993 for a free estimate. We’ll give you a number you can hold us to.
We Also Serve Cities Near Weatherford
Our Gate Motor & Opener in Weatherford service area includes the surrounding communities of Azle, White Settlement, Eagle Mountain, and River Oaks. If you’re west of Fort Worth and your gate opener is giving you trouble, call (877) 610-2993. Scheduling is coordinated from our Dallas-Fort Worth office, and crews serve Weatherford locally.
Serving Weatherford, TX - Our Local Coverage Area
We’re based in the Weatherford area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Motor & Opener in Weatherford
Parker County’s expansive clay soil swells when it takes on water, which pushes your gate posts out of plumb. Once the post shifts, the gate leaf binds against the operator, and the motor stalls or trips its safety sensor. The fix is realigning or re-footing the post, not swapping the motor. Call (877) 610-2993 and we’ll check the post alignment before we ever open up the operator.
Yes. We install solar-powered gate operators with battery backup for exactly this situation, which is common on Weatherford acreage where the nearest electrical service might be 300 to 400 feet from the gate. We size the panel array and battery bank to the actual load of your gate, including how many cycles per day it runs and whether it’s a heavy pipe gate or a standard swing gate. A free site visit is part of the estimate.
Most big-box openers are rated for 16 feet or less, but heavy-duty operators from LiftMaster and Viking are built to handle 20-ft and longer gates when paired with proper reinforcement. We’ve installed these on horse properties all around the 76088 ZIP, including gates that have been field-welded and re-welded over decades. We’ll spec the operator, the post footings, and the frame reinforcement together so the motor isn’t fighting a gate it was never sized for. Call (877) 610-2993 for exact pricing on your gate.
Usually not. Hail and lightning in this stretch of the I-20 corridor commonly fry keypads, photoelectric sensors, and control boards without damaging the motor itself. We test the operator, the safety edges, and the battery backup before recommending anything. If the keypad is the only failure, that’s a simple replacement, not a full operator swap. Estimates are free.
It’s worth fixing. We repair gates other companies want to replace. A racked pipe gate can be re-squared, re-welded, and re-hung on new post footings for a fraction of what a new gate and operator would cost. We weld on site, so the gate never leaves your property. We’ll give you an honest assessment: if the frame is structurally sound, we fix it and stand behind it with the 90-Day Done Right Promise. If the steel is fatigue-cracked beyond safe repair, we’ll tell you that too. Call (877) 610-2993 for a free second opinion on any written estimate you’ve received.
Most Weatherford calls from the 76085, 76086, 76087, and 76088 ZIPs get a same-day or next-morning response. If your gate is stuck open and you have livestock that could get out onto Tin Top Road or Peaster Highway, tell us when you call and we’ll prioritize you. A live person answers 24/7 at (877) 610-2993.
Every job carries our 90-Day Done Right Promise in writing. If something isn’t done right, we come back and make it right. No fine print, no runaround. Hal Gatewood’s name is on every invoice.
If your gate motor is struggling, making noise, or dead altogether in Weatherford, call (877) 610-2993 today. We’ll answer, we’ll ask the right questions, and we’ll give you a straight quote before any work starts. You can drive to the shop and look Hal in the eye, or he’ll be there himself. That’s how it’s been since 2001.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Weatherford since 2001.