Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Raleigh Hills
Gate installation in Raleigh Hills runs $2,800 to $7,500 for most driveway gates, with double swing gates and solar-powered operators landing at the upper end. We quote that price before any work starts, and it’s the price you pay. Hal Gatewood has been owner-operating since 2001, and the person who shows up to measure your gate is the same person whose name is on the invoice. Call (877) 610-2993 for a free estimate in Raleigh Hills.
Why Gatewood Fence & Gate Is Raleigh Hills’s Preferred Gate Installation Company
We work in Raleigh Hills every week, and we know the difference between a gate that belongs on a Portland flat lot and one that has to survive a Washington County clay hillside. The 97225 ZIP is full of mid-century ranch homes on generously sized lots, and the gate work here follows patterns you won’t find across the river. Mature Douglas firs shade the hardware, clay soils heave the posts, and long gravel drives demand operators with real torque. We plan for all three before we dig the first hole.
Our 90-Day Done Right Promise applies to every Raleigh Hills installation, in writing. If something isn’t right, one call brings us back. No runaround, no ticket queue. We also answer the phone 24/7 with a live person, not a voicemail. Seniors and veterans get a standing 10% discount, and there’s no trip charge inside the county. Hal’s name is on the shop, and the shop is down the road. That’s the oldest accountability there is.
Our Gate Installation Services in Raleigh Hills
Raleigh Hills gates need to clear long driveways, stand square on moving ground, and keep working when the tree canopy blocks the sun. Here’s what we install most.
Driveway Gate Installation in Raleigh Hills
A typical driveway gate installation in Raleigh Hills runs $3,200 to $6,800 for a single swing gate with an operator. Wide ranch drives with a double gate and solar power run higher, usually $5,000 to $9,000. We set posts in 30-inch concrete footings below the frost line because the expansive clay in the Tualatin Hills foothills will shove a shallow post out of square within two wet seasons.
Pedestrian Gate Installation in Raleigh Hills
Pedestrian gates in Raleigh Hills cost $900 to $2,200 installed, depending on whether you’re going wood, powder-coated steel, or aluminum. Our Gate Installation team sizes the hinge posts for the load they’ll actually carry, not the load the manufacturer’s chart assumes. On a shaded lot, we spec stainless or hot-dip galvanized hardware from day one. Mild steel rusts through under the fir canopy in 18 months.
Sliding Gate Installation in Raleigh Hills
Sliding gates are the right answer when a driveway climbs steeply and a swing gate would bind against the grade. In Raleigh Hills, that’s common. A sliding gate installation runs $3,800 to $8,000, with the rack-and-pinion track bed needing deeper gravel and compaction on clay soil. If you skip that step, the track shifts and the operator faults on the safety photocell. We don’t skip it.
Swing Gate Installation in Raleigh Hills
Swing gates work well on the flatter lots in the 97225 ZIP, especially the ranch homes built from the late 1940s through the 1970s. A single swing gate with an opener runs $2,800 to $6,500; a double swing gate runs $4,500 to $9,000 because you’re buying two leaf panels, two sets of hinges, and an operator rated for both. On SW 72nd Ave near the Raleigh Hills Grade School, we replaced a mid-century ranch’s original double swing gate with a solar-powered LiftMaster operator and hot-dip galvanized hinges. The old hinge posts had heaved in the clay, and the shaded steel hardware was rusted through from the Douglas fir canopy. Our crew poured 30-inch concrete footings below the frost line and set the new posts with a sag correction bracket, so the gates close square and the loop detector reads the long gravel drive.
Double Gate Installation in Raleigh Hills
Double gates are the standard for wide ranch drives in Raleigh Hills, where the property entrance needs to pass a truck or a horse trailer without a three-point turn. A double gate installation runs $4,500 to $9,000 with one operator. If you need both leaves to open independently, that’s a second operator and a higher cost, but on a long gravel drive it’s the difference between a gate that works every morning and one that faults when the clay gets wet.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Raleigh Hills
We’re certified to service and install nine major gate brands, including FAAC, BFT, Linear, and Viking. If you already have a Viking operator on a failing post, we can often reuse the operator and build a proper footing underneath it, which saves real money. For solar-powered gates on shaded Raleigh Hills lots, we stock FAAC and Linear solar controllers and batteries locally, so a repair doesn’t wait on a warehouse three states away. We install the equipment we’d want on our own gate, and we stand behind all of it with the 90-Day Done Right Promise.
Common Gate Installation Problems We See in Raleigh Hills Homes
- Expansive clay heaves the hinge post and the rack-and-pinion track. The Tualatin Hills foothills soil swells with winter rain and shrinks in summer. A post set in a 12-inch footing will rack within two seasons and the operator will start faulting on the safety photocell. We pour 30-inch footings below the frost line as standard.
- Mild-steel hardware rusts out under the Douglas fir canopy. The thick tree cover throughout 97225 keeps gate hardware damp even in August. Bare-metal hinges and latches seize within 18 months. Stainless or hot-dip galvanized is the default on every Raleigh Hills job, not an upgrade.
- Solar gate openers get sized for full sun and then get shaded by mature big-leaf maples and firs. By November the battery is undercharged, and after a cold, rainy week the operator is dead. We size the panel and battery bank for the actual canopy on your lot, not the manufacturer’s optimistic chart.
- Mature tree roots push against gate posts and shift the gate line. The large Douglas firs and big-leaf maples on older Raleigh Hills lots send roots toward post bases over decades. We offset footings and use root-friendly gravel beds where the root zone is active, and we tell you honestly when a tree is going to keep pushing the post no matter what we do.
Pricing for Gate Installation in Raleigh Hills, OR
Gate installation pricing in Raleigh Hills reflects the terrain and the tree cover. Here’s what to expect.
- Pedestrian gate: $900 to $2,200
- Single swing driveway gate with opener: $2,800 to $6,500
- Double swing driveway gate with opener: $4,500 to $9,000
- Sliding gate with operator: $3,800 to $8,000
- Solar power system (panel, battery, controller): $800 to $2,400 added to the gate cost
- Post replacement or re-set in a new footing: $700 to $1,500 per post
Every estimate is free, and the price is quoted and agreed before any work starts. When Hal writes a number on the estimate, that’s the number on the invoice. Call (877) 610-2993 for an exact quote on your Raleigh Hills gate.
We Also Serve Cities Near Raleigh Hills
Our Gate Installation in Raleigh Hills customers often send us to neighbors and family nearby. We install and repair gates throughout West Haven, West Haven-Sylvan, West Slope, and Cedar Hills, and we know the county rules and clay soil conditions across all of them. The same owner shows up, the same 90-Day Done Right Promise applies.
Serving Raleigh Hills, OR - Our Local Coverage Area
We’re based in the Raleigh Hills area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Raleigh Hills
Yes, if the gate crosses onto the right-of-way or involves a new driveway approach. Raleigh Hills is unincorporated Washington County, so permitted gate work falls under Washington County Land Use & Transportation rules, not Portland’s Bureau of Development Services. That changes setback, sight-triangle, and permit requirements compared with nearly every adjacent Portland neighborhood. We check the county requirements on every job before we dig, and we’ll tell you plainly whether your project is permitted or exempt. Call (877) 610-2993 and we’ll walk you through what applies to your lot.
The expansive clay soils in the Tualatin Hills foothills swell with winter rains and shrink in summer, and a shallow post set in a small footing will move with every cycle. Within two wet seasons, the hinge post racks and the gate binds, and any operator attached to it starts faulting. We pour 30-inch concrete footings below the frost line on every Raleigh Hills gate installation. That depth gets below the zone that moves, and it’s the difference between a gate that closes square for a decade and one that sags within two years.
Yes, but only if it’s sized for the shade, not for full sun. A solar opener sized for an open field will be dead by November on a lot shaded by mature Douglas firs and big-leaf maples. We spec a larger panel and a bigger battery bank based on the actual canopy at your address, and we use FAAC and Linear solar controllers that handle partial-sun charging better than cheaper imported units. The solar math changes under the trees, and we do that math before we sell you anything.
The persistent damp under the Raleigh Hills tree canopy keeps bare steel wet year-round, and mild-steel hinges and latches seize with rust far sooner than manufacturers’ ratings suggest. Spec stainless steel or hot-dip galvanized hardware on every component. It’s not an upgrade; it’s the baseline for a gate that lives under Douglas firs. On a shaded lot, we won’t install anything less, because we’d be back in 18 months doing the same job twice.
For long ranch drives in Raleigh Hills where trenching line voltage costs more than the gate itself, a properly sized solar system with a deep-cycle battery and a low-draw DC operator is usually the right answer. You’ll need a panel sized for the shade on your lot and a battery that can carry the gate through a cold, rainy week. We install FAAC and Linear solar packages sized to your actual canopy, and we’ll give you a straight price on both solar and a line-voltage run so you can compare the numbers yourself. Call (877) 610-2993 for a free estimate.
Contact Gatewood Fence & Gate for Gate Installation in Raleigh Hills
If you live in Raleigh Hills and you need a gate that holds square on clay, stays rust-free under the firs, and keeps working when the sun won’t reach the panel, call us. Hal will answer or he’ll call you back within the hour. The estimate is free, the price is fixed before we start, and the 90-Day Done Right Promise is in writing. Call (877) 610-2993.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Raleigh Hills since 2001.