Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Conway
Gate installation in Conway, FL typically runs $1,800 to $6,500 depending on the gate type, post work, and whether we’re adding an opener. On a lakefront Conway lot that price climbs toward the top of the range because the soil and wind demand better footings and sturdier hardware than a standard inland driveway. Most installs take one to two days once materials arrive. Call (877) 610-2993 and we’ll give you a written number before any work starts.
We know Conway’s streets. Curvin Drive, Hargill Drive, Lake Margaret Drive, the older ranch homes off Conway Road near Hoffner. When you call us about a gate that’s sagging or an opener that won’t respond, you’re not explaining your neighborhood to a stranger. Hal Gatewood has been doing this since 2001, and the person who shows up to your driveway is the same person whose name is on the invoice.
Why Gatewood Fence & Gate Is Conway’s Preferred Gate Installation Company
We’re locally owned and owner-operated. Hal’s name is on the shop, the address is published, and the license number is there for anyone who wants to look it up. That matters in Conway, where homeowners have been burned by companies that quote one number over the phone and hand over a different invoice at the door. We quote a price, you agree to it, and that’s the price. Nothing changes when the crew arrives.
Conway homeowners call us because we answer the phone with a live person, 24 hours a day, seven days a week. Not a voicemail, not a call center three states away, not a chatbot. When a storm rolls off the Conway chain of lakes and your gate goes dead at 9 p.m., somebody picks up. That’s been true since 2001.
Every job we do in Conway carries the 90-Day Done Right Promise in writing. If it’s not done right, one call brings Hal back. No runaround, no arguing about blame. We stand behind the work because we did the work.
Our Gate Installation Services in Conway
Driveway Gate Installation
A new driveway gate in Conway starts with the post footings. That’s where most of the money goes on a lakefront lot, and it’s where cheap installs fail. We pour deeper footings than code requires when we’re near saturated ground, because a gate that’s straight today and leaning toward Lake Conway next summer isn’t an installation, it’s a problem we sold you. We handle ornamental iron, aluminum, and steel driveway gates, and we’ll match the proportions to a 1960s ranch or a newer lakefront build.
Pedestrian Gate Installation
Pedestrian gates on Conway properties usually serve a side yard or a private waterfront access point. Those lakefront walk gates sit in the worst humidity the neighborhood has to offer, so we specify stainless hinges and hardware rather than the plated steel that fails in two years. If you’re locking down boat access or keeping kids away from the shoreline, a properly hung pedestrian gate with a self-closing hinge is the difference between a gate and a decoration.
Sliding Gate Installation
Sliding gates make sense on Conway driveways that slope up from the street or where a swing gate would block the road. But a slide gate on a low-lying lot has one weakness: the track. Standing water submerges the wheels and roller hardware, and the track itself rusts before the gate does. We set slide gate tracks with drainage in mind and use track materials built for wet environments. A sliding gate in Conway should glide, not grind, even in August.
Swing Gate Installation
Swing gates dominate Conway’s older ranch neighborhoods, and they fail when the hinge post fails. We see it constantly off Lake Conway Drive: the post tilts toward the water, the gate sags, and the opener burns out trying to move a gate that doesn’t line up anymore. We fix the post before we hang the gate, because hanging a new gate on a tired post means you’ll call us again in a year. We also add wind bracing on solid infill gates so a summer squall line doesn’t turn your gate into a sail.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Conway
We install and service openers from FAAC, BFT, Linear, and Viking, among others. On a Conway job we’re more likely to recommend a FAAC or BFT hydraulic operator for a heavy steel gate on a lakefront driveway because those operators handle wind resistance better than a bargain brand. We keep common parts stocked so a repair or installation isn’t waiting on a truck from out of state. If your opener is one of the major brands, we know the wiring, the boards, and the failure points.
Common Gate Installation Problems We See in Conway Homes
- Lakefront post heave and lean. Moisture-saturated sandy soils along the Conway chain of lakes undermine concrete footers on the water side of the driveway. The post tilts, the gate sags, and the opener strains until it fails. We correct the footing before anything else.
- Lightning and surge damage to opener boards. Central Florida’s June-to-September thunderstorm season sends strikes and power surges that fry circuit boards and safety sensors. The gate may not move at all, or worse, it may move unpredictably until the entrapment sensors fail.
- Wind load on solid infill gates. A solid aluminum or steel gate catches wind like a fence panel. Without bracing and a properly sized operator, hinge posts deflect, the gate binds, and the operator’s gears strip. This is a specific, predictable Conway failure mode, not a hypothetical.
- Rot and corrosion from humidity. Year-round moisture near the lakes means wood gate frames rot fast and even aluminum develops oxidation at weld points. We specify stainless hardware and corrosion protection on every Conway install because we know what the air does here.
Pricing for Gate Installation in Conway, FL
A new driveway gate in Conway runs roughly $2,200 to $5,500 for a single swing gate with basic operator, installed. Pedestrian gates start around $1,800. Sliding gates tip the scale higher, usually $3,000 to $6,500, because the track, motor, and footings all add up. Security gates with heavier steel, mag locks, or access control push that to $4,000 and above. What moves your number? The soil under the posts is the big one, especially near Lake Conway. Deeper footings and stainless hardware cost more up front and save you a rebuild later. A solid infill gate costs more than a picket style, but it also takes more wind. We give you a written estimate before any work begins, and the number doesn’t change unless you change the scope. Call (877) 610-2993 for a free estimate, and ask about the permanent 10% discount for seniors and veterans.
We Also Serve Cities Near Conway
Beyond Conway, we run crews into Orlando proper, Azalea Park, Belle Isle, and Pine Castle. If you’re just outside the 32812 service area, call anyway and we’ll tell you straight whether we can get to you. And if you’re comparing installers, start with our Gate Installation page to see how we price and what we include.
Serving Conway, FL - Our Local Coverage Area
We’re based in the Conway area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Conway
Every automatic gate has a manual release mechanism, usually a keyed handle or a pull lever on the operator itself. On most FAAC, BFT, Linear, and Viking operators, you disengage the motor by turning the release key or pulling the handle, then push the gate open by hand. If you’re not sure where your release is or the gate won’t move even after disengaging, call us at (877) 610-2993 before forcing it, because a bound gate can throw off the rack and pinion or damage the operator. Always check that the gate is fully disengaged before pushing, and never let a child operate a gate in manual mode while the power is out.
Because the soil under the water side of your driveway is saturated, and the concrete footer is no longer sitting on stable ground. In Conway’s 32812 zip, lakefront gate posts commonly tilt toward the water side as sandy, soaked soils shift and settle. The fix is a new footing with deeper embedment and better drainage, not a cosmetic straightening. Splint a leaning post and it’ll lean again after the next storm. Replace the footing and the problem stays gone.
Yes, and we install it as a matter of course on solid gates in Conway, especially within a few blocks of the lakes where wind comes across open water without obstruction. A solid infill gate acts like a wall in a gust, and without bracing the hinge post flexes every time the wind blows, which shortens opener life and eventually cracks the weld points. We size the bracing to the gate’s height, width, and material, and we use heavier operators when the wind load demands it. Don’t let an installer skip this to shave the quote.
A swing gate with elevated post footings and stainless hardware outperforms a sliding gate on a lot that holds seasonal water. Slide gates need a track, and a track that spends the summer underwater will rust and seize no matter what you do. If you must have a sliding gate, we set the track with drainage rock and use corrosion-resistant rollers, but the honest answer is that a swing gate handles Conway’s wet low spots better. Call (877) 610-2993 and we’ll walk your lot and tell you what we’d put on our own house.
Yes. A nearby strike can fry the circuit board’s safety sensor inputs or the receiver while leaving the motor itself functional, which means your gate moves but the entrapment protection is dead. That’s a dangerous condition, because a gate that closes on a child or a pet won’t reverse. Any time lightning hits within a few blocks and your gate acts even slightly differently afterward, get the operator checked. We replace damaged boards and sensors and can add surge protection to the circuit, which is cheap insurance in Conway’s thunderstorm season.
If your gate is leaning toward the lake, your opener is stone dead after a storm, or you’re tired of a gate that never worked right, call (877) 610-2993. We’ll come to Conway, look at what you have, and tell you honestly whether it’s worth saving. Free estimate, written price, and the work stands behind the 90-Day Done Right Promise.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Conway since 2001.