Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Wichita
Gate access control in Wichita means keypads, remotes, phone entry, and card readers that hold up to wind, clay soil, and hard use. We install, repair, and reprogram the whole system, from the keypad at the curb to the operator on the gate. Most Wichita calls get a same-day or next-day visit, and a live person answers the phone around the clock. If your gate won’t open after a storm or the keypad quit reading codes, call (877) 610-2993 and tell us what it’s doing. Hal Gatewood has been fixing gates since 2001, and his name is on the shop.
Why Gatewood Fence & Gate Is Wichita’s Preferred Gate Access Control Company
We show up with a truck stocked for Wichita’s actual problems, not a van of generic parts. That matters here because the wind tears up hardware and the clay shifts posts, so a keypad that works fine in April can be out of alignment by August. We know the west-side ranch homes along Maple and Central where the original chain-link and cedar gates are sixty years old, and we know the east-side 67206 and 67208 subdivisions where ornamental iron and automated swing gates went in during the 1990s. The person who answers your call knows these neighborhoods too. Hal’s crew is background-checked and uniformed, and every job carries the 90-Day Done Right Promise in writing. If it’s not right, one call brings him back. No runaround.
Wichita customers call because they want a name they can verify, not a national outfit that quotes one price on the phone and charges another at the door. We quote the price before we start, and it doesn’t change. Free estimates. Free second opinion on any written estimate. Ten percent off for seniors and veterans, permanently. Those aren’t promo tricks; they’re standing offers because Hal likes doing right by people.
Our Gate Access Control Services in Wichita
Keypad Entry
A keypad that stops reading codes is usually one of three things in Wichita: a loose wire from temperature expansion, a moisture-sealed keypad that wasn’t sealed well enough, or a code that got wiped during a power surge. We stock keypads for most major brands and can usually get a new one programmed and tested in a single visit. For 67203 and 67204 homes with older operators, we often recommend upgrading to a weather-rated keypad, because the spring hail and summer sun are hard on plastic housings.
Remote Control
If your remote only works from ten feet away, or works sometimes and not others, the antenna or receiver is often the culprit, not the remote. We test the receiver’s range, check for interference from nearby power lines or other wireless systems, and reprogram or replace as needed. We also handle multi-button remotes for homeowners with a separate pedestrian gate and driveway gate, which is common in east Wichita’s gated subdivisions.
Video Intercom
Video intercoms in Wichita take a beating from wind-blown dust and afternoon sun on west-facing entries. We install and service video intercom systems that tie into your phone, so you can see who’s at the gate before you open it. If your existing video intercom has a dead monitor or a grainy picture, bring us in before you replace the whole thing; sometimes it’s a corroded connector or a misaligned lens. We will tell you straight if it’s worth fixing or if a newer unit is the better call.
Phone Entry
Phone entry systems let a visitor call your cell from the gate, and they’re popular on Wichita’s east side and in rural-property conversions around Park City and Andover. We install cellular and VoIP phone entry units, and we can tie them into an existing gate operator without replacing the operator itself. If your phone entry stopped dialing out, the problem is often a dead battery in the unit or a SIM card that lost its service, and we can sort that out quickly.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Wichita
We’re certified to service nine major gate brands, and we install and repair Linear, Viking, Ghost Controls, and DoorKing systems around Wichita regularly. Those are the names we see most often on existing gates, and we keep common boards, remotes, and keypads for them on the truck. That means we can usually fix the problem in one trip instead of ordering a part and coming back. If you have an older operator that’s been discontinued, we’ll still make it work if the parts exist, and we won’t push you to replace it if a repair is the honest answer. Gate Access Control is what we do, every day, not a side line.
Common Gate Access Control Problems We See in Wichita Homes
- Storm-disabled operators. Power cuts during tornado-warned storms leave gate operators dead. Homeowners who skip the manual-release procedure and force the gate open can strip the operator’s gearbox, and then a power-related repair becomes a full operator replacement.
- Wind fatigue on solid gates. Sustained Great Plains wind pushes against solid infill gates hour after hour. The hinge hardware fatigues, weld points crack, and slide gates start to grind or jump track when the actuator engages.
- Clay soil shifting posts. Wichita’s expansive clay heaves in wet springs and contracts in dry summers. A hinge post that’s moved half an inch throws the gate out of plumb, and the keypad, safety edges, and photocells all go out of alignment with it.
- Latch and strike misalignment from temperature swings. Wichita’s 60-plus-degree difference between January lows and July highs makes metal expand and contract enough to throw latch strikes out of position. A gate that latched cleanly in the cold can bind or fail to close in August.
Pricing for Gate Access Control in Wichita, KS
Keypad replacement or reprogramming in Wichita typically runs $150 to $350, depending on whether we’re swapping hardware or just fixing wiring. A new remote and receiver setup usually lands between $80 and $220. Video intercom installation starts around $600 to $1,200 for a basic single-door unit with phone integration, and phone entry systems run $450 to $900 installed. If you’re adding access control to an existing gate, the operator, keypad, and safety equipment together often come to $1,800 to $3,500. Every quote is written and agreed before any work starts, and we honor it to the cent. Call (877) 610-2993 for a free estimate. If you have a written estimate from another company, bring it in and we’ll give you a free second opinion.
We Also Serve Cities Near Wichita
We run calls out to Park City, Haysville, Derby, and Andover the same week they come in, and we know those communities well. If you’re outside the immediate city, Gate Access Control in Wichita is our hub, and we’ll come to you. Same 90-Day Done Right Promise, same upfront pricing.
Serving Wichita, KS - Our Local Coverage Area
We’re based in the Wichita area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Wichita
Pull the manual release handle on your operator, which disengages the motor so the gate swings or slides freely. The release is usually a red or yellow handle on the operator box. Do not force the gate open without pulling the release first; that’s how gearboxes get stripped, and it turns a $200 service call into a $900 operator replacement. If you can’t find the release or the gate still won’t move, call (877) 610-2993 and a live person answers, day or night. We walk you through it or send someone out.
Wichita’s expansive clay soil heaves when wet and shrinks when dry, so your gate posts actually move with the seasons. In April the ground is saturated and the posts may have lifted; by August the clay has contracted and the posts have settled or tilted in a new position. That’s enough to throw a swing gate out of plumb and make an operator stall. We reset the post footing and sleeve it so it stays put.
Yes. Sustained wind doesn’t have to bend the panel to hurt the operator. It loads the hinges and the rack gear, and the operator motor has to work against that resistance on every cycle. Over time the overload, the limit switch, or the gear teeth wear out. A panel that looks straight can still be pulling on a failing operator. That’s common on solid infill gates around Wichita’s open west side, where wind has a straight shot across the plains.
Check the keypad and photocells first, because small electronics take lightning and surge damage easily during storm season. Then check that the gate sits level in the closed position and doesn’t rub or drag. If the keypad works but the gate shudders, or the operator hums and quits, shut it down and call us. A field vignette from last spring: after a squall line snapped a hinge post on a 67206 gated subdivision, our tech reset the post footing with deeper concrete and added a steel sleeve before re-hanging the swing gate and re-aiming the safety photocell. The same storm had knocked the LiftMaster operator out of travel, so we reprogrammed limits and replaced the loop detector feed, getting the gate back on automatic in one visit.
Yes. Automatic gate operators in Kansas are required to have UL 325 compliant entrapment protection, which means monitored safety devices, either photocells, contact edges, or both, that reverse the gate if something is in the path. If your gate lacks working safety edges or a photocell, don’t run it on automatic, especially if children or pets are around. We install and test these on every automatic gate job, and we check them on every service call.
Need someone to look at your Wichita gate access system today? Call (877) 610-2993. A live person answers, we’ll schedule a window that works, and you’ll know the price before we start. Hal Gatewood’s name is on the shop and on every invoice.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Wichita gate access control since 2001.