Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Moore
Gate access control in Moore usually means one of two things: your keypad or remote stopped talking to the operator, or you want to add entry control to a gate that never had it. Either way, we can typically have a tech at your Moore home the same day you call, and most access control repairs are done in one visit. Hal Gatewood has been running Gatewood Fence & Gate since 2001, and he will tell you the same thing he tells every Moore homeowner: show us the gate acting up and we will show you where it is failing. Call (877) 610-2993 and a live person answers, 24 hours a day.
Moore is not like other Oklahoma City suburbs when it comes to gate hardware. The 2013 EF5 tornado flattened entire neighborhoods, and the bulk rebuilds that followed put in thousands of gates that are now hitting the same failure window at the same time. We know those gates. We know what was installed, what was skipped, and what fails first. That local knowledge saves you time and money.
Why Gatewood Fence & Gate Is Moore’s Preferred Gate Access Control Company
Moore homeowners call us because the person who answers the phone knows the difference between a bad remote and a bad receiver, and because the person who shows up has probably worked on a dozen gates in your subdivision already. We are not a call center and we do not dispatch a rotating cast of subcontractors. Hal Gatewood’s name is on the shop, the address is published, and the license number is there for anyone to look up. That is the oldest accountability there is.
Since 2001 we have built a reputation in Moore for fixing what other companies want to replace. A builder-grade operator with a dead control board does not always need a whole new unit. Sometimes it needs a $140 board, a new set of hinges, and an hour of welding on site. We do that work in your driveway, not in a shop across town. And every job, down to a keypad re-sync, carries the 90-Day Done Right Promise in writing. If it is not done right, we make it right.
Response Time to Moore
We schedule Moore calls from our metro office and keep crews working the Moore, Norman, and south OKC corridor daily. For access control failures, most Moore homes see a tech the same day. For a gate that will not close or a keypad that will not accept a code, that is a security issue, not just an inconvenience. We treat it that way.
There is no trip charge inside the county, and the price is quoted and agreed before any work starts. $40 off any repair over $200. A free second opinion on any written estimate. A permanent 10% discount for seniors and veterans. We do not haggle. Those offers stand.
Our Gate Access Control Services in Moore
This is the part where a lot of gate companies start talking in generalities. We would rather tell you exactly what we do on Moore gates, the way Hal would if you caught him at the hardware store. Here are the four access control jobs we handle most in Moore.
Keypad Entry
A keypad should not quit after a hard rain, but in Moore’s post-2013 rebuilt subdivisions, that is one of the most common calls we get. The outdoor-rated keypads installed during the rebuild wave were often wired through exposed Romex or non-code outdoor splices, because the conduit runs were rarely laid during the rushed construction. When a Moore thunderstorm blows through, water gets in, the keypad shorts, and suddenly nobody can get in the gate. We open the keypad, trace the power run, cut out the bad splice, and re-wire it properly. If the keypad itself is dead, we stock replacements for LiftMaster, FAAC, BFT, and Linear, so you are not waiting a week for a part.
Typical keypad replacement in Moore runs $180 to $340 including the new unit and install. A repair to the wiring or the board is usually less.
Remote Control
A lot of Moore gates went in manual because the post-2013 homeowners were already stretched thin after the rebuild and remote access was cut from the scope. Adding remote control to an existing swing gate is a job we do constantly in Moore. It means mounting an operator, running power, setting travel limits, and syncing your remotes and a keypad if you want one. On the new subdivision gates south of SE 34th Street, we also have to account for the clay soil, which we will get to below. The short version: we set the operator and the post so the gate actually stays where we put it.
Adding remote control to a manual gate in Moore typically runs $850 to $1,400 depending on operator size and power run distance. That includes remotes, operator, and mounting hardware.
Phone Entry
Phone entry systems let a visitor call your cell phone or a base station from the gate, and you press a key to let them in. In Moore, this is popular for homeowners with long driveways and for small ranches and acreages on the south edge of town. The wiring matters more than the hardware here, and the hardware matters a lot. We install and service phone entry systems from Viking and Linear, which hold up better in Oklahoma weather than the no-name units some online retailers push.
A basic single-family phone entry setup in Moore starts around $550 and runs to $1,000 for a system with multiple tenants or gate operators.
Card Reader
Card readers are more common on commercial and multi-property gates in Moore, but we see them on residential estate gates around the east side of town too. A card reader that stops reading is usually a wiring issue or a reader head that has taken one too many Oklahoma heat cycles. We service card readers from all the major brands and can tie them into the same operator as your remote and keypad, so one system runs everything.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Moore
We are certified to service nine major gate brands, and on Moore gates we work on LiftMaster, FAAC, BFT, Linear, and Viking the most. The advantage of working with one local company for years is that we stock parts for the specific operators that the Moore rebuild contractors put in. When your LiftMaster receiver dies, we probably have the replacement board on the truck. We do not have to order it from a warehouse and make you wait. FAAC and BFT hydraulic operators are also common on the heavier custom gates we see on Moore’s east side, and we carry their swing and slide consumables.
Because access control is only as good as the gate it is bolted to, we also weld on site. A bent hinge post off Eastern Avenue does not get hauled away. It gets a new footing, a plumb set, and a proper weld so the keypad and remote you paid for actually work against a straight gate.
Common Gate Access Control Problems We See in Moore Homes
- Builder-grade operators dying block-by-block. The 2013-2015 rebuilds in Moore used a lot of the same lightweight operators, stamped hinges, and undersized control boards. Those parts are now failing within weeks of each other across entire subdivisions. If three gates on your street have died this year, yours is probably next. We stock the exact parts those builds used, so we can often fix the gate the same day instead of ordering from a supplier that does not know Moore from Tulsa.
- Clay soil knocking safety photocells out of alignment. Moore sits on the same shrink-swell clay that runs under the whole Oklahoma City metro. Wet springs and dry Augusts heave and settle the soil constantly, shifting gate posts out of plumb. The gate binds, the safety photocell beam drifts, and the operator refuses to close because it thinks something is in the way. We re-set the post, re-plumb the photocell, and the gate closes like it should.
- Exposed Romex and non-code outdoor splices on keypads and receivers. The rushed post-tornado rebuilds often skipped the conduit runs that access control power should have gone through. Homeowners open the keypad cover and find indoor Romex wrapped in electrical tape. That shorts out in Moore storms, and sometimes it is a fire risk. We pull the bad run and install proper outdoor wiring in conduit, done to code and done once.
- Frames out of plumb from straight-line wind, making the access control work against a broken gate. The April and May wind season does not just knock gates off hinges. It slowly racks the frame and loosens the post. Then the operator is working harder and harder, burning out boards and stripping gears. We fix the frame first, then re-set the operator limits. Fix the panel without the post and you will fix it twice.
Pricing for Gate Access Control in Moore, OK
Here is what Moore homeowners should expect to pay. These are our ranges, quoted up front and agreed before we turn a wrench.
- Keypad replacement or wiring repair: $180 to $340
- Adding remote control to a manual gate: $850 to $1,400
- Receiver or remote re-sync and programming: $120 to $190
- Safety photocell realignment (including post re-plumb): $150 to $280
- Phone entry system for a single-family gate: $550 to $1,000
- Full new gate access control installation with operator: $1,600 to $3,200
Every quote is firm before work begins. We do not come back with a bigger invoice because the job got complicated. If we find something major mid-repair, we stop, explain it, and get your okay before we spend another dollar. That is how Hal has run this shop since 2001, and it is the reason Moore customers keep calling. And remember: $40 off any repair over $200, and a permanent 10% discount for seniors and veterans. Call (877) 610-2993 for your exact quote. Estimates are free.
About Gate Access Control in Moore
Moore sits at the epicenter of Oklahoma’s tornado corridor. The 1999 F5, the 2003 storm, and the 2013 EF5 all cut directly through this city, and the rebuild after 2013 produced something no other city its size in the country has: thousands of nearly identical wood and vinyl privacy fences with matching swing gates, installed in bulk by the same two or three post-disaster contractors across entire subdivisions. Those gates are now 10 to 12 years old. The hardware is hitting peak failure at the same time. That is the Moore-specific pattern, and it is why our Gate Access Control team keeps the specific LiftMaster receivers, keypads, and hinge post brackets those rebuilds used on the truck at all times. We know what a 2014 Moore subdivision gate looks like because we have worked on hundreds of them.
Here is one example. After the April windstorm bent the hinge post on a 2014-era vinyl swing gate in a Moore subdivision off Eastern Avenue, our crew found the builder-grade LiftMaster remote was still cycling but the frame was out of plumb. We reset the post with a new concrete footing, replaced the stripped rack and pinion, and re-synced the keypad entry so the homeowner did not have to fight the sag every time the wind blew. That is a Moore gate. A generic gate tech from across the metro might have swapped the operator and called it done. It would have failed again in six months.
The shrink-swell clay under Moore makes this worse. The soil expands when it rains and contracts when it dries, and over a year that movement can shove a gate post out of plumb by an inch or more. The gate binds, the operator strains, the safety photocell drifts, and the whole system stops working. You can fix the electronics, but the clay will just pull it out again unless you fix the post too. We have been doing that work in Moore long enough that we know the soil, we know the subdivision patterns, and we know which corners of which neighborhoods settle worst.
Moore zip code 73160 covers the whole city, and we work it daily. We know the older ranch homes north of Main Street, the big rebuild subdivisions south of SE 34th, and the newer builds pushing toward the Southmoore area. We know that gates in the 2013-2015 rebuild zone tend to fail together. We know that the homes off Eastern Avenue took wind damage differently than the ones off Santa Fe. None of that is trivia. It is how we stock parts and how we fix your gate the first time.
We Also Serve Cities Near Moore
If you are in Gate Access Control in Moore is our home territory, but we also run calls to Del City, Norman, Midwest City, and Newcastle every week. The same crew, the same trucks, the same 90-Day Done Right Promise. If your gate is acting up and you are anywhere in the south OKC metro, call (877) 610-2993. If it is an emergency, we will get there.
Serving Moore, OK - Our Local Coverage Area
We’re based in the Moore area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Moore
Because the power runs to those keypads were rarely laid in conduit during the rushed rebuilds, and the exposed Romex or outdoor splices short out when Moore storms push water into the housing. The fix is pulling the bad run and installing proper outdoor-rated wiring in conduit, plus replacing the keypad if the board is fried. Call (877) 610-2993 and we will quote it before we start.
Yes. We do this constantly in Moore, especially on the 2013-2015 rebuild swing gates where remote access was cut from the scope. We mount an operator, run power, set travel limits, and sync remotes and a keypad if you want one. A typical manual-to-remote conversion in Moore runs $850 to $1,400. The quote is free and it is the price you pay, period.
Almost certainly, yes. The shrink-swell clay under Moore heaves and settles through wet and dry cycles, shifting the gate post and knocking the photocell beam out of line. The operator then refuses to close because it reads a phantom obstruction. We re-set the post and re-plumb the photocell so it stops happening. Expect $150 to $280 for that job in Moore. Call (877) 610-2993 and we will come look.
Because the post-2013 rebuilds installed nearly identical builder-grade gates across entire subdivisions, and those components are wearing out on the same 10-to-12-year schedule. The stamped hinges, undersized control boards, and budget receivers all fail within weeks of each other. If the gates around you are dying, yours is not far behind. We stock the exact parts those builds used, so we can often fix yours the day you call.
Remote control is enough for most Moore homeowners, but a loop detector is worth considering if you pull a trailer or have a long driveway where you want the gate to open automatically as you approach. Loop detectors sense the vehicle and trigger the gate without pressing anything. They are more involved to install, typically adding $300 to $600 to the job, but they are the right call for a lot of Moore acreage gates. Call (877) 610-2993 and Hal will tell you straight if you need one or not.
Get Your Moore Gate Access Control Fixed Today
The gate that will not open or close on command is a security problem, and in Moore it is a problem we fix fast. Call (877) 610-2993 and a live person answers, day or night. No voicemail, no queue, no runaround. We will give you a straight price over the phone, schedule a time that works, and show up with the truck stocked for Moore’s specific gate problems. Free estimates, written quotes, and the 90-Day Done Right Promise on every job. If it is not done right, we come back and make it right. That is the deal.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Moore since 2001.