Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Haltom City
Gate access control in Haltom City means keeping a keypad, card reader, or phone entry system working through dust from the salvage yards, clay soil that won’t sit still, and daily cycles that wear out cheap parts fast. Most homeowners and business owners in the 76117 zip code call us when a gate quits reading a remote, a strike binds from a shifted post, or a loop detector gives up entirely. We have been fixing gates since 2001, and we answer the phone live around the clock. Call (877) 610-2993 and you will talk to a real person who knows Haltom City gates.
Why Gatewood Fence & Gate Is Haltom City’s Preferred Gate Access Control Company
Hal Gatewood started this company in 2001, and his name is still on the shop and on every invoice. That matters in Haltom City, where a lot of gate work sits along Belknap Street and the Airport Freeway, and the person who fixes your sliding gate today is the same one you will see at the hardware store next week. We do not hide behind a call center or a dispatch queue. When you call, you get us.
Haltom City has a particular mix of residential and commercial gate work. The side streets off Denton Highway hold modest 1950s and 1960s brick homes with chain-link perimeter fences, while the I-820/Belknap corridor is packed with auto salvage yards, used car lots, and fleet yards that run sliding gates dozens of times a day. We service both. Our Gate Access Control in Haltom City work leans toward the commercial side far more than in neighboring North Richland Hills, which means our trucks carry the heavy-duty parts those gates need.
Every job carries the 90-Day Done Right Promise in writing. If something is not right, one call brings Hal back. No fine print, no runaround. We also honor a free second opinion on any written estimate, no trip charge inside the county, $40 off any repair over $200, and a permanent 10% discount for seniors and veterans.
Our Gate Access Control Services in Haltom City
Keypad Entry
Keypad entry is the workhorse of Haltom City gate access, especially on the commercial lots near I-820 and Belknap. We install and service weather-sealed keypads rated for the dust and grit that blow off the salvage yards. A typical keypad replacement in Haltom City runs $220 to $480 installed, and we stock units from DoorKing and Linear so repairs usually happen the same visit.
Remote Control
When a remote stops opening a gate, the problem is rarely the remote itself. In Haltom City, we see receiver boards fail from heat and dust inside the operator housing, and antenna damage from hailstorms. We test the receiver, reprogram remotes on site, and replace only what actually failed. A new receiver board for a gate in the 76117 area typically runs $180 to $350, parts and labor included.
Phone Entry
Phone entry systems work well for Haltom City used car lots and fleet yards where delivery trucks and employee cars come and go at different hours. We install systems that call your cell phone or a landline and let you buzz the gate open remotely. Installed pricing for a phone entry system in Haltom City starts around $650 and runs up to $1,400 depending on how many phone lines and gate operator connections you need.
Card Reader
Card readers suit Haltom City businesses that want to log who comes and goes, or that need to revoke access quickly when an employee leaves. We install proximity card readers that pair with FAAC, BFT, Viking, or Linear operators. A single card reader install on a Haltom City gate generally costs $400 to $900, including the reader, wiring, and programming.
We also handle video intercom systems for Haltom City homeowners who want to see who is at the driveway gate before opening it. Ask us about smart access options that let you control the gate from your phone, even if you are sitting in traffic on 820.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Haltom City
We are certified to service nine major gate brands, and around Haltom City the ones we touch most are Linear, Viking, and DoorKing. We keep common boards, limit switches, and radio receivers for those brands on the truck, which saves you a second trip. If your gate runs a Ghost Controls or BFT operator, we service those too. The point is we do not have to order parts and make you wait two weeks. Hal fixes gates in your driveway or at your lot, not back at a shop across town.
Common Gate Access Control Problems We See in Haltom City Homes
- Dust and metal shavings killing keypads. Keypads near the salvage yards and machine shops along Belknap clog with fine grit that shorts the contacts. We clean and reseal them, and when they are too far gone, we replace them with sealed commercial-rated units.
- Loop detectors burning out from constant truck traffic. High-traffic lots on the I-820 corridor run loop detectors through thousands of truck crossings a month. The wire fatigues, the detector fails, and the gate sticks open. We test the loop, splice in new wire, and rebuild the saw cut so the repair lasts.
- Clay soil heaving gate posts out of alignment. Haltom City sits on Blackland Prairie clay that swells in wet springs and shrinks in dry summers. The post holding your gate shifts, the latch no longer lines up, and the access control strike binds. We reset posts in concrete and realign the gate so the electronics work without strain.
- Hail damage to receivers and antennas. North Texas hail dents panels and cracks antenna housings, which weakens remote range. We replace damaged antennas and remount receivers where they are shielded from the worst of it.
The Haltom City Gate Access Reality: This Is Not North Richland Hills
Haltom City’s dense concentration of auto salvage yards, used car lots, fleet yards, and light industrial businesses along the Airport Freeway (I-820) and Belknap Street corridors creates an unusually high demand for heavy-duty commercial sliding chain-link gate repair. Gate technicians here service far more high-cycle, high-load commercial operators than the DFW average, and more than nearly any residential suburb nearby. The salvage yards and used-car wholesale lots clustered near the I-820/Belknap interchange run their sliding gates dozens of cycles a day. Worn v-groove wheels and debris-clogged tracks are the single most common commercial gate call across all of Haltom City, and the technicians who stock those specific parts for heavy chain-link sliders stay booked solid. We stock them.
We replaced a Viking slide gate operator on a Belknap Street salvage yard where the old loop detector had failed from constant truck traffic, keeping the gate stuck open. Our tech installed a new Viking operator, adjusted the safety photocell, and set the keypad entry for staff so deliveries and employee cars kept moving without a single full closure. That job took one morning. The gate never stopped mid-cycle after that.
On the residential side, Haltom City is mostly 1950s to 1970s brick homes on small lots with aging chain-link perimeter fencing. Original steel posts are rusting at the base and shifting with ground heave, which means latch misalignment is the most common residential gate access failure we see. A gate that will not latch is a gate that cannot hold a strike, which means your keypad or remote cannot do its job. Fix the post first, then the electronics. That order saves you money and a repeat visit.
Pricing for Gate Access Control in Haltom City, TX
Here is what gate access control work runs in Haltom City. Keypad replacement ranges from $220 to $480. Remote receiver boards run $180 to $350. A phone entry system install starts around $650 and can reach $1,400 for multi-user commercial lots. Card reader installation costs $400 to $900. Full sliding gate operator replacement for a commercial lot on the Belknap corridor usually lands between $1,800 and $3,200 depending on gate weight and operator capacity.
The things that move the price are gate weight, whether we are repairing or replacing, and how much wiring has to be run. Every quote is agreed before any work starts. You will know the number before we touch a tool, and the price you agree to is the price you pay. We do not show up and hand you a bigger invoice. Call (877) 610-2993 for a free estimate on any gate access control job in Haltom City.
We Also Serve Cities Near Haltom City
Our gate access control crew covers Haltom City and the surrounding Tarrant County communities, including Richland Hills, Watauga, North Richland Hills, and Saginaw. If you are just down the road and your gate is acting up, call the same number. Learn more about our full Gate Access Control service area or call us directly for Haltom City work.
Serving Haltom City, TX - Our Local Coverage Area
We’re based in the Haltom City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Haltom City
Because Haltom City’s Blackland Prairie clay holds water against the keypad housing, and older keypads are not sealed against that kind of prolonged moisture. The rain itself does not kill the keypad; the slow seep around the mounting plate does. We replace the gasket, seal the back, and when the keypad has already corroded, we install a weatherproof unit rated for direct exposure. Call (877) 610-2993 and we will come take a look.
Yes. We wire the phone entry system in parallel with the existing keypad or card reader so the gate never has to stay open while we work. We have done this on lots up and down Belknap Street and the I-820 frontage road where closing the gate even for an hour is not an option. Most installs take half a day, and the gate keeps running the entire time.
Probably not. In Haltom City, a sliding gate that stops mid-cycle is usually a worn v-groove wheel, a debris-clogged track, or a failed loop detector sending false signals to the operator. The motor is often fine and does not need replacing. We inspect the track, wheels, and sensors before recommending anything, and we stock those heavy-duty slider parts locally so the repair happens in one trip.
A swing gate needs room to arc open, which is tough on the small lots and shared driveways found throughout older Haltom City neighborhoods near Denton Highway. A slide gate runs on a track parallel to the fence line, so it uses almost no driveway space. For tight Haltom City lots, a slide gate with a keypad or remote is usually the better fit, and we will tell you honestly which one works before you commit.
Yes. Automatic gates anywhere, including Haltom City, must meet UL 325 standards, which require entrapment protection devices such as safety photocells, reversing edges, or contact sensors. The exact requirement depends on the gate type and operator class. We install the right entrapment protection on every automatic gate we touch in Haltom City, and we will explain what your gate needs and why. Call (877) 610-2993 for a free estimate.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Haltom City and Tarrant County since 2001.