Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Bartlett
Gate access control in Bartlett, TN is overdue on most homes. Here’s the straight answer: the keypad and intercom hardware on gates installed here between 1972 and 1998 is now 25 to 45 years old. It’s failing in a synchronized wave across the city’s brick ranch subdivisions. We fix it, we replace it, and we do it with parts that match the era of your house’s original build. Hal Gatewood has been at this since 2001, and his crew knows exactly what Bartlett’s older ornamental iron gates need. Call (877) 610-2993 and a live person answers. Always.
Why Gatewood Fence & Gate Is Bartlett’s Preferred Gate Access Control Company
We’re not a national company with a rotating door of technicians. Gate Access Control in Bartlett is work we’ve done for decades, and we’ve seen the same gates on the same streets since before some of those subdivisions had sidewalks. Our published address is on the shop, Hal’s name is on every invoice, and the person who shows up is someone you’ll run into at the hardware store on Stage Road. Bartlett customers have trusted us with their gates because we don’t replace what we can repair, and when we do replace a part, we tell you why before we touch it.
Our crew covers Bartlett neighborhoods from the older sections near the railroad tracks over to the newer builds near Ellendale. We know the soil here. We know what rust in this humidity does to a 1980s hinge post. And we show up when we say we will. No trip charge inside the county, no call center. You call, Hal or someone from his crew answers, and you get a straight answer about what’s actually wrong.
Our Gate Access Control Services in Bartlett
Bartlett’s gate systems need specific kinds of attention. Here’s what we actually do on a daily basis across ZIP code 38134.
Keypad Entry
Most Bartlett subdivision gates use keypads that were installed when the house was built. That means a lot of weather-beaten plastic housings with corroded contacts by now. We repair keypads when the board is still good, and we replace them with sealed, weather-rated units when the Shelby County humidity has done its work. A keypad that quits on a rainy Tuesday isn’t a mystery. It’s usually water intrusion through a cracked housing. We fix the root cause, not just the symptom.
Remote Control
If your gate remote works only when you’re two feet from the antenna and pointed at the receiver, that’s almost always a receiver or antenna problem, not a weak battery. On Bartlett properties with long driveways, we tune receivers and add external antennas so the gate opens before you’re sitting at the end of the drive waiting for it to decide. We service remotes for LiftMaster, FAAC, BFT, Linear, Ghost Controls, DoorKing, Elite, and Mighty Mule. Whatever your system, we have the memory to match it.
Phone Entry
Phone entry systems are common on Bartlett gates where the driveway is long enough that walking to the gate is a serious chore. We install and repair cellular and landline-based phone entry systems. The older ones tied to a hardwired phone line are dying fast now, and we’ve been swapping them for cellular units that don’t care about the condition of the copper outside your house. That’s one of the most common upgrades we do on Gate Access Control in this area.
Card Reader
Card readers on Bartlett gates are often leftover from a previous owner’s commercial use or an HOA requirement. We install proximity card readers, maintain existing ones, and replace worn-out card slots and readers that have quit reading. If the card reader still works but the gate is slow to respond, the issue is often the loop detector or the operator’s control board, not the reader. We test the whole system before we start swapping parts.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Bartlett
We service every major gate access control brand, including Viking, Ghost Controls, and DoorKing. For Bartlett customers, we stock common parts locally so we aren’t waiting on a truck from some warehouse three states away. That means a burned-out control board on a Viking swing gate can be replaced same day if the part is on our truck. If it’s not, we tell you that before we start, not after. No surprises on the invoice, no surprises on the timeline.
Common Gate Access Control Problems We See in Bartlett Homes
- Rust-pitted hinge posts snapping in summer humidity. Bartlett’s humid summers get inside the ornamental iron on these gates and eat the hinge posts from the inside out. When the post fails, the gate suddenly sags and the operator strains or jams. The gate didn’t fail in the middle. The post failed first.
- Clay soil heaving posts out of plumb. Shelby County’s expansive clay swells in wet winters and shrinks in dry summers. Gate posts set in the 1980s without deep concrete footings shift with the soil, pulling rack and pinion systems out of alignment. That’s why a slide gate suddenly binds mid-travel after years of smooth operation.
- January ice storm damage to gate arms and safety photocells. Ice-laden branches come down on gate arms and operators during Bartlett’s winter storms. Photocells get sheared off, control boards short. We see this every January and February. It’s a seasonal spike we plan for, and so should you.
- Loop detectors failing to sense vehicles. On long Bartlett driveways, a failed loop detector means the gate doesn’t know a car is there. We recently replaced a 1987 DoorKing slide gate operator near Stage Road that had burned out after its loop detector failed to sense a pickup truck. The operator ran itself to death trying to open on command. We set both hinge posts in deeper concrete footings because the clay had heaved them out of plumb, and we upgraded the old keypad to a smart video intercom so the homeowner could open the gate from a phone. No more walking down that long driveway in January ice.
Pricing for Gate Access Control in Bartlett, TN
Here’s what Bartlett homeowners should expect to pay for common access control work. A keypad replacement in Bartlett runs $350 to $800, depending on whether we’re matching an existing panel or upgrading to a smart video intercom. Remote control repair and receiver replacement runs $150 to $400. Phone entry with cellular conversion runs $700 to $1,400. Card reader installation runs $500 to $1,000 per reader. A full operator replacement for a slide or swing gate runs $2,500 to $6,000, including the control board, safety edges, and post repair if the soil has shifted things. Every quote is given in writing before any work starts. The price we quote is the price you pay. Call (877) 610-2993 and we’ll give you a real number.
We Also Serve Cities Near Bartlett
We work throughout Shelby County and the Memphis metro, and Bartlett is home base for our gate access control work. We also serve Germantown, Lakeland, Memphis, and Millington. If you’re between those places, call anyway. We’ll tell you if we can get there.
Serving Bartlett, TN - Our Local Coverage Area
We’re based in the Bartlett area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Bartlett
Because Bartlett’s humid summers rust the hinge post from the inside, and Shelby County’s clay soil heaves the post out of plumb. The post is the weak point. The gate panel itself is usually fine. We fix the post, not the panel. Fixing the panel without the post means you’ll fix it twice.
Yes, a solar gate opener can handle a wide gate if it’s sized correctly and the panel gets real sun. On Bartlett properties with open, south-facing driveway entrances, solar works well. If the gate is shaded by mature oaks or the driveway is long enough that the panel sits far from the operator, we recommend AC power or a hybrid setup. We’ll tell you which works for your specific entrance, not the one that’s profitable to sell you. Call (877) 610-2993 and we’ll come look.
It’s usually water intrusion in the keypad housing, not soil or wiring. Bartlett’s heavy rain finds cracked seals and corroded contacts. We replace the housing with a sealed unit and put dielectric grease on the connections. If the issue is underground wiring on a long driveway, we test the line before digging anything. Either way, we fix it right the first time.
The operator is running but the gate won’t move because the ice storm likely sheared off a safety photocell or shorted the control board. The operator thinks it’s working. It’s not. We see this every winter in Bartlett. We test the safety edges and photocells, then replace what the ice took out. The operator itself may be fine.
No. If it still works and the safety edges and photocells are functional, keep it. But a 30-year-old operator on a Bartlett gate is running on borrowed time, and sourcing parts for a machine that old gets harder every year. We’ll tell you honestly if repair makes sense or if replacement is cheaper in the long run. We don’t replace what works. We also don’t let you spend $400 on a part for a machine that will need another $400 part in six months. Call (877) 610-2993 for an honest assessment.
If you live in Bartlett and your gate access control is starting to act up, call us. We’ll answer the phone, we’ll come look, and we’ll tell you what it costs before any work starts. Free estimates, no trip charge inside the county, and the 90-Day Done Right Promise in writing on every job. Call (877) 610-2993 today.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Bartlett since 2001.