Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Tucker
Gate access control installation or repair in Tucker usually runs between $450 and $2,800 depending on whether you’re adding a keypad to an existing opener or building out a full smart access system with video intercom and phone entry. Most jobs we handle in Tucker are done in a single visit, and we stock common keypad, receiver, and control board parts so you’re not waiting on a shipped component. If your gate won’t open, call us at (877) 610-2993. A live person answers, day or night.
We know Tucker’s older neighborhoods better than most, because we’re out here every week. The brick-pillar driveway gates on Fellowship Road, the long ranch driveways off Hugh Howell, the split-levels over near Livsey Elementary. This isn’t a stop on a route for us. It’s home turf.
Why Gatewood Fence & Gate Is Tucker’s Preferred Gate Access Control Company
Hal Gatewood started this shop in 2001, and his name is still on the door and on every invoice. We’re locally owned and owner-operated, with a published address and license number anyone can look up. When someone in Tucker calls about a gate that won’t respond to a keypad or a remote, the person who answers is sitting in our office, not a call center three states away.
The work comes with our 90-Day Done Right Promise, stamped in writing on every job. If it’s not done right, one call brings Hal back. No runaround. No “technician will return your call within 48 hours.” We also offer $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% discount for seniors and veterans. Those aren’t haggling points. They’re standing offers.
We service Gate Access Control systems across nine major brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. If you bought it, we’ve probably worked on it.
Our Gate Access Control Services in Tucker
Keypad Entry
A hardwired keypad entry system in Tucker typically runs $450 to $900 installed, and it’s the most common access point we retrofit onto existing openers. Tucker’s spring storm season is rough on keypads. Rain driven against brick pillars works into older housings, and the humidity corrodes the contacts inside until codes stop registering. We replace them with sealed units rated for outdoor exposure and wire them directly into your opener’s control board.
Remote Control
Adding or reprogramming remote controls for a Tucker gate usually costs $150 to $400 depending on how many transmitters you need and whether we’re swapping the receiver too. If your remote works from the driveway but not from the street, that’s often an antenna or receiver-range issue, not the remote itself. We diagnose that before selling you anything.
Phone Entry
Phone entry systems let a visitor call your phone from the gate keypad, and you press a button to open it. In Tucker, these are popular on properties where the gate is far from the house and you can’t hear a doorbell. Expect to pay $700 to $1,600 for a phone entry retrofit, depending on whether you want a cellular unit or can tie into a landline.
Card Reader
Card reader access control shows up on a lot of Tucker properties with multiple vehicles or visiting service people. A standalone card reader system with a dozen cards runs $600 to $1,300 installed. If you need it integrated with an existing LiftMaster or FAAC control board, that’s a straightforward wiring job for our crew.
Smart Access
Smart access means controlling the gate from your phone, usually through an app tied to a Wi-Fi or cellular module on the opener. In Tucker, Wi-Fi reach is a real limitation on long driveways. We install cellular-based smart modules where the gate is too far from the house router, so the gate opens from your phone whether you’re in the kitchen or in Buckhead. Smart access retrofits typically run $500 to $1,400.
Solar Gate Opener
For long Tucker driveways where running conduit to the gate means trenching through red clay and tree roots, a solar gate opener is often the practical answer. But Tucker’s mature hardwood canopy throws shade on a lot of panels, and a shaded panel never charges a battery fully. We size panels and batteries for your actual sun exposure, not the manufacturer’s ideal conditions. Solar opener installations in Tucker run $1,100 to $2,800 depending on gate weight and panel placement.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Tucker
We’re certified to service FAAC, BFT, Linear, and Viking equipment, among others. If your Tucker gate runs on one of these, we likely have the receiver, control board, or keypad on the shelf or can get it same-day from our local suppliers. That means fewer return trips and less downtime on a gate that’s also your security perimeter.
Common Gate Access Control Problems We See in Tucker Homes
Here’s what actually fails on Tucker gate access systems, in our experience:
- Post heave wrecks the strike alignment. Tucker’s red clay expands and contracts through wet and dry seasons, and over 40 years that moves a brick pillar two or three inches out of plumb. The keypad still works, but the latch no longer lines up with the strike. Fixing the electronics without fixing the post means you’ll be calling us again next spring.
- Water intrusion kills keypads after storms. Tucker gets roughly 50 inches of rain a year, and spring thunderstorms drive water into older keypad housings. Corroded contacts mean codes fail intermittently. A sealed outdoor-rated keypad fixes it for good.
- Shaded solar panels never fully charge. Mature oaks and pines in Tucker neighborhoods like Smoke Rise and Mountain Park throw shade across gate panels for much of the day. The battery limps along at partial charge and the gate fails on overcast weeks.
- Wide swing gates sag onto the latch side. Heavy wood or tube gates on shallow red clay footings pull hinge posts inward over time. The gate sags, the keypad strike misses, and the operator strains against a geometry problem it was never designed to fight.
Pricing for Gate Access Control in Tucker, GA
A basic keypad retrofit on an existing opener in Tucker runs $450 to $900. A full smart access system with phone control and video intercom typically lands between $1,200 and $2,800. Solar openers for long driveways run $1,100 to $2,800 depending on gate size and panel exposure. Card readers run $600 to $1,300 with cards included. Remote control replacement is the least expensive job we do, usually $150 to $400.
What moves the price in Tucker specifically is post condition. If your brick pillar has drifted and we need to excavate, pour a deep footing, and remount the hinges before touching the electronics, that’s real labor and it’s quoted up front, in writing, before we start. You’ll always know the price before we pick up a tool.
Call (877) 610-2993 for a free estimate. No trip charge inside the county.
We Also Serve Cities Near Tucker
Our Tucker crew also covers Clarkston, Mountain Park, Stone Mountain, and Chamblee. Same people, same trucks, same 90-Day Done Right Promise. If you’re in one of those areas and your gate access system is acting up, call the same number: (877) 610-2993.
Serving Tucker, GA - Our Local Coverage Area
We’re based in the Tucker area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Tucker
Spring thunderstorms in Tucker drive wind-blown rain into older keypad housings, and the high humidity that follows corrodes the internal contacts until codes register intermittently or not at all. The fix is usually a sealed, outdoor-rated keypad wired directly to the control board. We install these regularly in the 30084 and 30085 zip codes. Call (877) 610-2993 and we’ll have it working the same visit.
Yes, but only if the panel and battery are sized for the gate’s weight and the actual sun exposure on your property. A 16-foot steel tube gate needs a heavy-duty operator, and if the panel sits under mature oaks, the battery will never charge fully. We calculate sun hours on your specific site before recommending anything, and the price is agreed before work starts.
If the keypad and remote both work, the operator runs, but the gate won’t latch or binds midway through its travel, the usual culprit in Tucker is post movement in red clay. The pillar has drifted out of plumb and the geometry is wrong. We measure the posts first on every access control call in Tucker, because skipping that step is how you get a new operator that still doesn’t work right.
Usually not. Most keypad and control board retrofits mount to the existing pillar face or on a post adjacent to it without excavation. But if the pillar itself has moved and the gate no longer meets the latch, we may need to underpin or reset it. We’ll tell you honestly which situation you have and quote the work before touching anything.
A cellular-based smart access module works best when the gate is out of Wi-Fi range. It talks to your phone over the cellular network, not your home router, so you can open the gate from anywhere. These systems run $500 to $1,400 installed, and we handle the programming and testing on site. Call (877) 610-2993 for an exact quote, free.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Tucker since 2001.