Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Stone Mountain
When a driveway gate stops closing in Stone Mountain, the problem usually traces back to one of two things: a post set too shallow in granite, or a 25-year-old operator that’s simply worn out. We fix both, and we do it in your driveway, not by hauling the gate off to some shop. Gatewood Fence & Gate has repaired, realigned, and rebuilt gates across 30083, 30087, and 30088 since Hal Gatewood started the company in 2001. If your gate is sagging, jamming, or dead at the keypad, call (877) 610-2993 and a live person answers, any hour. We’ll give you an honest read on whether it’s a repair or a replacement, and we’ll quote the price before any work starts.
Why Gatewood Fence & Gate Is Stone Mountain’s Preferred Gate Repair Company
Our Gate Repair work in Stone Mountain runs on a simple rule: fix the failure, not the symptom. That means when a gate sags, we look at the hinge post first, because a gate sags in the post, not in the middle. Hal Gatewood’s name is on the shop, the license number is published, and the address is on the invoice. You can drive to the shop and look him in the eye. That’s the oldest accountability there is.
Stone Mountain homeowners call us because the person who answers the phone at 2 a.m. is the same person who shows up the next morning. We don’t route calls through a call center. We don’t leave you in a queue. And every job, from a hinge pin replacement on a 1990s wrought-iron gate off Memorial Drive to a full automatic operator swap near the park corridor, carries the 90-Day Done Right Promise in writing. If it’s not done right, one call brings us back. No runaround.
We also know Stone Mountain’s ground better than most. Our Stone Mountain crews don’t show up assuming a standard auger will do the job. They expect granite, and they bring the hammer drill, the epoxy anchors, and the base plates to prove it.
Our Gate Repair Services in Stone Mountain
Hinge & Post Repair
This is where most Stone Mountain gate failures start. We pull posts that were set in shallow holes and hit ledge at 10 to 12 inches, so the concrete cap is sitting on granite with maybe six inches of grip. That post wobbles, the gate racks, and the hinges tear loose. We drill into the ledge, epoxy galvanized anchor bolts, and set a base plate that actually holds. Then we re-hang the gate and adjust it so it swings true.
Gate Realignment
A gate that drags on the driveway or won’t latch is out of square, and the cause is almost always post movement in DeKalb’s expansive red clay. Wet winters swell the soil. Dry summers shrink it. Around Stone Mountain, that thin clay sits on granite, so water has nowhere to drain. The posts shift, the frame flexes, and every weld at the post collar takes stress it was never meant to take. We realign the gate at the hinges, correct the post lean where possible, and rebuild the weld points with our Gate Parts & Welding in Stone Mountain so the fix holds.
Automatic Gate Repair
The single-button DC operators installed on Stone Mountain gates in the 1990s and early 2000s are mostly obsolete now. Manufacturers stopped supporting them years ago, and parts are gone. When one of these fails, we don’t patch it. We replace the operator with a current model from LiftMaster, Linear, or DoorKing through our Gate Motor & Opener in Stone Mountain, matched to the gate’s weight, width, and daily cycle count. For long driveways without mains power, we install solar-ready operators that handle the duty cycle without a trench across your yard.
Electric Gate Repair
Photo eyes, keypads, safety edges, loop detectors. When an electric gate stops responding, the issue is usually in the low-voltage wiring or a failed safety sensor, not the motor itself. We trace the circuit, test each component, and replace only what’s failed. You get a written price before we touch anything, and the price we quote is the price you pay.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Stone Mountain
We service nine major gate brands, and for Stone Mountain homeowners, the ones that matter most are LiftMaster, Linear, Viking, and DoorKing. We stock common parts for these locally, so a bad control board on a Viking operator doesn’t mean waiting two weeks for a distributor. If your system has a Ghost Controls or Mighty Mule opener that’s failing under the daily cycle load of a heavy steel driveway gate, we’ll tell you honestly whether the operator is worth repairing or whether it’s time for a larger unit. You’ll never hear a sales pitch dressed up as a diagnosis.
Common Gate Repair Problems We See in Stone Mountain Homes
- Floating posts. A post set in a hole that hit granite at 10 inches and got a thin concrete cap is a floating post. It holds for a few years, then the whole column starts wobbling as clay shifts around it. We fix it with hammer-drill anchors into the ledge, not more concrete.
- Rusted hinge pins on 1990s wrought iron. The ornamental gates installed across 30083 and 30088 are now 20 to 30 years old. Hinge pins corrode, weld collars crack, and the gate starts sagging. We grind out the old weld, replace the pin, and re-weld on site.
- Obsolete DC operators. Those single-button openers from the 90s are dead weight. No manufacturer support, no replacement boards. We swap them for current operators with battery backup and proper safety sensors.
- Jam‑up on slide‑gate tracks. Rack and pinion slide gates on Stone Mountain clay end up with swollen, uneven tracks. The gate fights the rack, the motor overloads, and eventually something breaks. We fix the track, reset the rack, and correct the opener’s force settings.
Pricing for Gate Repair in Stone Mountain, GA
Every job gets a written price before we start. No trip charge inside the county. No invoice surprises at the door.
- Hinge pin or small weld repair: $180-$340
- Post repair with granite anchoring: $450-$900 per post, depending on depth to ledge and post size
- Gate realignment with frame correction: $275-$600
- Automatic operator replacement: $850-$2,200, depending on gate weight, width, and power source
- Full electric gate diagnosis and sensor repair: $200-$550
Stone Mountain’s granite adds real labor to post work, and we price it honestly, not with a “soil condition surcharge” you didn’t see coming. We also run standing offers: $40 off any repair over $200, a permanent 10% discount for seniors and veterans, and a free second opinion on any written estimate you’ve received from another company. Call (877) 610-2993 and we’ll talk through your gate before you spend a dime.
We Also Serve Cities Near Stone Mountain
Our Stone Mountain crews work the neighborhoods along Rockbridge Road, the streets west of the Park, and throughout 30083, 30087, and 30088. The same crew that fixes gates in Stone Mountain also handles calls in Gate Repair in Stone Mountain neighbors like Mountain Park, Tucker, Clarkston, and Redan. Same live person on the phone. Same 90-Day Done Right Promise on every job.
Serving Stone Mountain, GA - Our Local Coverage Area
We’re based in the Stone Mountain area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Stone Mountain
Because the concrete is probably sitting on granite, not gripping it. In much of Stone Mountain, especially 30087 and the park corridor, solid granite lies 12 to 18 inches below the surface. A standard auger stops at the rock, the installer pours a thin concrete cap anyway, and the post only has 6 to 8 inches of grip. After a few years of DeKalb clay swelling and shrinking, that cap loosens and the post wobbles. The fix is drilling into the ledge and setting epoxy-anchored bolts with a surface-mount base plate. Call (877) 610-2993 and we’ll take a look. The estimate is free.
Yes. We regularly install and service solar-powered operators on the acreage properties along Rockbridge Road and west of Stone Mountain Park where trenching mains power across 300 feet of granite ledge is cost-prohibitive. The operator runs on a battery bank fed by a solar panel, and as long as the panel gets decent sun and the battery is sized for the daily cycle count, it’ll hold up. If your existing solar setup is failing, we’ll diagnose whether it’s the panel, the batteries, the charge controller, or the operator itself. Call (877) 610-2993 for a straight answer.
In most cases, yes. The ornamental wrought-iron and tubular-steel gates installed across Stone Mountain’s brick ranch neighborhoods in the 90s are solid steel, and steel is repairable. We cut out the rusted hinge pin, weld in a new one, correct the frame alignment, and re-hang the gate. If a post has shifted and the gate is racked, we address the post before we correct the frame. You don’t fix a sagging panel without stopping the post movement first, or you’ll fix it twice. Call (877) 610-2993 and we’ll tell you what’s salvageable.
We do. The clay around Stone Mountain drains poorly because it sits on granite. A slide gate track set on that clay gets pushed and heaved over two or three seasons, and the rack starts binding against the pinion. That overloads the motor, trips the safety circuit, or strips the gear. We fix the track bed, reset the rack, and recalibrate the opener’s force and limit settings. If the track is too far gone, we’ll quote a replacement track honestly, not insist on a full gate replacement. Call (877) 610-2993 and describe the jam. We’ll tell you what it likely is over the phone.
Most single post repairs on granite take one full day on site. The time goes into drilling into the ledge, setting epoxy anchors, and letting the epoxy cure before we re-hang the gate. If the post is on the park side of 30087 and the access is tight, it can stretch into a second morning. We quote the time honestly before we start, and the price doesn’t change if the granite turns out to be closer to the surface than expected. Call (877) 610-2993 and we’ll put a scope together.
Stone Mountain’s gates fail in predictable ways: granite set posts loose, humidity rusts hinge pins, and 1990s operators die. Gatewood Fence & Gate fixes all three, on site, with the name of the owner on the invoice. Call (877) 610-2993 for a free estimate, or drive by the shop and talk to Hal directly. You won’t get a runaround. You’ll get a price, and a promise in writing.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Stone Mountain since 2001.