Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Poulsbo
Gate repair in Poulsbo usually falls into one of three categories: a gate that won’t open, a gate that won’t stay closed, or a gate that’s sagging and dragging on the gravel. Most automatic gate failures we see around Poulsbo trace back to a few culprits: salt-air corrosion from Liberty Bay, rotted hinge posts from decades of rain, or legacy operators from the 1980s and 90s that predate modern safety requirements. We handle all of it, and a live person answers when you call (877) 610-2993, day or night. No voicemail, no dispatch queue. Just a real fix, quoted up front before any work begins.
We’re Gate Repair specialists, and we work on gates all over Poulsbo, from the hillsides above downtown to the newer subdivisions off Noll Road and Finn Hill Road. The salt air and 50-plus inches of annual rainfall do things to gate hardware here that don’t happen in drier towns, and we’ve learned what that means: you don’t just patch a rusty hinge on a Poulsbo gate. You fix the post, the geometry, and the drainage, or you’ll be calling us again in two years.
Why Gatewood Fence & Gate Is Poulsbo’s Preferred Gate Repair Company
Hal Gatewood has owned and operated Gatewood Fence & Gate since 2001, and his name is on the shop and on every invoice. That’s not a marketing line. It means when we give you a price on the phone, that’s the price at the door, and we put the 90-Day Done Right Promise in writing on every job. If something isn’t right, one call brings him back. No runaround.
We’ve seen what Poulsbo’s marine climate does to gate hardware that was never built for it. A zinc-plated hinge that lasts 20 years in Yakima rusts at the ground line in five years near Liberty Bay. We stock stainless and hot-dip galvanized components for Poulsbo jobs, and when a gate can be repaired rather than replaced, that’s what we do. Hal’s crew handles our Gate Parts & Welding in Poulsbo on site in your driveway, so the gate stays where it belongs, and the person who shows up is background-checked, uniformed, and accountable to Hal himself.
Folks in Poulsbo tend to get our number from a neighbor who already used us. That’s the way it should be. Calls are answered by a live person 24/7, and the published address and license number are easy for anyone to verify. If you want, you can drive to the shop and look Hal in the eye before we ever touch your gate.
Our Gate Repair Services in Poulsbo
Electric Gate Repair
Electric gate operators around Poulsbo take a beating from the salt air off Liberty Bay. Control boards corrode, relays stick, and contacts green over faster than they should. We service and repair LiftMaster, Viking, DoorKing, Linear, and Ghost Controls operators, and we carry a range of Poulsbo Gate Motor & Opener parts for those brands locally. If your gate opens but won’t close, or closes but won’t stop, that’s usually a limit switch, a control board, or a degraded safety sensor, and we diagnose it on the spot. Typical electric gate repair in Poulsbo runs $185-$420 depending on the part and the age of the operator.
Automatic Gate Repair
Automatic gates on Poulsbo’s sloped driveways live hard lives. Swing gates rack against the grade, slide gates grind grit into their tracks, and every coastal winter tests every seal and connection. When an automatic gate in Poulsbo won’t open after a rainstorm, it’s almost always water in the operator, a swollen wood frame binding at the latch, or a photocell knocked out of alignment by a storm. We fix the actual cause, not just the symptom. Automatic gate repair in Poulsbo averages $150-$385, and we quote before we touch anything.
Hinge & Post Repair
Hinge and post repair is the single most common call we get in Poulsbo, and for one simple reason: salt air plus rain. Standard steel hinge posts rot at the ground line, especially where a gate sits in standing water on a bluff slope. We reset posts in deeper concrete footings, install hot-dip galvanized post brackets, and replace hinges with stainless or galvanized hardware that holds up to Liberty Bay’s environment. Hinge and post repair in Poulsbo typically costs $275-$650 depending on whether the post needs digging out and resetting.
Gate Realignment
A gate sags in the hinge post, not in the middle, and that’s where we start. On Poulsbo’s hillside lots, realignment often means re-hanging a gate after years of slope pressure, or shimming hinges to correct racking. We also handle the geometry of racked gates, which are built to follow a sloped driveway. When a racked gate is built wrong, runoff pools against the lower rail and rots the cedar frame from the bottom up. Gate realignment in Poulsbo runs $125-$300 for most residential gates.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Poulsbo
We’re certified to service nine major gate brands, and around Poulsbo we see a lot of LiftMaster, DoorKing, Viking, and Linear operators on older properties. We keep common parts for those brands stocked so we’re not waiting a week on a control board when your gate is stuck open at night. Whether it’s a Ghost Controls actuator from a newer install or a 25-year-old Viking swing operator, we can usually repair it in place rather than selling you a full replacement you don’t need.
Common Gate Repair Problems We See in Poulsbo Homes
- Racked gates trapping water at the lower rail: Poulsbo’s bluff lots above Liberty Bay often require racked gates to follow sloped driveway approaches. Built right, they shed water fine. Built wrong, they pool runoff against the cedar frame and rust the hinges out within five years.
- Legacy operators missing modern entrapment protection: Gate openers installed before the early 2000s around Poulsbo frequently lack functioning photocells or loop detectors. That’s a safety issue, not just a nuisance, and it’s one we can usually retrofit without replacing the whole operator.
- Salt-air corrosion at the hinge post ground line: Houses within a mile of Liberty Bay sit in a marine corrosion zone. Standard steel posts rust through just below grade, and when they fail, the gate drops suddenly. We replace them with hot-dip galvanized or stainless.
- Seasonal wood swelling and binding: Poulsbo’s wet winters swell cedar and pressure-treated gate frames enough to bind the latch. Come summer, they dry out and loosen. The fix is usually a realignment plus sealing the end grain, not planing the gate down over and over.
Pricing for Gate Repair in Poulsbo, WA
Here’s what Poulsbo homeowners can expect to pay for common gate repairs:
| Repair Type | Typical Poulsbo Range |
|---|---|
| Gate realignment | $125 - $300 |
| Hinge replacement (single gate) | $150 - $275 |
| Post reset with new footing | $350 - $650 |
| Control board replacement | $225 - $420 |
| Full gate rehang (heavy steel or wood) | $400 - $800 |
The price is quoted and agreed before any work starts. No trip charge inside Kitsap County. We offer $40 off any repair over $200, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. On a rusted hinge post we’ll in fact tell you whether welding it is smart money or whether the metal’s already too far gone and a new galvanized post is cheaper over five years. Call (877) 610-2993 for an exact quote, estimates are free.
We Also Serve Cities Near Poulsbo
If you’re outside Poulsbo proper but still in Kitsap County, we work in Bangor Trident Base, Silverdale, Bainbridge Island, and Tracyton. Same live-person phone answer, same 90-Day Done Right Promise, same repair-first approach. We’re Gate Repair in Poulsbo and across the peninsula, and we schedule local jobs directly.
Serving Poulsbo, WA - Our Local Coverage Area
We’re based in the Poulsbo area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Poulsbo
Rain after a dry spell almost always means one of three things: water got into the operator housing, the wood frame swelled enough to bind the latch, or a photocell got knocked out of alignment by the storm. We diagnose all three on site and usually fix the gate the same visit for $150-$385. Call (877) 610-2993 and we’ll schedule a time that works for you.
Usually yes. Older Poulsbo automatic gate operators often lack working photocells, loop detectors, or entrapment protection required by modern UL 325 standards. We can retrofit Gate Access Control in Poulsbo like safety edges and photocells onto many legacy LiftMaster, Viking, and DoorKing operators without replacing the whole unit, as long as the motor and gearbox are sound. If the board is beyond saving, we’ll say so plainly and give you a written quote before any work begins.
A racked gate is built so the bottom rail follows the angle of your driveway, which keeps the gate level at the latch side where it meets the post. On flat ground, a standard rectangular gate works fine, but on Poulsbo’s bluff slopes above Liberty Bay, the bottom of the gate must angle with the grade or the latch won’t line up, and the gate will drag or hang crooked.
Salt air from Liberty Bay rusts steel gate hardware from the inside out, and by the time you see rust at the bottom hinge, the steel is often thinner than it looks. Hal can usually tell within a few minutes of file-testing the metal whether welding is safe or whether the post needs replacing. If the post must go, a new hot-dip galvanized post with a deeper footing runs $350-$650 in Poulsbo. Get the free estimate at (877) 610-2993.
Poulsbo’s wet winters cause cedar and pressure-treated wood gates to absorb moisture and swell, which binds the latch. Summer dries the wood, the gate shrinks, and suddenly the latch is loose again. The permanent fix is a realignment, hinge adjustment, and sealing of the end grain so the wood stops taking on so much water. Short of that, we can re-time the hardware seasonally if needed, but sealing usually solves it. Call (877) 610-2993 and we’ll talk it through.
Call Gatewood Fence & Gate for Gate Repair in Poulsbo
If your gate is sagging, stuck, rusty, or just not working like it used to, call (877) 610-2993. A real person answers, and we’ll get you scheduled for a free estimate. You’ll get an honest assessment of what’s worth repairing and what’s not, a written price before any work starts, and the 90-Day Done Right Promise on the job. Hal’s name is on the shop. He stands behind it.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Poulsbo and Kitsap County since 2001.