Gate Repair in Melissa - Same-Day Repair, Priced Before We Start

Fast, Reliable Gate Repair Across Melissa

Gate repair in Melissa, TX typically runs $180-$340 for hinge and post realignment, $350-$900 for automatic opener replacement, and $150-$280 for weld and rust repair on ornamental iron. Most jobs here need same-week scheduling unless the gate is stuck open or off its track, in which case we treat it as an emergency and move it up the board. Hal and his crew know Melissa’s neighborhoods well, from the HOA entry gates on Milrany Lane to the acreage driveways off Highway 5. Call (877) 610-2993 and a live person answers, day or night.

Call (877) 610-2993

Why Gatewood Fence & Gate Is Melissa’s Preferred Gate Repair Company

Hal Gatewood started this shop in 2001 and built it on a repair-first philosophy. He welds on site in your driveway rather than hauling your gate off to some shop across the county. The name is on the shop, the address is published, and the license number is there for anyone to look up. That is the oldest accountability there is. If something is not done right, the 90-Day Done Right Promise is stamped in writing on every job. One call brings him back, no runaround.

Melissa customers call us because we answer with a live person around the clock. Not a voicemail. Not a call center three states away. You get someone who knows what a 16-foot tube steel gate weighs and why the Blackland Prairie clay under it matters. Our Gate Repair team shows up in background-checked, uniformed trucks, and you get a straight quote agreed before any work starts.

Our Gate Repair Services in Melissa

Gate Realignment

A gate sags in the hinge post, not in the middle, and that is where we start. In Melissa, the expansive clay under newer subdivisions swells after wet winters and shrinks through dry summers. That heave tilts hinge posts out of plumb within two to three years of installation, even on gates that look brand new. We reset the post, correct the sag, and retest the latch so the gate closes true again.

Hinge & Post Repair

Builders in Melissa’s master-planned communities often set gate posts in shallow footings because the clay is heavy to dig. Over time the post leans, the gate binds at the latch, and the operator strains against the misalignment. We dig deeper footings below the active clay zone, reset the post with proper concrete, and rehang the gate so it swings or slides without fight. Fix the panel without the post and you will fix it twice.

Automatic Gate Repair

Melissa has a real crop of mid-2010s developer-spec operators that were undersized for the gates they were paired with. A 600-pound masonry entry gate running on a light residential operator burns out motors within a few years. We diagnose whether the opener is worth repairing or whether it needs up-sizing to match the actual gate weight. We service LiftMaster, FAAC, BFT, Linear, and Viking units, and we stock common parts so we are not waiting on a distributor in Dallas.

Electric Gate Repair

Solar-powered openers on rural acreage entrances around Melissa lose charge during North Texas’s overcast winter stretches, leaving gates stuck mid-swing. We check panel output, battery health, and charge controller settings before replacing anything. On long driveways off FM 545 where mains power is impractical, the fix is often a properly sized panel array and a battery bank that holds through a stretch of gray days.

Trusted Brands We Service in Melissa

We are certified to service nine major gate brands, and for Melissa customers we keep parts on the truck for the ones we see most: FAAC, BFT, Linear, and Viking. That means less waiting on a FedEx box and more gates fixed same visit. If we are replacing an operator, we pair it to the actual gate weight and cycle duty, not just whatever the builder installed. Hal will tell you plainly if the old unit was undersized, because he has seen too many burned-out motors on gates that never should have carried them.

Common Gate Repair Problems We See in Melissa Homes

• Hinge posts tilting out of plumb. Blackland Prairie clay expands after wet winters and shrinks in summer heat. A post set in a shallow footing will lean, the latch stops lining up, and the operator starts faulting out. The fix is a deeper footing below the active clay zone, not just shimming the latch.
• Undersized developer-spec operators burning out. Melissa’s newer subdivisions often have masonry entry gates that were marketed as community amenities but paired with light residential openers. Three summers of 100°F heat and daily cycles kill those motors. We up-size the operator to match the gate.
• Solar openers dying in winter. Acreage properties outside the city core run solar-powered gate operators because running mains power down a 400-foot driveway is expensive. North Texas winters bring long overcast stretches, and undersized panels cannot keep batteries topped off. We size the array for winter sun angles, not summer peaks.
• Rust and weld fatigue on ornamental iron. North Texas heat and humidity tear through powder-coat finishes, especially at weld joints near hinges. We grind, weld, and re-coat on site, so the gate stays in your driveway rather than going off to a shop.

Pricing for Gate Repair in Melissa, TX

We Also Serve Cities Near Melissa

If you are just outside the city limits, we also cover Anna, Fairview, McKinney, and Princeton. Our crews are on the road across Collin County most days, and scheduling is coordinated from the Dallas-Fort Worth office. If you are in one of those towns and need Gate Repair in Melissa, call and talk to a human about when we can be there.

FAQs - Gate Repair in Melissa