Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Lynn
Gate repair in Lynn usually means one of two things: a gate that won’t open, or a gate that won’t close. Both get fixed the same way here. We start with the post, not the panel. In Lynn, that matters more than in most cities because the salt air off Lynn Harbor eats hinges and latches year-round, and the freeze-thaw cycle heaves posts out of plumb every winter. Gatewood Fence & Gate has been owner-operated since 2001, and when you call (877) 610-2993, you get a live person. Not a voicemail, not a chatbot. Hal Gatewood’s name is on the shop and on every invoice, and his crews serve Lynn neighborhoods from the Diamond District down to Lynn Shore Drive weekly.
Why Gatewood Fence & Gate Is Lynn’s Preferred Gate Repair Company
We’re the company Lynn homeowners call after the last company didn’t show. That’s not marketing. That’s the phone log. Most of our Lynn work comes from referrals in the triple-decker blocks off Lynnway and the single-family streets near Flax Pond, where one neighbor watches us reset a sagging gate and then asks if we can look at theirs. Hal has been at this since 2001, and he still answers his own phone. You can drive to the shop and look him in the eye. That’s the oldest accountability there is.
Our crews know Lynn’s housing stock before they arrive. We know that a rear-yard gate behind a pre-WWII triple-decker off Union Street was probably set in concrete poured when the building went up. We know that a driveway gate on a narrow lot near Lynn Common is likely original chain-link with a rusted bottom rail. And we know that an ornamental gate facing the water on Ocean Street is fighting salt corrosion every single day. That local knowledge means we show up with the right fix in mind, not a blank notepad.
Our Gate Repair Services in Lynn
Electric Gate Repair
Electric gates in Lynn fail in predictable ways. The operator works fine, but the gate drags. The remote works, but the gate reverses before closing. The keypad works, but the gate won’t budge. Most of the time the problem isn’t the operator at all. It’s a post that shifted, a hinge that seized, or a sensor wire corroded from salt air. We diagnose the whole system, not just the motor. If your LiftMaster or Viking opener keeps tripping in Lynn’s damp coastal air, the fix usually starts at the hinge post, not the circuit board.
Automatic Gate Repair
An automatic gate that slams or stalls in Lynn is often fighting a post that settled out of plumb over the winter. When the post leans even an inch, the gate binds and the operator burns out trying to compensate. We don’t just reset the opener and hope. We reset the post, realign the gate, and then teach the operator its new travel limits. That sequence is what keeps a gate running quietly for another decade. If the operator itself is done, we service major brands including Linear, Ghost Controls, and DoorKing, and our Gate Repair team carries common parts so the job doesn’t stall waiting on a shipment.
Hinge & Post Repair
This is the repair we do most in Lynn. A gate sags in the hinge post, not in the middle, and that’s where we start. In Lynn’s triple-decker neighborhoods like the Brickyard and Lower Boston Street, rear-yard gate posts were often set in shallow concrete footings 50 to 80 years ago. Frost heaves them up and over, the gate drags, and the hinge bolts wallow out their holes. We cut the post, weld a new footing, reset it plumb, and replace the hinges with hardware that can take the salt. Fix the panel without the post and you’ll fix it twice.
Gate Realignment
A gate that won’t latch or scrapes the ground isn’t just annoying. It’s wearing out the operator, the hinges, and the lock every time it cycles. In Lynn, where shared driveway gates on narrow lots get used dozens of times a day, a misaligned gate fails quickly. We realign the gate to the post, set the latch to close clean on the first throw, and check the gap so it doesn’t bind when the summer heat expands the metal. Show me the gate closing on its own and I’ll show you where it’s failing. Usually it’s the post, not the panel.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Lynn
We service and repair Gate Repair systems from Linear, Viking, Ghost Controls, DoorKing, and the other major brands. We stock common parts locally for our Lynn customers, so you’re not waiting a week for a capacitor or a limit switch to ship from a distributor. When an operator is beyond saving, we’ll tell you straight and quote you a replacement with the labor included up front. No swapping parts that don’t need swapping.
Common Gate Repair Problems We See in Lynn Homes
- Salt-seized latches and hinge pins. The salt air off Lynn Harbor gets into hinge pins and latch mechanisms on ornamental iron gates and rusts them solid. A gate that moved fine in June is frozen shut by November. We cut the old hardware off and replace it with marine-grade parts.
- Frost-heaved hinge posts. Lynn’s rear-yard gates behind triple-deckers are often set in footing concrete poured before Eisenhower was president. Repeated freeze-thaw cycles heave the post several inches, and the gate drags every winter no matter how much you lubricate it. The fix is a post reset, not a lubricant.
- Rusted-through chain-link frames. Shared driveway gates on narrow lots are frequently original low-grade chain-link. The bottom rail rusts through from salt and standing snowmelt, and under normal swing stress the frame folds. We weld a new bottom rail and brace the corners to keep it square.
- Triple-decker back gates nobody maintained for years. In Lynn’s rental-heavy corridors near the waterfront, a back gate might go five years between inspections. By the time we get the call, the post is out of plumb, the latch is seized, and the operator has been fighting it all along. We price that pattern into the first visit and fix it all at once.
Pricing for Gate Repair in Lynn, MA
Gate repair in Lynn is priced by the job, quoted before work starts, and agreed in writing. That’s non-negotiable. You’ll know the number before we touch the gate. A typical hinge and post reset in Lynn runs $320 to $680 depending on whether we need to cut and weld a new footing. A gate realignment with latch adjustment usually lands between $180 and $340. Rust repair and welding on a chain-link or ornamental gate runs $220 to $550, depending on how much rail needs replacing. A full electric gate operator repair or replacement on a Lynn driveway gate typically falls between $450 and $1,100, including the trip. Right now, any repair over $200 takes $40 off, there’s no trip charge inside the county, and a free second opinion on any written estimate. The price we quote is the price you pay.
Call (877) 610-2993 for a free estimate. We’ll come out, look at the gate, and tell you exactly what it needs and what it costs. No surprise invoice at the door.
We Also Serve Cities Near Lynn
If you’re just over the line in South Peabody, Swampscott, Saugus, or Revere, we handle gate repair there too. Our Lynn crews are on the road across the county every day, so the trip is short and the estimate is free. Call (877) 610-2993 and we’ll tell you when we can be there.
Serving Lynn, MA - Our Local Coverage Area
We’re based in the Lynn area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Lynn
Because your hinge post is frost-heaving. Water in the ground freezes, expands, and pushes the post up and out of plumb every winter, then it settles back a little in spring but never all the way. Over a few Lynn winters, the post drifts an inch or two, the gate drags and binds, and the fix is a post reset, not a can of WD-40. Call (877) 610-2993 and we’ll check the post before we touch anything else.
Gates near Lynn Harbor and Lynn Beach need hinge and latch hardware replaced far more often than gates inland in Saugus or South Peabody. The salt air rusts pins and latch mechanisms year-round, and we typically replace hinges, latches, and mounting bolts every five to eight years on waterfront gates, regardless of how well they’re maintained. Lubricating a salt-corroded hinge doesn’t remove the corrosion. It just greases the rust. Call (877) 610-2993 for a free assessment.
No. If the panel is straight and the frame is solid, the gate stays. Your posts are the problem. They were likely set in shallow concrete decades ago and have frost-heaved out of plumb. We cut the old posts, weld new footing plates, reset them plumb, and reuse your existing gate panel. That’s the repair-first approach. A new panel won’t fix a post that’s heaving. Call (877) 610-2993 and we’ll confirm what’s actually loose before recommending anything.
Yes. That reversing problem is usually the safety sensor misaligned, a hinge binding from salt corrosion, or a post that’s shifted and changed the gate’s travel path. We check the sensors, the hinges, and the post alignment, then reset the operator’s limits. Most reversal problems in Lynn are mechanical, not electrical. Call (877) 610-2993 and we’ll diagnose it on site.
It needs the hinge post reset first, then new hinges sized to the original ornamental iron work, and likely a realignment of the latch. On Lynn’s older Victorians off Western Avenue and Ocean Street, the ornamental gate is usually original and worth keeping. The problem isn’t the gate. It’s the post that’s been heaving in a shallow footing for 80 years. We reset it, weld new hardware mounts, and hang the same gate back straight. Call (877) 610-2993 for a free estimate.
We were called to a triple-decker on Ocean Street in the 01902 ZIP code where a custom ornamental swing gate was dragging and wouldn’t latch. Our tech found the hinge post had frost-heaved three inches out of plumb, the original latch was completely rust-seized from harbor air, and the gate panel itself was still straight. So we cut and welded a new post footing, reset the post plumb, and replaced the hinges and latch with marine-grade hardware before realigning the gate. The gate is still there, still straight, and now it latches on the first throw. That’s the difference between patching a symptom and fixing the post.
Contact Gatewood Fence & Gate in Lynn
If your gate drags, won’t latch, or the operator keeps failing in a Lynn neighborhood from the Diamond District to the waterfront, call (877) 610-2993. We answer live, around the clock, and we’ll set a time that works. The estimate is free, the price is agreed before work starts, and every job carries the 90-Day Done Right Promise in writing. If it’s not done right, we make it right. That’s the deal. Dispatch and scheduling for our Lynn crews is coordinated from our Boston office, but the person who shows up at your gate lives in the region and knows the salt air fight firsthand.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Lynn since 2001.