Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Lighthouse Point
Gate repair in Lighthouse Point usually comes down to one thing: salt. The finger canals that thread through this peninsula city sit close enough to every driveway that standard gate hardware fails in two to three years instead of eight to ten. A typical hinge or operator repair here runs $180-$340, and same-day service is available when a gate won’t open or close safely. Hal Gatewood and his crew have been fixing gates along these canals since 2001, and the shop carries the marine-grade stainless and galvanized parts this city actually needs. Call (877) 610-2993 and a live person answers, any hour.
Why Gatewood Fence & Gate Is Lighthouse Point’s Preferred Gate Repair Company
Most gate companies in Broward treat Lighthouse Point like any other zip code. We don’t, because the failure modes here are different. A gate on NE 31st Court decays faster than one a mile west in Pompano Beach, and anyone who has worked both areas knows why: canal-side salt air, aging pilasters, and operator housings that sit in humid, surge-prone air every hurricane season. Hal has repaired gates on almost every street in the 33064 zip code, from the older canal-front homes near Sample Road up to the newer custom builds off NE 33rd Avenue. When we show up, we already know what to look for before we touch the gate.
The person who answers your call is the same person who will stand in your driveway. That’s not a slogan. Gatewood Fence & Gate is owner-operated, with a published address and license number, and Hal’s name is on every invoice. The 90-Day Done Right Promise is in writing on every job: if something isn’t right, one call brings him back. No runaround. The crew arrives in uniform, background-checked, and the price is quoted and agreed before any work starts. For Lighthouse Point homeowners, that matters more than a flashy truck wrap.
Our Gate Repair Services in Lighthouse Point
Electric Gate Repair
Electric gate repair in Lighthouse Point frequently means a control board that got wet. On low-lying canal parcels, even a modest storm surge can push water into a ground-level operator box and short the board while the gate itself looks fine. We diagnose the board, the transformer, and the safety edges, then replace only what failed. If a LiftMaster or FAAC board can be repaired instead of replaced, we do that. Most electric gate repairs in Lighthouse Point run $160-$350 depending on the component.
Automatic Gate Repair
Automatic gates in Lighthouse Point need more than a working motor. The salt air that corrodes a hinge will also eat through operator chassis bolts, arm linkages, and limit switches. We see BFT and Viking operators with rusted internals on gates that are only four years old. Our crew services the full operator, reconnects sensors and keypads, and adjusts the force settings so the gate closes smoothly instead of slamming against salt-worn stops. Expect $200-$400 for typical automatic gate repair work here, quoted before we touch a single screw.
Hinge & Post Repair
This is where Lighthouse Point work gets specific. On many 1950s and 1960s canal homes, the hinge post isn’t a separate steel column; it’s a masonry pilaster with rebar inside. After six decades of salty humidity soaking through hairline concrete cracks, that rebar rusts, expands, and spalls the pilaster face. The post shifts under the gate’s weight, and the gate sags. A hinge swap alone won’t hold. We rebuild the post footing with epoxy-coated rebar, set marine-grade stainless hinges, and only then rehang the gate. That’s the difference between a fix that lasts six months and one that lasts fifteen years. Hinge and post repair in Lighthouse Point typically runs $250-$600 depending on pilaster condition.
Gate Realignment
A scraping gate on a Lighthouse Point driveway is often a hinge or post problem dressed up as an alignment issue. We start by loading the gate and watching where it moves. If the post is solid and the hinges are true, we adjust the pintle plate and the drop rod until the gate swings clean. If the post has moved, we say so, and we fix that first. Gate realignment here runs $150-$300 when posts are sound, and the price is locked before we begin.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Lighthouse Point
We carry parts and service support for nine major gate brands, and on most Lighthouse Point calls we’re working on FAAC, Linear, or LiftMaster equipment. Because our shop stocks the boards, arms, sensors, and stainless hardware these systems need, we’re not waiting on a multi-day shipment from a warehouse in another state. When your gate is down on a canal-front lot and the HOA wants it moving again, that local parts shelf matters. We also service Viking and BFT systems regularly. Whatever brand is on your pilaster, we’ll tell you straight whether it’s worth repairing or if the salt has gotten the better of it. Gate Repair is what we do full-time, not a sideline.
Common Gate Repair Problems We See in Lighthouse Point Homes
- Hinge seizure from canal salt spray. The salt-laden humidity off the finger canals works its way into hinge pins and bearing surfaces within a couple of years. We regularly replace seized steel hinges on Lighthouse Point gates with marine-grade stainless so the gate can swing without a hydraulic assist.
- Spalled pilasters on mid-century canal homes. Homes built between the 1950s and 1970s often have masonry pilasters with rusting rebar inside. When the concrete face crumbles, the hinge post shifts under load, and the gate sags or scrapes no matter how often it’s adjusted.
- Flooded operator boxes after storm events. In this city, a ground-level gate motor sits close to the water table even on a dry day. During hurricane season, surge pushes water into the chassis and shorts control boards. The gate looks fine from the driveway; it just won’t run.
- Weld fatigue on ornamental iron gates. The ornate scrollwork on older Lighthouse Point gates is beautiful until a salt-weakened weld separates under pressure. We repair rusted welds on site and reinforce the joint so the panel doesn’t crack again at the same point.
Pricing for Gate Repair in Lighthouse Point, FL
Gate repair pricing in Lighthouse Point runs higher than inland Broward for one honest reason: the parts this environment demands are more expensive. Marine-grade stainless hinges cost more than zinc-plate steel, and they’re the right call within a few hundred yards of a finger canal. Here’s what we quote, and the price you get is the price you pay.
- Hinge replacement: $180-$320 per gate, including marine-grade stainless hardware
- Operator or control board repair: $200-$400 depending on brand and board condition
- Gate realignment: $150-$300 when posts and hinges are sound
- Pilaster or post rebuild: $300-$600 depending on footing depth and rebar condition
- Weld and rust repair: $100-$250 per section, done on site, without hauling the gate away
We offer a free second opinion on any written estimate you’ve received from another company. No trip charge inside the county. And there’s a permanent 10% discount for seniors and veterans. Call (877) 610-2993 for a free estimate on your specific gate.
We Also Serve Cities Near Lighthouse Point
While this page is written for Lighthouse Point, we regularly work in the surrounding communities: Pompano Beach Highlands, Deerfield Beach, Pompano Beach, and Coconut Creek. Each area has its own quirks, but the same owner-operated crew shows up with the same written promise. For more on our broader service area, see Gate Repair in Lighthouse Point and the neighborhoods around it.
Serving Lighthouse Point, FL - Our Local Coverage Area
We’re based in the Lighthouse Point area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Lighthouse Point
Because your gate sits within a few hundred yards of a finger canal, and that salt-laden air never stops working on steel. The same operator that lasts eight years in Coconut Creek or western Pompano Beach fails in three to four years on a Lighthouse Point canal lot. We address this by using galvanized or stainless enclosures and sealing control boards against humidity ingress. Call (877) 610-2993 and we’ll look at what’s on your post.
In most Lighthouse Point cases, the gate itself hasn’t bent. The hinge post inside the masonry pilaster has shifted, almost always because the original rebar rusted, expanded, and cracked the concrete face. A sag correction without post repair won’t hold. We rebuild the footing, reset the post, and then realign the gate. That’s the only fix that lasts on these mid-century canal homes.
Yes. The salt air corrodes wiring connections inside the operator chassis, and it eats through the rubber seals around the control board. That lets humidity reach the board itself, so you get intermittent failures that are hard to trace: the gate opens sometimes, then not. We see this on FAAC and Linear units throughout Lighthouse Point. When we repair the board, we address the seals too.
If your operator sits at grade on a low-lying canal parcel, absolutely. We recommend raising the operator housing above the known surge zone where possible and always replacing standard seals with marine-grade gaskets. Even a few inches of storm water inside the chassis can destroy a control board. If your gate stopped working after the last storm, call (877) 610-2993 and we’ll diagnose it same day.
Almost always, yes. Hal welds on site, in your driveway, which means the gate never leaves the property. We cut out the rusted section, weld in fresh steel, grind the joint clean, and repaint. On several Lighthouse Point canal homes, we’ve kept original 1960s ornamental gates running and looking right, when other companies said replace. If you want an honest read on whether your gate is salvageable, call (877) 610-2993.
On a canal-front home off NE 31st Court, we rebuilt a sagging ornamental swing gate whose original hinge post had spalled from rusted rebar inside the masonry pilaster. Our crew poured a new post footing with epoxy-coated rebar, squared the gate, and installed a LiftMaster operator with marine-grade stainless hinges, so the gate now swings silently despite the salt air.
If your gate is sagging, seized, or dead in Lighthouse Point, call Gatewood Fence & Gate at (877) 610-2993. A live person answers, the estimate is free, and the price is set before we start. Hal’s name is on the shop, and the shop is down the road. That’s the oldest accountability there is.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Lighthouse Point and surrounding Broward County communities since 2001.