Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Lawrenceville
Gate repair in Lawrenceville usually runs $185 to $485 for most hinge, post, and operator fixes, and we can typically have someone at your gate the same day you call. We work on the automated subdivision entrances off Sugarloaf Parkway, the ornamental driveway gates along Russell Road, and the older swing gates in neighborhoods across 30044 and 30045. Hal Gatewood has been fixing gates since 2001, and the calls we get from Lawrenceville homeowners and HOA boards almost always come down to the same thing: a gate that was installed twenty-plus years ago and has finally worn through its original hardware. Call (877) 610-2993 and a live person answers, day or night.
Why Gatewood Fence & Gate Is Lawrenceville’s Preferred Gate Repair Company
We’re not passing through. Hal’s name is on the shop and on every invoice, and the shop is down the road. When a Lawrenceville HOA calls about a dead entrance gate on a Friday afternoon, the person who answers the phone is the same person who will show up with a welder and a box of control boards. Our Gate Repair team works on site. We don’t haul your gate to a shop somewhere and bring it back a week later. If the hinge post has heaved out of plumb, we cut it, repour the footing, and weld the hinge back where it belongs, right in your driveway.
Lawrenceville customers call us because we answer the phone. Not a voicemail tree, not a call center three states away. A live person, 24 hours a day, 7 days a week. That matters when a subdivision entrance gate is stuck open at 2 a.m. and the HOA board member on duty needs an answer now. Every job carries the 90-Day Done Right Promise in writing. If it’s not done right, we come back and make it right. One call brings Hal back. No runaround.
We carry a published address and license number anyone can look up. That’s the oldest accountability there is. When we give you a price, that’s the price. It’s quoted and agreed before any work starts, and nobody changes it at the door.
Our Gate Repair Services in Lawrenceville
Most of what we do in Lawrenceville falls into four areas. Here’s what each one actually involves on the ground here.
Hinge & Post Repair
This is the repair we see more than any other in Lawrenceville, and it’s almost always tied to the red clay. Gwinnett County’s expansive clay soil swells through wet winters and shrinks in dry summers, pushing post footings out of plumb inch by inch. A gate sags in the hinge post, not in the middle, and that’s where we start. If your gate drags on the ground or won’t latch in Lawrenceville, call (877) 610-2993 before the hinges tear out completely.
Gate Realignment
A gate that’s 2 inches out of plumb at the post translates to a 6-inch sag at the latch end. We see gates all over 30043 and 30044 that were hung on footings sized for a lighter aluminum panel, then upgraded to ornamental iron without replacing the post. The post heaves, the gate leans, and tightening the hinges only strips the threads. The real fix is cutting the post out, widening the footing, and re-hanging the gate on a post that can actually hold it.
Electric Gate Repair
Older Lawrenceville subdivisions run on Apollo and LiftMaster operators from the late 1990s and early 2000s. Those control boards fail without warning. One day the gate opens fine. The next morning it’s stuck halfway, and the board is dead. We diagnose the board on site, and if it can be repaired we repair it. If it’s obsolete, we retrofit with a current operator and add the safety sensors the original install never had. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule systems.
Automatic Gate Repair
When an automatic gate stops responding to remotes, keypads, or loop detectors, the problem is rarely the motor itself. More often it’s a dead control board, a failed limit switch, or a photocell that’s been knocked out of alignment. Around Lawrenceville we also see power supply problems from Georgia thunderstorms that pop surge protectors and take control boards with them. We carry common parts on the truck so we can usually fix the gate on the first visit.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Lawrenceville
We’re certified to service nine major gate brands, and in Lawrenceville the ones we see most are LiftMaster, Linear, Viking, and DoorKing. Most older subdivision gates in this area were built with LiftMaster or Apollo operators, and we keep the common boards, limit switches, and photo-eyes for those in stock locally. That means when a Linear operator on a 30044 driveway gate fails, we typically have the replacement part on hand and can get the gate working the same day we look at it. If you’re not sure what brand your gate is, call and describe the operator housing or send a photo. Hal can usually identify it from the shape and the year.
Common Gate Repair Problems We See in Lawrenceville Homes
- Heaved hinge posts from red clay soil. The soil here swells in winter and shrinks in summer, and single-post swing gates on shallow footings are the first to lean. You can tighten hinges, but the gate will sag again by spring unless the footing is widened.
- Obsolete Apollo control boards from the late 1990s. These fail without warning and leave the gate stuck open or closed. A board from 1998 was never designed to run for 25 years, and when it goes, it’s not a repair, it’s a replacement.
- Missing entrapment-protection photocells on pre-2008 operators. Almost every gate installed before the 2008 UL 325 mandate lacks photo-eyes or edge sensors. That’s a safety retrofit we recommend on nearly every older subdivision entrance in 30042 through 30046.
- Rust through ornamental steel panels near the creek drainages. Lower-lying subdivisions near the South Fork Peachtree Creek and Alcovy River drainages hold more humidity, and surface rust on steel panels accelerates faster there than on higher ground. We cut out rusted sections and weld in new steel on site.
Pricing for Gate Repair in Lawrenceville, GA
Here’s what gate repair actually costs in Lawrenceville right now. A hinge and post repair typically runs $185 to $420, depending on whether we’re replacing hinges, cutting out and repouring a footing, or both. Gate realignment on a heaving post runs $250 to $485, with the higher end covering a widened footing and re-hang. Electric gate repairs are the widest range: a limit switch or photocell replacement is usually $180 to $320, while a full control board replacement on an older LiftMaster or Apollo runs $350 to $650 parts and labor. We quote every price before work starts, and that’s the number on the invoice. No trip charge inside the county. Call (877) 610-2993 for an exact quote, estimates are free.
We Also Serve Cities Near Lawrenceville
Our Gate Repair in Lawrenceville service area extends to the neighboring towns where the same generation of subdivision gates is failing on the same schedule. If you’re in Lilburn, Norcross, Duluth, or Suwanee and your gate is heaving, sagging, or dead at the board, we’ll send someone out. These are the same 1990s-era operators and the same red clay, and we know exactly what to look for.
Serving Lawrenceville, GA - Our Local Coverage Area
We’re based in the Lawrenceville area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Lawrenceville
Because they were all installed at the same time. Lawrenceville’s HOA subdivisions were built in a single wave between roughly 1988 and 2008, and production builders used a short list of operators, Apollo and LiftMaster most of all. Those operators are now 20 to 35 years old, and their control boards are failing on roughly the same schedule. When one subdivision’s gate dies, the one down Sugarloaf Parkway is usually a few months behind it. Call (877) 610-2993 and we’ll tell you if your board can be repaired or needs replacing.
No, not to current safety standards. The 2008 UL 325 standard requires entrapment-protection devices like photocells or contact edges on automated gates, and nearly every gate installed before that mandate in Lawrenceville lacks them. A gate without photo-eyes will reverse on a child, a pet, or a car in its path only if it meets enough resistance, and that’s a serious safety hazard. A retrofit is straightforward and we do it regularly on older gates across 30042 through 30046. Call (877) 610-2993 and we’ll assess what your gate needs to pass a safety inspection.
No. A leaning post after rain is a footing problem, not a hinge problem. Gwinnett County’s red expansive clay swells when it gets wet and shrinks when it dries, and that cycle pushes shallow post footings further out of plumb every season. Tightening the hinges only pulls the post harder in the wrong direction. The real fix in Lawrenceville is cutting the post out, widening the footing, setting the post in concrete below the frost line, and re-hanging the gate. We do this on site, and it’s the only repair that stops the seasonal lean for good.
In most cases you can retrofit. If the LiftMaster operator itself still runs, we can add UL 325-compliant photo-eye pairs and sometimes edge sensors to bring it up to current safety standards. The exception is when the control board predates the wiring terminals for external sensors, which is common on very early LiftMaster boards from the mid-1990s. In those cases a replacement operator is cheaper than trying to make obsolete electronics do something they were never built to do. We’ll tell you which path applies to your gate when we look at it.
Because the hinge post was sized for an aluminum panel and never replaced when the heavier iron went on. This is the single most common failure we find in Lawrenceville subdivisions, particularly along the 30043 and 30044 corridors where builders put in single-post swing gates on shallow footings. An aluminum panel might weigh 250 pounds. Ornamental iron can be 500. The post heaves in the clay, and the gate sags. The fix is a new, deeper footing and a properly sized post, not a hinge adjustment. Call (877) 610-2993 for a free estimate, and Hal will tell you exactly what the post needs before anyone touches a wrench.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Lawrenceville since 2001.