Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Daly City
Most gate repairs in Daly City come down to one thing: rust in places you can’t see until the gate starts dragging. We’re Gatewood Fence & Gate, and we’ve been repairing gates on the Peninsula since 2001. When your side gate in the 94015 ZIP starts sagging toward the latch, or an automatic opener in Westlake stops responding, you want a repair crew that knows what coastal fog does to steel, not a rotating cast of subcontractors. Call (877) 610-2993 and a live person answers. Hal Gatewood runs the shop himself, and if your gate is down, we’ll get someone out to Daly City the same day.
Why Gatewood Fence & Gate Is Daly City’s Preferred Gate Repair Company
The name on the shop is Hal Gatewood, and Hal has been doing this since 2001. That matters when you’re in a neighborhood like Westlake or St. Francis Heights, where the fog rolls in off the Pacific every afternoon and the salt air eats through cheap hardware in five or six years. We’ve repaired gates on Doelger row homes, on the hillside streets above Mission, and on the newer builds closer to Serramonte. Our repair crews know which hinges fail on which streets, and why a gate that held fine in Noe Valley might be dragging after three winters in the 94014 ZIP.
Our reputation in Daly City is built on showing up when we say we will and fixing the gate where it sits. We don’t haul your gate back to some distant shop and return it three weeks later. We weld on site, in the driveway, with your gate still on its hinges when that’s the right call. Every job is stamped with our 90-Day Done Right Promise in writing. If it’s not done right, one call brings us back. No runaround, no fine print. That’s the whole promise.
Our Gate Repair Services in Daly City
Hinge & Post Repair
The hinge post is where every Westlake side gate eventually fails. We pull the gate, test the post for rot at the base, and reset or replace it before re-hanging the panel. In Daly City’s narrow side yards, a post set in constantly damp soil needs stainless hardware and proper drainage or you’ll revisit the same job within a few years. We do it right the first time, with materials spec’d for the marine layer.
Weld & Rust Repair
Rust is the Daly City special. Hollow steel tube frames hold moisture from the inside, and the salt air works on the weld points from the outside. Hal welds on site, grinding out rotted sections and patching with plate steel where the frame is worth saving. If a door’s steel is too far gone, we’ll tell you straight and quote a replacement panel, not sell you a patch that lasts one season. Fix the panel without addressing the post and you’ll fix it twice.
Gate Realignment
A gate that drags is usually sagging in the hinge, not in the middle. We assess the hinge geometry, re-weld or replace the hinges, and adjust the post angle to bring the gate back to true. On the Doelger row homes, we regularly find the same strap-hinge design sagging on six consecutive houses. If you’re in Westlake and your neighbor’s gate is dragging, yours may be next. We can spot the pattern before you call.
Automatic Gate Repair
Automatic gate openers in Daly City fail differently than they do inland. Salt condensation works into operator boards and safety photocells, causing intermittent faults that look like power issues. We service FAAC, Viking, and Linear operators, diagnose the real problem on site, and carry common parts so we’re not waiting on a distributor to ship something from Riverside. Automatic gate maintenance here means cleaning and sealing electrical connections at least twice a year. We’ll show you what to watch for.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Daly City
We service nine major gate brands, and for Daly City customers that includes the ones you’ll actually find on local homes and driveway systems: FAAC, Viking, and Linear. We know which models hold up under fog and salt spray in the 94015 and 94016 ZIP codes, and we keep the common replacement parts for those units where we can grab them same-day. The less time your gate sits dead, the better. If your opener is off-brand or older, we’ll still take a look and tell you honestly whether it’s worth repairing.
Common Gate Repair Problems We See in Daly City Homes
Here’s what we see most often when we get called to a Daly City gate:
- Corroded strap hinges on Westlake side gates. The Doelger row homes used the same strap-hinge pattern on almost every side yard gate. After decades of fog and salt air, the straps rot through and the gate sags into the latch post.
- Rotten hinge posts from trapped moisture. Concrete-set posts in narrow side yards collect water at the base. Rot starts below grade, invisible until the post splits when we re-hang the gate.
- Failing automatic gate boards from salt-air condensation. Fog infiltrates operator enclosures and leaves condensation on circuit boards. Intermittent dead-open or dead-close behavior in Daly City is often a corroded board, not a bad motor.
- Hollow steel tube frames rusting from within. Painted tube steel looks fine from outside, but moisture collects inside through pinhole rust. A gate that’s “suddenly weak” at the weld points has been failing internally for years.
Pricing for Gate Repair in Daly City, CA
We Also Serve Cities Near Daly City
The same crew that handles Daly City repairs also covers Gate Repair work in Visitacion Valley, South San Francisco, Noe Valley, and the Mission District. If you’re on the edge of town or just across Mission Street, the dispatch is still local to the Bay Area and the same 90-Day Done Right Promise applies.
Serving Daly City, CA - Our Local Coverage Area
We’re based in the Daly City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Daly City
Why do gates rust so quickly in Daly City compared to inland areas?
Daily fog and salt-laden air off the Pacific deliver a constant film of moisture and chloride to every steel surface on your gate. Combined with the marine layer’s cool, damp microclimate, it creates one of the most corrosive low-temperature environments on the Peninsula. Steel that lasts twenty years inland can rust through in five to eight years here. For an exact diagnosis of your gate, call (877) 610-2993 - we’ll give you a free estimate.
What type of hinges should I use for a side-yard gate in Westlake?
For side-yard gates in Westlake and other Daly City neighborhoods, hot-dipped galvanized or stainless steel hinges are the minimum we’ll install. Painted steel hinges, even premium ones, will rust underneath the paint. On a Doelger row home with a 36-inch side gate you can use heavy-duty galvanized strap hinges, but for anything wider we go to ball-bearing stainless hinges with a welded post bracket. We’ll quote the right spec based on your exact gate.
How do I know if my automatic gate in Daly City meets safety requirements?
If your automatic gate was installed before the current UL 325 standard was expanded, or if it’s a DIY opener without photo eyes or an edge sensor, it likely doesn’t meet current safety requirements. A gate that reverses on contact but has a dead spot mid-travel can close on a child or pet. We test the reversing loop, the photo eye sensitivity, and the ground edges on every automatic gate we touch in Daly City. Call (877) 610-2993 and we’ll assess yours.
What fails first on a typical Daly City side gate - the panel or the hinges?
The hinges almost always fail before the panel. Salt air concentrates at the hinge barrel and the lag bolts, rusting them from the outside while the panel itself still looks fine. By the time the panel is visibly rusted through, the hinges have been failing for years. That’s why we start every Daly City diagnosis at the hinge post, not the panel.
Do I need to replace my whole gate if the steel is rusted?
Not necessarily. Surface rust is treatable with grinding, welding on site, and a proper primer and maritime-grade paint. Through-and-through rot at weld seams, or rust that has compromised the structural integrity of the tube, is a replacement situation. We’ll show you the difference with the gate in front of you and recommend only what’s actually needed. If you have a written estimate from another company, bring it to us for a second opinion - free, no strings.
Contact Gatewood Fence & Gate for Gate Repair in Daly City
If your gate is dragging, sagging, or dead in the 94014, 94015, 94016, or 94017 ZIP, call (877) 610-2993. A live person answers 24/7. No call center, no voicemail. We’ll give you an honest assessment and a written price before any work begins. Hal’s name is on the shop and on every invoice, and the shop is right here in the Bay Area. Whether you need hinge replacement on a Westlake side gate, a weld repair on a rusted frame, or a new opener board for a FAAC or Viking system, we’ll get it done right and back it with our 90-Day Done Right Promise in writing.
Written by the team at Gatewood Fence & Gate, serving Daly City and the surrounding Bay Area with on-site gate repair, welding, and automatic opener work.