Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Motor & Opener Across The Acreage
If your gate motor stopped working in The Acreage, the fix usually comes down to one of three things: a corroded control board, a shifted hinge post, or an operator that was undersized for the gate from day one. We see all three weekly across the 1.25-acre lots that define this unincorporated stretch of Palm Beach County. Gate motor repair in The Acreage typically runs $180 to $340 for most residential operators, with full motor replacements falling between $850 and $2,400 depending on brand and gate weight. Call (877) 610-2993 and a live person answers, day or night.
Why Gatewood Fence & Gate Is The Acreage’s Preferred Gate Motor & Opener Company
Hal Gatewood started this company in 2001, and his name is still on the shop and on every invoice. We’re not a national chain running a call center out of state. Dispatch and scheduling are coordinated from our South Florida office, and the person who shows up at your gate in The Acreage works for Hal directly. No subcontracted strangers, no uniforms with a rented logo.
A gate motor is only as reliable as the post holding the gate and the wiring feeding the operator. A lot of companies will swap the motor and leave the post swaying, then act surprised when the new motor strips its gears six months later. We fix the hinge post first. We check the conduit for water intrusion. We set the gate’s travel limits so it doesn’t strain against itself. That’s why the 90-Day Done Right Promise is written on every job we do in The Acreage, not buried in fine print. If it’s not right, one call brings Hal back.
Our Gate Motor & Opener team has repaired and replaced operators on dozens of The Acreage properties, from custom estates off 140th Ave N to modest ranch homes along 60th St N. We keep common parts for FAAC, BFT, and Linear operators stocked, which means less waiting on a distributor and more same-visit repairs.
Our Gate Motor & Opener Services in The Acreage
Motor Repair
Most motor failures in The Acreage start beneath the surface. Water seeps into buried conduit during the wet season, sits in the low spots, and wicks up into the operator housing. We open the unit, dry or replace the board, re-seal the conduit entries, and test the load on the motor. If the gears still bite and the motor still draws within spec, you don’t need a new unit. You needed someone willing to find the actual fault instead of quoting a replacement.
Motor Installation
A new gate motor in The Acreage only makes sense when it’s matched to the gate’s weight, length, and daily cycle count. A heavy wooden ranch gate that swings open for horses twice a day needs a different motor than a light aluminum driveway gate. We measure the leaf, check the hinge post, and size the operator accordingly. Every installation includes a written quote agreed before any work starts, with no changed numbers when the job is done.
Linear Motor Replacement
Linear operators are common on The Acreage slide gates, and we service them regularly. The ram-style design works well on long driveways until the rack and pinion misaligns from post heave. When that happens, the motor pushes against a binding gate and the gears strip. We realign the rack, reset the post if needed, and only then replace the motor if it’s actually burned out. BFT and Viking operators get the same treatment.
Slide Motor Service
Slide gates on flat, low-lying lots take abuse from standing water and shifting soil. We see a lot of original 1990s slide operators throughout The Acreage that were installed when the lots were first built out. The motors still run, but the gate drags on a rusted track or the receiver board is shorting from corrosion. We replace rollers, clean and seal tracks, and pull new wire when the old run has turned brittle underground. A slide motor replacement here runs $950 to $2,400 depending on gate length and whether the track and rack need rebuilding.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in The Acreage
We’re certified on nine major gate operator brands, and the ones we see most on The Acreage driveways are FAAC, Linear, BFT, and Viking. That matters because parts availability and wiring pinouts differ between brands, and guessing leads to fried boards and blown fuses. If you have a FAAC swing arm that’s clicking but not moving, or a Linear slide motor that reversed direction on its own, we can diagnose it on site. For The Acreage customers, we keep the most common replacement boards, limit switches, and safety photocells in the truck, so many repairs wrap up the same day.
Common Gate Motor & Opener Problems We See in The Acreage Homes
- Corroded control boards from wet-season humidity and salt air. Even though The Acreage sits inland from the coast, the humid air that hangs over western Palm Beach County from June through October pushes moisture into operator housings and corrodes terminals. Original boards from the late 90s and early 2000s are dying at a steady clip.
- Post footing heave in sandy, high-water-table soil. A lot of hinge posts in The Acreage were set in sandy soil that saturates every wet season. The post shifts, the gate binds, and the motor strains against the added drag until something strips.
- Undersized operators on heavy ranch gates. Horse properties throughout The Acreage use oversized wooden gates that often outweigh what the original motor was rated for. Daily livestock traffic compounds the stress, burning out motors years before their stated lifespan.
- Rack and pinion misalignment on slide gates. On flat lots with poor drainage, slide gate tracks shift as posts heave. The rack pulls away from the pinion gear, the motor tries to compensate, and either the gears grind down or the safety photocells trip constantly.
Pricing for Gate Motor & Opener in The Acreage, FL
Gate motor repair in The Acreage runs $180-$340 for most residential service calls. That includes board-level repairs, limit switch replacement, travel adjustments, and wiring fixes. A new swing arm operator installed runs $850-$1,600, while heavy slide gate motor replacement ranges $950-$2,400. Battery backup additions run $400-$800 on most systems, and intercom integration typically adds $350-$900 depending on wiring. Seniors and veterans take 10% off every job, and any repair over $200 gets a $40 discount. No trip charge inside Palm Beach County. Call (877) 610-2993 for a written estimate before any work begins.
We Also Serve Cities Near The Acreage
Our gate motor and opener service covers The Acreage and the surrounding western Palm Beach County communities. If you’re in Royal Palm Beach, Palm Beach Gardens, Wellington, or Lake Park, the same crew that handles Gate Motor & Opener in The Acreage can reach you. Same live answers, same written estimates, same 90-Day Done Right Promise on every job.
Serving The Acreage, FL - Our Local Coverage Area
We’re based in the The Acreage area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Motor & Opener in The Acreage
The sandy soil under The Acreage saturates during wet season and causes hinge posts to heave, which shifts the gate’s alignment and forces the motor to work against added resistance. That strain accelerates wear on gears, burnishes limit switches, and shortens motor life by years. The fix is a properly set post with deeper footing and adequate drainage. We quote the post work and the motor work together because doing one without the other means doing it twice. Call (877) 610-2993 to have a gate measured in The Acreage.
The Acreage is unincorporated Palm Beach County, so any gate motor repair that crosses into permit-required scope goes through the Palm Beach County Building Division rather than a municipal office like Wellington has. Inspection schedules, code interpretations, and turnaround times all differ. We handle the paperwork and know which jobs trigger a permit and which don’t. Nothing gets installed without the right sign-offs.
Yes. The humid air that pushes across South Florida carries enough salt and moisture to corrode terminals, circuit traces, and connector pins inside an operator housing, even one that’s closed and latched. The corrosion starts at the conduit entry points and spreads inward. Sealed conduit fittings, dielectric grease, and stainless hardware slow it down. We specify those on every The Acreage installation instead of the zinc-plated hardware that rusts through in two seasons.
Usually, yes. The sag is almost always in the hinge post, not the motor. If the post is still sound, we repair the hinge, re-hang the gate, and let the original motor run as long as it’s drawing proper amperage. Replacing the motor without fixing the sag burns out the new operator in months. We’ll tell you straight if the motor itself is near end-of-life. A free second opinion on any written estimate is available to every The Acreage customer.
Gate operators in The Acreage must meet UL 325 entrapment protection standards, which mandate inherent entrapment sensing, secondary protection like photocells or contact safety edges, and audible alarms on many installations. Palm Beach County enforces these requirements, and we install every operator to current code. If your gate has a safety edge that’s cracked or photocells that trip constantly, that’s a repair we handle the same day.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate. Hal has been fixing gates and gate motors in Palm Beach County since 2001, and his name is on every invoice. Call (877) 610-2993 and he’ll answer.