Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Motor & Opener Across Foxborough
Gate motor and opener repair in Foxborough runs $220-$480 for most board swaps, limit adjustments, and gear replacements, while full opener retrofits on older gates typically land between $900 and $1,700. We service the whole 02035, from the neighborhoods off Route 1 near Gillette Stadium to the older colonials around the town center. If your gate is stuck half-open or the motor is grinding, call (877) 610-2993. A live person answers, and Hal Gatewood sends someone who knows exactly which streets eat gate hardware and why.
Why Gatewood Fence & Gate Is Foxborough’s Preferred Gate Motor & Opener Company
Hal Gatewood has been at this since 2001, and the name on the shop is the name on the invoice. That matters in a town like Foxborough, where half the automated gates we see were installed by somebody who no longer answers the phone. We work on what’s in front of us first. If a control board is fried, we don’t tell you the whole operator needs replacing just so we can bill a bigger number. Sometimes it does need replacing, and we’ll tell you that straight, with the math to back it up.
Foxborough homeowners call us because we’ve already fixed the gate two houses down. The morning after a Patriots home game or a stadium concert, our phone rings with the same story: the gate cycled a dozen times in an afternoon, then died. We know that pattern cold. We stock actuator parts, control boards, and battery backups locally so we’re not waiting on a warehouse in Ohio while your driveway sits open to Route 1 spillover traffic.
Every job carries the 90-Day Done Right Promise in writing. If it’s not fixed right, one call brings us back, no runaround. Response time to Foxborough is same-day or next-morning for most calls, including weekends when the stadium is hosting.
Our Gate Motor & Opener Services in Foxborough
Motor Installation
Motor installation in Foxborough typically runs $950-$2,400 depending on gate weight, operator type, and whether we’re converting a manual gate or pulling out an old opener. We install slide, swing, and linear operators sized for the gate, not the website’s best seller. Around Foxborough’s older colonials off Central Street and Mechanic Street, we often recommend upgrading the hinge posts at the same time. The motor can be new, but if the post is forty years old and soft at the base, you’ll be calling us again in a season.
Motor Repair
Motor repair calls in Foxborough split into two buckets: dead control boards and mechanical wear. Control boards fail from heat, moisture, and repeated cycling. Mechanical wear shows up as grinding, slow travel, or a gate that stops halfway. We repair what’s repairable. Hal’s crew welds on site, in your driveway, not in some warehouse. If a bracket cracked, we weld it. If a gear stripped, we swap it. You’re not paying for a boxed replacement when $180 of parts and an hour of work gets the same gate moving right.
Linear Motor
Linear operators are common on the ranch-style and garrison colonial homes built across Foxborough in the 1970s and 80s. These run on a threaded shaft or chain-driven carriage, and when they fail, it’s usually the limit switch or the drive nut. We service linear motors from FAAC, BFT, and Linear, and we carry common limit switches and capacitors on the truck. A linear motor tune-up on a Foxborough driveway gate runs $160-$320, and that usually includes cleaning the rail, adjusting the stops, and checking the clutch.
Slide Motor
Slide motors take a beating in Foxborough because so many driveways along Route 1 and the surrounding streets use them to keep event traffic out. When a car clips the gate edge, the rack and pinion gets knocked out of alignment, and the motor works against itself until it burns out. We straighten the rack, reset the pinion clearance, and replace limit switches as a set. Slide motor repair here runs $240-$510. If the gate is pre-UL 325 and has no safety photocells, we talk to you about adding them before someone gets hurt.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Foxborough
We’re certified to service nine major gate brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Most Foxborough gates we see run on FAAC, BFT, or Linear equipment, and we keep parts for those three on hand more than any others. That means when your opener quits the morning after a Gillette Stadium sellout, we’re not ordering a board and telling you to wait four days. We’re fixing it that afternoon or the next morning.
Common Gate Motor & Opener Problems We See in Foxborough Homes
- Burned-out control boards after event days. When Gillette Stadium hosts 65,000 people, residential streets within a mile or two of Route 1 fill with cars avoiding lots. Drivers use private driveways as turnarounds, and the gate cycles twenty times in an afternoon. The board overheats and dies.
- Sagging hinge posts on older wrought-iron gates. Foxborough’s town center has plenty of original iron gates set in fieldstone or old concrete. After twenty or thirty southeastern Massachusetts winters with freeze-thaw cycles heaving the ground, those posts shift. The gate drags, the motor strains, and something eventually burns.
- Road salt corrosion on hinges and latches. Route 1 gets heavily salted all winter, and that salt spray gets kicked up onto low-mounted gate hardware. We see latches so corroded they won’t release, and hinges that grind metal-on-metal until the motor can’t pull the gate anymore.
- Battery backup failures. Battery backups die quietly. Homeowners don’t know until the power blinks and the gate won’t move. After we see battery corrosion on a Foxborough gate, we check the backup on every service call we make within a mile of that house. It’s cheap insurance against the next outage.
Pricing for Gate Motor & Opener in Foxborough, MA
Here are honest numbers for Foxborough, not a national average. Control board replacement runs $180-$380. Limit switch and capacitor jobs run $140-$260. Gear or drive nut replacement on a linear motor runs $220-$440. Full operator retrofits on older slide or swing gates run $950-$1,700. Battery backup installation runs $280-$520, and safety photocell installation on a pre-UL 325 gate runs $190-$340. The price is quoted and agreed before any work starts, in writing. No trip charge inside the county, and we offer $40 off any repair over $200. Seniors and veterans get 10% off, permanently. Call (877) 610-2993 and we’ll talk through what your gate actually needs.
We Also Serve Cities Near Foxborough
Our Gate Motor & Opener team works across the towns around Foxborough, including Mansfield, Sharon, Wrentham, and Walpole. If you’re just over the line in Sharon or Walpole, you get the same live-answer phone, the same upfront pricing, and the same Gate Motor & Opener in Foxborough crew that’s been fixing stadium-adjacent gates for years. Call us and we’ll be there.
Serving Foxborough, MA - Our Local Coverage Area
We’re based in the Foxborough area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Motor & Opener in Foxborough
Because your gate is cycling fifteen or twenty times in a few hours while event traffic uses your driveway as a turnaround point. Each cycle heats the control board, and on a legacy operator without thermal protection, the board eventually gives. The fix is usually a properly sized board replacement plus a battery backup and adjusted limits so the gate isn’t working harder than it should. Call (877) 610-2993 and we’ll take a look.
In most cases we can retrofit a 1980s operator with modern safety photocells without replacing the whole unit. The work involves mounting the photo eyes, running low-voltage wiring back to the control board, and verifying the entrapment protection cycle. Cost in Foxborough runs $190-$340 per gate. If the control board is too old to accept a monitored photo eye input, then replacement becomes the cheaper answer, and we’ll show you why in writing before any work starts.
No. The motor isn’t causing the sag. Foxborough’s 20-30 freeze-thaw cycles each winter heave the gate posts, and when the post leans even a few degrees, the gate sags and the motor works against the bind. We fix the post first, then re-level the gate, then adjust the motor limits. Fix the panel without the post and you’ll fix it twice.
Yes, and we see it more in Foxborough than anywhere else we work. Streets within a mile of Route 1 get heavy overflow parking and turnaround traffic during Patriots games, Revolution matches, and major concerts. Vehicles clip gate edges, slam gates closed, and cycle openers repeatedly. No neighboring town has this traffic pattern at this scale, and it’s why we stock extra actuator parts and control boards before the fall NFL schedule starts.
First, kill power to the opener at the breaker so the board doesn’t cook further. Second, inspect the gate from a safe distance. If it’s partially open and blocking your driveway, leave it alone, and don’t try to force it. Then call (877) 610-2993. We answer live, 24/7, and we’ll walk you through what to check over the phone. Most post-event failures we see are blown boards or knocked-out limit switches, and we can usually be on site in Foxborough the same day.
Call Gatewood Fence & Gate for Gate Motor & Opener Work in Foxborough
Hal Gatewood’s name is on the shop, and the shop is down the road. That’s the oldest accountability there is. If your gate motor is dead, grinding, or sagging, call (877) 610-2993 now. We’ll give you a straight answer, a written price, and a day we’ll be there. Free estimates, no trip charge inside the county, and the 90-Day Done Right Promise on every job, in writing. Foxborough gates break in Foxborough-specific ways, and we’ve been fixing them long enough to know exactly what that means.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Foxborough since 2001.