Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across North Palm Beach
Installing a gate in North Palm Beach is not the same job as installing one ten miles inland. The salt air coming off the Intracoastal and the Atlantic less than a mile east chews through hardware at a rate that shocks people who moved here from Orlando or Atlanta. A brand-new swing gate operator that should last ten years in Palm Beach Gardens often fails in five or six here, because the control board terminals corrode from constant marine humidity. We know this because we fix it every week, and we build every new install in that reality. If you’re planning a driveway gate, pedestrian gate, or full perimeter entry in the 33408 zip, call Hal at (877) 610-2993 for a free estimate and a spec that will actually survive North Palm Beach.
Why Gatewood Fence & Gate Is North Palm Beach’s Preferred Gate Installation Company
Hal Gatewood has been welding and installing gates since 2001, and his name is on the shop. That matters when you live in a village of 5.6 square miles where half your neighbors are in an HOA and the other half are on the water. We are not a franchise that sends a different crew every time. Hal or one of his long-time guys shows up, looks at your posts, your soil, your salt exposure, and tells you straight what will hold and what will not. Our Gate Installation team has done enough work in North Palm Beach to know that a galvanized hinge pin in Lost Tree Village will look like a rusted nail within two years. So we do not use them there.
We answer the phone around the clock. Not a voicemail. Not an answering service in another time zone. You call, a person picks up, and if you’re in North Palm Beach we can usually have someone out the same day or the next morning for an estimate. Every job, from a single pedestrian gate to a full double gate entry, carries our 90-Day Done Right Promise in writing. If it is not right, we come back and make it right. No runaround. And our pricing is quoted before any work starts, so the number you hear on the phone is the number you see on the invoice. North Palm Beach residents have enough to worry about with HOA boards and hurricane season. Their gate should not be one more headache.
Our Gate Installation Services in North Palm Beach
Driveway Gate Installation
Most driveway gates in North Palm Beach are either swing gates across a paver or shell driveway, or sliding gates spanning a wider entry. The biggest install mistake we see from outside companies is using standard galvanized hardware within blocks of the Intracoastal. We spec marine-grade hinges, stainless pins, and zinc-rich primed posts because anything less will sag and bind within a few years. Driveway gate installation in North Palm Beach typically runs $2,800 to $6,500 for a standard single swing gate with manual operation, and $4,500 to $9,800 with automation. Double driveway gates run higher, usually $6,000 to $14,000 depending on width, material, and whether the HOA requires a specific ornamental design.
Pedestrian Gate Installation
Pedestrian gates take a beating here because they get cycled constantly, and the lower hinge sits right where salt spray collects. We install pedestrian gates in North Palm Beach with stainless fasteners and a powder coat rated for marine environments, which is not something you’ll get from a warehouse box gate. A basic steel pedestrian gate with posts and hardware runs $900 to $2,400. Wrought iron or custom ornamental work runs $2,500 to $5,000, depending on the design and whether it has to match an existing perimeter fence.
Sliding Gate Installation
Sliding gates are common in North Palm Beach where a driveway slopes toward the street or where there is no room for a swing arc. The failure mode specific to this area is salt crust building on the rack and pinion teeth, which makes the motor strain until the teeth strip. We install sliding gates with sealed rack, stainless rollers, and a marine-grade operator housing that keeps the board dry and the electrical connections from turning green. A new sliding gate in North Palm Beach runs $3,500 to $8,000 for a single cantilever or track slide, and $7,000 to $15,000 for a wide automated slider with safety edges and loop detectors.
Swing Gate Installation
Swing gates are the most common type in North Palm Beach, especially in the older subdivisions built out from the late 1950s through the 1970s. Those original gates often use FAAC operators that have been patched and re-patched for twenty years, and the hinge posts are frequently the weak point. When we install a swing gate here, we start with the post footing, not the panel. The post has to be set deep enough in the sandy, salty soil and the weld points have to be coated correctly, or the gate sags and the operator burns out fighting it. A new automated swing gate runs $3,200 to $7,500 single, $6,500 to $13,000 double, depending on width, weight, and operator type. Every price we quote includes the post work, because a gate installed without good posts is a gate you will pay for twice.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in North Palm Beach
We install and service FAAC, BFT, Linear, and Viking operators, along with LiftMaster, Ghost Controls, DoorKing, Elite, and Mighty Mule. We keep common boards, photocells, and remotes stocked for North Palm Beach customers, because waiting a week for a part when your gate will not close is not acceptable. Salt air is hardest on control boards, so when we install a new operator near the water we often upgrade to a marine-grade board or add extra sealing around the terminals. If you have an existing FAAC or BFT swing gate that keeps failing, ask about a board replacement before you pay for a whole new operator.
Key Takeaways for North Palm Beach Gate Installation
- Salt air on the Intracoastal strips gate hardware 3 to 5 years faster than five miles inland, so stainless and marine-grade specs are not optional.
- Hinge post rot at the weld points is the most common reason gates sag and bind in North Palm Beach.
- Control board terminal corrosion inside FAAC, LiftMaster, and BFT housings peaks right before storm season each year.
- Swapping a gate panel without addressing the posts means you will pay for the same job again inside five years.
- We quote the full price before any work starts, and every install carries our 90-Day Done Right Promise in writing.
Common Gate Installation Problems We See in North Palm Beach Homes
- Salt corroded hinge pins seizing the gate. Within blocks of the water, standard steel hinge pins lock up within a few years, and the gate starts binding against the operator until the motor burns out. We saw a 1970s subdivision entry in North Palm Beach where every hinge pin on a double swing gate had seized so completely that the gate could not be swung by hand.
- Control board terminals turning green inside the operator housing. Marine humidity enters through the breather holes and corrodes the terminal strip, causing intermittent open and close failures that are worse right before summer storm season. A FAAC board in a seaside enclosure needs far more attention than the same board inland.
- Stripped rack and pinion teeth on sliding gates. Salt crust builds on the drive teeth, the motor strains against the extra friction, and eventually the teeth shear off entirely. That is a preventable failure if you clean the rack regularly and use a sealed drive system.
- Weld point rot where the gate meets the hinge post. This is the classic North Palm Beach failure. The weld itself holds, but the heat affected zone around it rusts through from years of salt spray, and one day the gate drops. We coat every new weld with a zinc-rich primer before final paint or powder coat, which is a spec that adds years to a gate’s life near the Intracoastal.
Pricing for Gate Installation in North Palm Beach, FL
Here is what honest numbers look like in this market. A manual pedestrian gate in North Palm Beach runs $900 to $2,400. A single automated swing gate runs $3,200 to $7,500. A double automated swing gate runs $6,500 to $13,000. A sliding gate runs $3,500 to $15,000 depending on span and automation. What moves the price most is the hardware spec. Marine-grade stainless hinges, posts, and fasteners cost more up front than standard galvanized, but they are the difference between a gate that lasts seven years and one that lasts twenty. The second driver is HOA requirements. Communities like Lost Tree Village have strict aesthetic standards, so a matching ornamental design costs more than a stock panel. We always give you a written price before starting, and the price we quote is the price you pay. Call (877) 610-2993 for a free estimate at your property.
North Palm Beach’s housing stock was mostly built between the late 1950s and the 1970s, and many of the original subdivision entry gates are still partially in service, repeatedly repaired rather than replaced. That means we often find corroded conduit runs and aging FAAC operators that have been jumped and patched for decades. A new install that works with that old conduit instead of replacing it will fail again. We price the conduit work honestly, which is why our quotes sometimes look higher than a company that plans to ignore it until it shorts out.
We Also Serve Cities Near North Palm Beach
Our Gate Installation in North Palm Beach service covers the whole 33408 zip, from the waterfront properties along the Intracoastal to the gated subdivisions inland. We also regularly install gates in Lake Park, Riviera Beach, Palm Beach Gardens, and Palm Beach. If you are just outside the village line, call us anyway, because our no-trip-charge policy likely covers you. We would rather have the chance to look at your gate than argue about a map boundary.
Serving North Palm Beach, FL - Our Local Coverage Area
We’re based in the North Palm Beach area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in North Palm Beach
Plan on replacing a swing gate operator every 6 to 8 years if you live within a few blocks of the water, compared to 10 to 12 years inland. The marine humidity corrodes the control board terminals and the motor windings long before the gears wear out. If your FAAC or LiftMaster operator is older than eight years and you are getting intermittent failures right before storm season, call us before it quits entirely. We can usually inspect it same day and give you a straight answer about repair versus replacement. Call (877) 610-2993 and we will tell you honestly which one makes sense.
For a slide gate in North Palm Beach, the post footing should be at least 36 inches deep with a 12 inch diameter concrete pier, and the concrete should be mixed with a corrosion inhibitor because the groundwater near the Intracoastal is brackish. We also set the posts in a heavy gauge galvanized steel sleeve before pouring, which prevents the salt from wicking up the post and eating through it at ground level. In higher water table spots near the canal network, we may go deeper or use a wider pier. This is exactly the kind of spec that separates a gate that stays true from one that leans within four years.
Yes, and that is not a negotiation. Lost Tree Village and several other North Palm Beach enclaves have architectural review boards that require replacement gates and operators to match the original ornamental design, often custom monument ironwork from the community’s original build era. A stock panel or a generic operator housing will not pass inspection. We have done this work in Lost Tree Village, so we know what the board expects, and we can match original ironwork and housing styles before you submit for approval. If you are in a community with these standards, mention it when you call so we bring the right samples.
Salt air is shorting the photocell wiring or the cell itself. The cells are sealed units, but the wire splices and the terminal connections inside the junction boxes are not, and in North Palm Beach’s constant marine humidity the splices corrode until the signal drops and the operator thinks something is in the path. Then the gate refuses to close, and a technician who does not know the area replaces the photocell, gets it working for a month, and blames the cell when it fails again. The fix is replacing the corroded splices with marine-grade sealed connections, or running fresh wire. We do that as standard on any North Palm Beach gate repair.
You can, but you have to be honest about the location. Solar gate openers work well when the panel gets direct sun for most of the day, which many waterfront driveways in North Palm Beach do. The salt air concern is the battery and the terminals, not the panel itself. We install solar operators with marine-grade battery enclosures and sealed terminal strips, and we mount the panel where salt spray from the Intracoastal will not cake the glass. If your property sits under heavy oak canopy, solar is not the right call, and we will tell you that plainly instead of selling you a system that drains every three days. Call (877) 610-2993 for an honest assessment and a free estimate.
Call Gatewood Fence & Gate for Gate Installation in North Palm Beach
If you need a new gate, a replacement operator, or an honest second opinion on a quote from another company, call Hal at (877) 610-2993. You will get a live person, a straight answer, and a written price before any work starts. We have been installing gates since 2001, our name is on the shop, and we stand behind every job in North Palm Beach with the 90-Day Done Right Promise. No dispatch queue, no call center, no pressure. Just a local gate crew that knows what the Intracoastal salt air does to hardware and builds accordingly.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving North Palm Beach since 2001.