Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Fort Myers
Gate installation in Fort Myers, FL typically runs $1,400 to $6,800 depending on the gate type, post work, and whether you’re replacing an existing gate or starting fresh. We install driveway, pedestrian, sliding, and swing gates across Fort Myers with the HOA approval process built into how we quote. If your gate took damage from Hurricane Ian or the salt air has finally killed the old operator, call (877) 610-2993 for a straight answer and a written price before any work starts.
Fort Myers is different from inland Florida, and not just because of the humidity. We work in communities where the board has to sign off on every hinge, every color, every post cap. That’s not a nuisance to us. It’s just the job done right the first time, so you’re not redoing it in front of an unhappy architectural review committee.
Why Gatewood Fence & Gate Is Fort Myers’s Preferred Gate Installation Company
Hal Gatewood has been running Gatewood Fence & Gate since 2001, and the shop is still his. His name is on the invoice, his license number is published, and the person who shows up to measure your gate is the same person you’ll see again if anything needs adjusting. That matters in Fort Myers, where the gate on your driveway has to survive salt spray, summer downpours, and another hurricane season.
When a Fort Myers customer calls, a live person answers. Not a voicemail tree, not a call center. You get Hal or someone on his crew, day or night. We’ve pulled bent gates off crushed rails in Iona, reset posts in Cypress Lake, and replaced operators in McGregor where the control board corroded from standing water after Ian. We know which communities off Colonial Boulevard have strict swing-gate-only covenants and which Gateway sub-associations standardized on LiftMaster slide operators in the mid-2000s. That’s local knowledge you can’t get from a national outfit.
Our Gate Installation Services in Fort Myers
Driveway Gate Installation
Most driveway gates in Fort Myers are ornamental aluminum swing gates on brick or stucco pillars, especially in the HOA neighborhoods built from the 1980s through the 2000s. We measure the opening, check the pillar structure, and size the gate so it clears the driveway apron without dragging. If the old posts are cracked or leaning, we pour new footings before hanging anything.
Sliding Gate Installation
In a lot of Fort Myers shared driveways and rights of way, a swing gate simply won’t fit. The setback isn’t there. That’s where a slide gate on a rack and pinion works better, but only if the track is shimmed level on the existing pillar. We’ve seen gates bind and burn out operators because someone bolted the rack to a wavy pillar and called it done. We don’t do that. A sliding gate keeps vehicle access tight against the property line and leaves room for pedestrians when you add a separate pedestrian gate alongside.
Swing Gate Installation
For gated communities off Gateway Boulevard and the older riverfront enclaves along the Caloosahatchee, swing gates remain the standard. The catch in Fort Myers is matching HOA specs: specific picket spacing, specific finish, specific hinge style. We order panels that match the board’s approved design rather than showing up with whatever the supplier had on the truck. If your double swing gate sags in the middle, we’ll check the hinge posts before we blame the gate.
Pedestrian Gate Installation
A pedestrian gate has to do two jobs in Fort Myers: match the driveway gate and keep working while the big gate is down. We install pedestrian gates with their own post footings independent of the vehicle gate, so you can lock the driveway gate for the night and still get in and out on foot. With a keyed lock or a standalone keypad, your pedestrian gate doesn’t depend on the operator that just got flooded.
Security Gate Installation
A security gate in Fort Myers usually combines a heavier steel frame with an operator, a keypad or intercom, and UL 325 entrapment protection like photo eyes and reversing edges. The HOA will want to see the entrapment protection, and Florida building code requires it on new and replacement installations. We wire protective loops and photo eyes at the correct heights, dial in the close force, and leave you with the manual release instructions in the same folder as the written warranty.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Fort Myers
We’re certified to service and install nine major gate brands, including LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. In Fort Myers specifically, we keep parts in the truck for the operators we see most: FAAC swing operators in the older river communities, BFT slide operators in the Gateway area, and Linear and LiftMaster units in the 1990s and 2000s subdivisions. That means when we’re working in 33913 and find a failed logic board on a 2005 Linear, we often have the replacement board on hand rather than ordering it from a distributor in Tampa and making you wait a week. Check out our full Gate Installation capabilities if you’re comparing us with other shops.
Common Gate Installation Problems We See in Fort Myers Homes
- HOA appearance covenants and exact-match requirements: A lot of Fort Myers gate replacements get flagged because the new panel is close but not exact. The board approved one picket profile and one powder-coat finish, and if you install something else, the violation letter shows up and the gate has to come back off. We pull the spec sheet before we order.
- Post-Ian corrosion in buried conduit and bottom rollers: Storm surge and standing floodwater got into a lot of gate electrical, especially in lower-lying parts of 33916 and 33966. A new operator wired into an old flooded conduit can fail within months. When we trench new conduit, we’re installing something built for the next storm, not just the last one.
- Tight working space at shared driveway entrances: Twin-home and villa communities in Cypress Lake and Villas often have shared driveway aprons with little room to swing a gate without hitting a car or a wall. Slide gate installations solve the space problem, but the track has to be absolutely level on the existing pillar. If it’s not shimmed right, the gate binds and the operator burns out early.
- Old masonry pillars that need non-standard hardware: Older neighborhoods near downtown Fort Myers, around 33901, have 1950s through 1970s brick pillars that were never built for modern gate hardware. Standard hinge plates don’t fit, and the local suppliers don’t stock what’s needed. We cut and weld brackets on site rather than chipping the pillar apart and starting over.
Pricing for Gate Installation in Fort Myers, FL
In Fort Myers, a basic single swing gate on existing pillars runs about $1,400 to $2,600. A double driveway swing gate with new posts and an operator lands closer to $4,000 to $6,800. Sliding gates run $2,800 to $5,500 installed, depending on the track length and whether we’re cutting into the driveway or setting a new foundation. Pedestrian gates are the most affordable, usually $900 to $2,200. The biggest cost drivers are pillar condition, operator choice, and whether we have to trench new electrical. Every quote is written out beforehand, agreed to before we start, and backed by the 90-Day Done Right Promise: if it’s not done right, we make it right. Call (877) 610-2993 for a free, no-trip-charge estimate inside the county.
Gate Installation in Fort Myers: Built for HOA Rules and Hurricane Season
Fort Myers is the densest concentration of HOA-governed gated communities in Southwest Florida. From the master-planned corridors of Gateway in 33913 to the Colonial Boulevard neighborhoods in 33912 and the waterfront enclaves along the Caloosahatchee, nearly every gate replacement here has to clear an architectural review board first. Those covenants dictate gate style, color, hardware, and sometimes even the operator brand. If the spec says black-oxide hardware and a matte bronze panel, that’s what goes in. We don’t fight the board; we read the spec and build to it.
Then Hurricane Ian made a Category 4 landfall directly on the Fort Myers coastline in September 2022. Thousands of gate systems were destroyed or badly warped, and the replacement cycle is still running. Layer the Gulf-coast salt air on top of that, and you have a market where the failure mode is predictable: motors and control boards oxidize faster here than in inland Florida, and post-Ian conduit damage keeps showing up as operator failures months after the visible damage was repaired. For more context on how we serve this area, see our Gate Installation in Fort Myers page.
In Gateway, we recently replaced a worn LiftMaster slide gate operator and corroded bottom rollers on a sub-association entry gate. Because scores of nearby gates were installed in the same 2000s construction wave with nearly identical LiftMaster and Linear operators, we stocked the matching logic board and drive gear SKUs. That let us clear four additional service calls in the same ZIP that day. We kept the gate in manual mode with a temporary keypad entry while we poured a new post footing, so vehicle access never stopped during the work.
We Also Serve Cities Near Fort Myers
Our crews cover Fort Myers and the surrounding communities, including Villas, Cypress Lake, McGregor, and Iona. If you’re just outside the city limits and wondering whether we make the drive, the answer is yes. No trip charge inside Lee County, and the same written quote process applies no matter which side of the river you’re on.
Serving Fort Myers, FL - Our Local Coverage Area
We’re based in the Fort Myers area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Fort Myers
No, and we won’t try to convince you otherwise. If the HOA covenants for your community restrict gate types to swing gates, installing a slide gate would put you in front of a violation notice and likely force removal and reinstallation. What we do is check the actual covenant language with you. Some communities restrict only the street-facing appearance, not the back or side entry. If a slide gate truly is prohibited, we’ll size a swing gate that fits your setback or talk to the board about a variance. Call (877) 610-2993 and we’ll help you read the covenant before you spend a dollar.
We set up a temporary pedestrian route with a standalone gate or a manual keypad entry before we take the main gate down. During the Gateway job, we kept the vehicle gate in manual mode with a temporary keypad while the new post footing cured. Your neighbors still reach the mail kiosk, and the community still has access. We never leave a Fort Myers community without a working entry point.
Yes, and Florida building code requires it regardless of HOA language. UL 325 entrapment protection, meaning photo eyes, reversing edges, and close-force limits, is mandatory on new and replacement gate installations. Your HOA may also specifically require it in their architectural guidelines. We install entrapment protection on every automatic gate we put in, no exceptions. If your board asks for documentation, we leave the UL 325 compliance sheet with the rest of your paperwork.
Salt air corrosion, standing water, and post-Ian conduit damage are the three big reasons. Fort Myers sits on the Gulf with 56-plus inches of annual rainfall concentrated from June through September. Control boards, motor windings, and hinge bearings oxidize faster here than they do 30 miles inland. After Ian, storm surge pushed saltwater into buried conduit runs that were never designed to stay submerged. A new operator wired into that old circuit will fail within months. We replace damaged conduit before we install the new operator.
Yes. We pull the approved spec sheet from your community’s architectural guidelines before ordering any panel. That means matching the picket profile, the powder-coat finish, and the hinge style your board approved. If the original supplier went out of business, we match the finish from a physical sample, not a catalog photo. Fort Myers HOAs reject replacements over one shade of difference. We’re not going to let that happen to you. Call (877) 610-2993 for a free estimate and we’ll bring the spec sheet to the first visit.
Call Gatewood Fence & Gate for Gate Installation in Fort Myers
If you need a gate installed, replaced, or matched to HOA spec in Fort Myers, call (877) 610-2993. You’ll get Hal or a member of his crew on the phone, a free estimate with the numbers on paper, and a written 90-Day Done Right Promise before we start. No trip charge inside Lee County. $40 off any repair over $200. A permanent 10% discount for seniors and veterans. We’ll measure the site, check the covenants, and hand you a quote that doesn’t change at the door. The name is on the shop, and the shop is just a phone call away.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Fort Myers with on-site welding and owner-operated accountability since 2001.