Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Brookhaven
Gate installation in Brookhaven’s 30319 ZIP comes down to one thing most of the time: picking a company that understands tight lots, shared driveways, and what Georgia red clay does to a gate post. We know this because we have been digging footings and welding hinges in these neighborhoods since long before the teardown boom started packing automated gates onto every new-construction infill lot. A driveway gate on a Drew Valley or Ashford Park property is not a generic project. The clearances are tight, the soil moves, and a gate that fights the ground from day one will fail early. That is why Hal Gatewood runs every Brookhaven job the same way he has since 2001: show up, look at the actual site, quote a written price, and stand behind the work with the 90-Day Done Right Promise. Call (877) 610-2993 and a live person answers, any hour.
Why Gatewood Fence & Gate Is Brookhaven’s Preferred Gate Installation Company
We are locally owned and owner-operated, and Hal Gatewood’s name is on the shop and on every invoice. That matters in Brookhaven because most of the automated driveway gates going in on post-2012 infill lots were installed by general contractors rushing a build, not by a gate specialist. We get called to correct those. A gate sags in the hinge post, not in the middle, and that is where we start. We fix the panel without the post and you will fix it twice.
Brookhaven homeowners call us because the person who answers the phone knows the difference between a swing gate on a ranch off Peachtree and a slide gate squeezed onto a Drew Valley infill lot. Our crew has pulled up to hundreds of these properties. We carry parts for the brands installed most around here, and we weld on site instead of hauling your gate to a shop. You will see the same face at the hardware store later. That is the oldest accountability there is.
Every Brookhaven job carries the 90-Day Done Right Promise in writing. Not “up to” anything, not fine print. If it is not done right, one call brings Hal back. We also honor standing offers that do not require haggling: $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans.
Key Takeaways for Brookhaven Homeowners
- A typical driveway gate installation in Brookhaven runs $2,800-$6,500 depending on gate type, operator, and site prep.
- Slide gates on tight Ashford Park and Drew Valley infill lots require proper rack clearance or the track chokes with red clay mud and mulch.
- Post footings in 30319 must account for Georgia Piedmont shrink-swell clay, or a swing gate will pull out of plumb within a few years.
- We answer the phone with a live person, 24/7. Not a voicemail, not a call center.
Our Gate Installation Services in Brookhaven
We install and service the full range of residential and light-commercial gates across Brookhaven. That includes the sub-services most common in 30319: driveway gates, pedestrian gates, sliding gates, swing gates, double gates, and security gates. Here is how each one plays out on Brookhaven lots specifically.
Driveway Gate Installation in Brookhaven
A driveway gate in Brookhaven is usually an automated swing or slide gate on a new-construction infill lot, often with shared driveway access to negotiate. We design the layout so the gate opens without swinging over a neighbor’s curb cut or blocking a sidewalk. On lots where a swing gate simply will not fit against the property line, we recommend a slide gate with proper clearance for drainage and debris. A typical automated driveway gate installation in Brookhaven runs $3,500-$6,500 including the operator, because the site prep and power run usually cost more than the gate itself.
Pedestrian Gate Installation in Brookhaven
Pedestrian gates in Brookhaven appear on both ends of the housing stock. Older 1950s-1970s ranches and cape cods sometimes still have original ornamental wrought-iron entry gates with manual latches and corroded hinges. Newer homes get matching pedestrian gates beside an automated driveway gate, often with electronic locks tied to the same access control. A pedestrian gate install typically runs $800-$2,200 in Brookhaven, depending on materials and whether it needs its own post footings.
Sliding Gate Installation in Brookhaven
Sliding gates are the default choice on Brookhaven’s narrow infill lots, particularly in Ashford Park and Drew Valley where new construction sits nearly to the lot line and driveway depth is minimal. The failure pattern we see most in these neighborhoods is a slide gate track that chokes on Georgia red clay mud and landscape mulch, which binds the rollers and burns out the rack-and-pinion motor seasonally. We install slide gates with raised track systems or cantilever designs where possible, and we set the rack clearance to shed debris rather than trap it. A sliding gate installation in Brookhaven typically runs $3,800-$7,000 depending on gate width, track style, and operator.
Swing Gate Installation in Brookhaven
Swing gates remain popular on Brookhaven properties with enough setback, especially double swing gates across a wider driveway. The local challenge is the soil. Post footings set in shrink-swell Piedmont clay shift enough to pull swing-gate hinges out of plumb within a few years, which stresses the operator and cracks welds. We dig deeper footings than code minimums, use heavyweight gate hinges with adjustability built in, and weld the hinge points on site. A single swing gate installation in Brookhaven runs $2,800-$5,200; a double swing gate runs $4,500-$8,000 depending on size and operator.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Brookhaven
Brookhaven homes run a mix of operator brands depending on who did the original install. We service and install nine major gate brands, and we stock the parts Brookhaven customers need most often: FAAC operators, BFT control boards, Linear actuators, and Viking gate motors. That local parts inventory means a repair in 30319 often gets done the same day, because we are not waiting on a shipment from somewhere else. If your current gate runs one of these brands and is acting up, call (877) 610-2993 and describe what it is doing. Hal will tell you straight whether it is worth fixing.
Common Gate Installation Problems We See in Brookhaven Homes
We see the same failure patterns repeat across Brookhaven because they are tied to the local soil, the housing stock, and the way the teardown boom packed new homes onto small lots. Here is what we run into most:
- Slide-gate tracks clogged with red clay and mulch. On tight infill lots in Ashford Park and Drew Valley, landscape mulch and Georgia red clay mud wash onto the track every rain. The gate binds, the motor strains, and the operator burns out far faster than it should. We set tracks with drainage clearance and recommend annual track cleaning.
- Post footings that shift with shrink-swell clay. Brookhaven’s Piedmont soil expands in wet winters and contracts in summer drought. That movement pulls swing-gate posts out of plumb, opening the gap at the hinge side and cracking welds. We dig footings below the active shrink-swell zone and use concrete that can take the movement.
- Freeze-thaw cracks on older ornamental iron gates. Brookhaven gets ice storms rather than sustained freezes, and the rapid freeze-thaw cycle cracks powder-coat finishes and seizes hinge pins on legacy wrought-iron gates from the 1950s-1970s homes. We reweld and refinish those rather than replacing them when possible.
- Wrong gate type for the lot geometry. General contractors sometimes install a swing gate where a slide gate was the only thing that could physically work on a narrow infill driveway. The gate never operates right and the posts take constant stress. We evaluate the actual site and recommend the gate type that fits the space, not the one that was easiest to order.
Pricing for Gate Installation in Brookhaven, GA
Gate installation in Brookhaven is priced by what the site actually requires, and we quote it in writing before any work starts. The gate itself is usually the smaller part of the bill. Site prep, post footings, the power run to the operator, and safety devices add up fast in 30319 because terrain and lot geometry vary block to block. Here is what we see across Brookhaven:
| Installation Type | Typical Brookhaven Range |
|---|---|
| Pedestrian gate | $800 - $2,200 |
| Single swing driveway gate (manual) | $2,300 - $4,000 |
| Single swing driveway gate (automated) | $2,800 - $5,200 |
| Double swing driveway gate (automated) | $4,500 - $8,000 |
| Sliding driveway gate (automated) | $3,800 - $7,000 |
These ranges include the gate, operator where applicable, footings, hardware, and standard safety devices. Power runs over long distances, access control integration, and site conditions that require extra concrete or drainage work add to the total. The price is quoted and agreed before any work starts, so the invoice matches the estimate. Call (877) 610-2993 for a free measure and a written quote. Estimates are free, and we will give you a straight answer on whether your existing gate is worth repairing.
We Also Serve Cities Near Brookhaven
While this page is focused on Gate Installation in Brookhaven, our crew regularly works in North Atlanta, Chamblee, Doraville, and North Druid Hills. Many of these neighborhoods share the same red clay soil and aging housing stock, which means the same local expertise applies. If you are in one of these nearby areas, give us a call and we will schedule a measure. Our Gate Installation team covers the whole corridor.
Serving Brookhaven, GA - Our Local Coverage Area
We’re based in the Brookhaven area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Brookhaven
Slide gates in those two Brookhaven neighborhoods clog with Georgia red clay mud and landscape mulch faster than in Chamblee because the infill lots are so tight that driveways sit close to planted beds and drainage is minimal. Every rain washes sediment onto the track, the rollers bind, and the motor strains. In Chamblee, lots tend to have more setback and less new-construction landscaping pressed against the gate line. We install slide gates in Ashford Park and Drew Valley with raised tracks or cantilever designs and set rack clearance to shed debris. If your gate is already binding, call (877) 610-2993 and we will come look at it. The trip charge inside the county is waived.
Yes. Shared driveways in Brookhaven are common on older properties and on new infill lots where two homes share one curb cut. We install the gate so the full opening is available to both properties, typically with a slide gate or a double swing gate matched to the driveway width, and we set the operator with separate remotes or keypads for each household if needed. The key is positioning the gate inside the property line rather than at the street so it never swings over a neighbor’s access. We also coordinate with both property owners before the install so nobody’s access changes without them knowing. Call (877) 610-2993 for a free site measure and we will walk you through the layout.
Any new automatic gate in Brookhaven must meet UL 325 entrapment protection standards, which require at least two independent means of protection: a reverse-sensing mechanism on the operator and an external monitored device such as photo eyes or a contact edge. In practice, every automated gate we install in 30319 gets a primary entrapment protection device and a secondary one, because we treat UL 325 as the floor, not the ceiling. On the Drew Valley slide gate we just replaced, we angled the photocell pair to survive yard maintenance equipment passing by, because a knocked-out photo eye is a gate that will not close. We test every device before we leave. If you have questions about a specific gate, call (877) 610-2993 and ask for Hal.
We dig post footings below the active shrink-swell zone of Brookhaven’s Piedmont clay, which means deeper than typical code minimums, and we use heavyweight adjustable hinges welded on site rather than bolted plates. The post carries the gate; the hinges carry the adjustment. Where a driveway has a slope or poor drainage near the post, we add a concrete collar or drainage relief so water does not pool around the footing and accelerate movement. A swing gate that is properly footed and hinged for Brookhaven soil will hold its line for years. If yours is already sagging, we usually reset the post and reweld the hinges rather than replace the gate.
Yes. On Brookhaven properties where the driveway is far from the home’s electrical panel, or where trenching across landscaped beds or hardscape would tear up the yard, a solar gate operator is often the smarter install. We install solar-ready operators from FAAC, BFT, and Viking with properly sized panels and battery backup, and we size the system to the gate’s daily cycle count so it does not die on cloudy winter days. Solar works best on single and double swing gates with moderate use; on a heavy slide gate that cycles many times a day, a hardwired power run is more reliable. We will tell you which one makes sense for your site. Call (877) 610-2993 for a free measure and we will price both options in writing.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Brookhaven since 2001.