Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Bee Cave
Gate installation in Bee Cave runs $2,400-$9,800 for most automated driveway gates, and the work usually takes two to five days once materials land. We know that range because we’ve been installing swing gates, sliding gates, and pedestrian gates across the 78738 ZIP since Hal Gatewood put his name on the shop in 2001. If you’re on Falconhead West, Ladera, or Lake Pointe, you already know the first thing that has to happen is architectural review: no approved application, no gate, and skipping that step leaves you with fines even if the work itself is perfect. Call (877) 610-2993 and we’ll walk you through the approval process before we ever set a post.
Why Gatewood Fence & Gate Is Bee Cave’s Preferred Gate Installation Company
We’re the shop that answers the phone with a live person at 2 a.m. when a gate motor gives out during a Hill Country storm. No voicemail. No call center. Hal Gatewood’s name is on every invoice, and his published address means you can drive over and look him in the eye if you want. Bee Cave homeowners keep our number in their phone because when a gate sags or a motor burns up, we come out, find what’s actually failing, and fix that instead of swapping parts that were never the problem.
Our crew works Bee Cave neighborhoods every week. We know the Falconhead driveways, the Ladera slopes, the Uplands cul-de-sacs. We know which HOA management companies want the architectural form before a single wrench turns, and we keep their contact sheets in the truck. When we quote a job on Lake Pointe or in the Barton Creek corridor, we are not guessing at the rules. We’ve done it before, on your street or the one behind you.
And we back everything with a written 90-Day Done Right Promise. If it isn’t right, one call brings us back. No runaround, no fine print.
Our Gate Installation Services in Bee Cave
Driveway Gate Installation
Most Bee Cave homes were built between 2003 and 2018 on lots with long private driveways, which is why automated driveway gates are the rule here, not the exception. We install single and double driveway gates on original posts, on new posts, and in redesigns that change a wide open entrance into something you control. In communities like Lake Pointe, the gate panel has to match the architectural character of the house, which means custom pickets, specific finishes, and sometimes a mockup before the steel gets cut.
Swing Gate Installation
Swing gates are the most common style in Bee Cave, and they are also the one that fights the ground the hardest. The limestone and clay soils under the 78738 ZIP heave with wet winters and settle with dry Julys, and a gate post that moves a quarter inch knocks the whole gate out of alignment. We set posts below the local frost line and brace them for the soil we actually have here, not the soil a generic installer assumes. Swing gates on long Falconhead driveways also need the right hinges for the panel weight, which is often heavier than a spec sheet says once wrought-iron pickets and hardware are on.
Sliding Gate Installation
A sliding gate makes sense on a Hill Country slope where a swing arc would clip the grade or the drive itself. Sliding gates need a clean, level track run and a heavy post at each end to carry the rolling weight. On Bee Cave lots where the drive pitches toward a creek or a drainage swale, we pour a track bed that won’t wash out in a flash-flood event. We’ve seen track beds from other installers sitting half-empty after one Barton Creek storm season, and we don’t do that kind of work.
Pedestrian Gate Installation
Pedestrian gates are what you actually use every day when the driveway gate stays shut. We build them to match the driveway gate in finish, picket style, and hardware so the whole entry reads as one piece. In Bee Cave HOAs, the pedestrian gate is often the one a board member walks up and judges with a tape measure, so we keep the reveal height and spacing inside the covenant before we order steel.
If you’re replacing an operator rather than the gate itself, our Gate Installation team handles the full scope: panel, posts, motor, safety edges, and access control. One call covers all of it.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Bee Cave
We install and service operators from LiftMaster, Linear, Viking, Ghost Controls, DoorKing, and more. For Bee Cave homes, the brand decision is often not yours alone: a Falconhead West or Ladera HOA may have an approved operator list, and your architectural application needs the brand name on it. We stock common parts for Linear and LiftMaster operators locally, which means a failed board or a burned transformer can often be fixed the same day instead of waiting a week on a ground shipment. When you call, we can tell you what we have on hand for your specific model.
Common Gate Installation Problems We See in Bee Cave Homes
- HOA approval skipped. We replace a fair number of brand-new gate operators in Falconhead West and Ladera because someone installed one without architectural review and the board made them pull it. The fines and the rework cost more than the gate. We pull the approval before the work, not after.
- Posts heaving out of plumb. The limestone and clay soils in this part of Bee Cave move with every wet-dry cycle, and a post that wasn’t set deep or braced properly will lean inside of two years. A swing gate that dragged the ground or won’t latch is usually a post problem, not a panel problem. Fix the post and you fix the gate.
- Flash-flood damage to operators and wiring. Plenty of Bee Cave driveways sit near a Barton Creek tributary or a low drainage swale, and when a Hill Country storm parks itself over the Edwards Plateau, water moves fast. Underground wiring gets shorted, and operators in low spots get drowned. We install operators above local flood level where the site allows and run conduit that sheds water instead of holding it.
- Undersized operators on big panels. Some original installations on 2005-2010 era Bee Cave homes had operators that were marginal on day one. Ten years on, the bearings are tired and the panel is heavier than anyone planned for. We size the replacement operator for the actual measured weight of the gate, not the brochure spec, and we test the full travel before we leave.
Pricing for Gate Installation in Bee Cave, TX
Here’s what we see across the 78738 ZIP. A single swing gate with a basic operator on existing posts runs $2,400-$4,200. A double swing gate on new posts with custom finish work runs $4,800-$7,900. A sliding gate with track, posts, and operator runs $3,800-$6,500. A pedestrian gate matching the driveway panel runs $900-$2,800. If you need the power run extended to the gate, add $400-$1,800 depending on distance and trenching. These ranges reflect Bee Cave’s reality: HOA custom finishes, Hill Country soil work, and operators sized for heavy panels.
We quote a written price before any work starts and we don’t change it at the door. You get the number in writing, and the number on the invoice matches. Call (877) 610-2993 for a free measure and a written estimate. Seniors and veterans always get 10% off, and if you already have a written estimate from another company, we’ll give you a free second opinion on it.
We Also Serve Cities Near Bee Cave
We work in Bee Cave every week, and we run the same crews to Lakeway, Lago Vista, Shady Hollow, and Austin. If you’re just outside the 78738 line, call us anyway – if we can’t get to you fast, we’ll tell you straight and point you to someone who can.
Serving Bee Cave, TX - Our Local Coverage Area
We’re based in the Bee Cave area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Bee Cave
Yes. Falconhead West’s architectural review process applies to operator brand changes and finish color changes, not just new gates. If you swap a LiftMaster for a Viking without approval, the board can fine you and require removal even if the install itself is flawless. We submit the architectural request for you, with the operator spec and finish sample the committee needs, and we build the lead time into our schedule so you’re not stuck waiting on a form to clear. Call (877) 610-2993 and we’ll check the current Falconhead West requirement for your exact scope.
Bee Cave sits on expansive limestone and clay that swells when it’s wet and contracts when it’s dry, and that cycle moves posts seasonally. A swing gate is a long lever, so a half inch of post movement at the ground becomes several inches of gate sag at the latch end. For a new install we set posts below the local shrink-swell depth and brace the hinge post for the panel weight plus a safety margin, because a hinge post that stays true is what keeps the gate closing like it should.
Yes. Barton Creek and its tributaries run right through the 78738 ZIP, and a fast storm coming off the Edwards Plateau can push water over driveways and into low-lying gate equipment. An operator that sits in a swale or a wiring conduit that wasn’t sealed will drown. We position operators above observed flood flow where the site allows, seal conduit joints, and use operators rated for outdoor exposure. If your lot is in a known low spot, say so when you call and we’ll plan for it.
UL 325 is the safety standard that governs automatic gate operators, and it has applied to every operator we’ve installed since the standard was adopted. It requires external entrapment protection: a monitored safety edge or a non-contact sensor like a photocell, plus secondary entrapment detection at the motor. A compliant Bee Cave install includes the safety edges or photocells, correct installation of the controls, and a test cycle on both the open and close travel before we call it done. If a new gate doesn’t have that, it isn’t done right.
Solar can work in Ladera, but it depends on how shaded the panel site is and how many cycles a day the gate runs. A long driveway gate that opens six or eight times a day needs a properly sized panel and battery bank, and a heavily treed Ladera lot can leave a solar panel starving for light in winter. We can survey the panel site and give you a straight answer on whether solar makes sense or whether it’s worth running power. Call (877) 610-2993 and we’ll check your specific lot before you spend a dollar.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate. Hal founded Gatewood Fence & Gate in 2001 and has been installing and repairing gates across Central Texas since then. His name is on the shop, his address is published, and he still answers the phone.