Ghost Controls Gate Motor & Opener Nationwide | Gatewood Fence & Gate

Ghost Controls Gate Motor & Opener in Los Angeles: What to Know First

Ghost Controls gate motor repair and installation in Los Angeles is something we handle regularly, usually same-day or next-day depending on the failure. A typical Ghost Controls opener repair runs $185 to $420, while a full motor replacement generally lands between $680 and $1,250 installed. The price is quoted and agreed before we touch anything, so what we say on the phone is what you pay when the job is done.

Call (877) 610-2993

This page is for Los Angeles homeowners who own a Ghost Controls opener and want someone who actually knows the brand, not a technician reading a manual for the first time in your driveway. Call (877) 610-2993 and you’ll get a live person, day or night. Hal Gatewood has been working gates around this city since 2001, and Ghost Controls is one of nine brands we service regularly.

How Ghost Controls Products Fail and How We Fix Them

Ghost Controls makes a solid residential opener, but we see the same handful of failures across Los Angeles neighborhoods from Encino to Pasadena. Here is what actually goes wrong and what we do about it.

• AXDP and AXP series battery drain after Santa Ana wind events. When those hot, dry winds kick up dust and debris, the safety sensor eyes get coated or knocked slightly out of alignment. The opener responds by cycling more often, which drains the 12V battery faster than the trickle charger can recover. We clean and realign the sensors, then load-test the battery under load. Most of the time the battery is fine once the eyes are right.
• Limit switch drift on the GHDP and GHP series after ground movement. Los Angeles clay soil expands and contracts with rain and drought. A gate post that shifts even half an inch changes where the gate stops every cycle. The opener keeps hunting for the limit, which burns motors and strips the plastic worm gear. We reset the limits only after checking the post, because a limit reset on a shifting post is a repair you’ll pay for twice.
• Receiver board failures from power surges on older AXD models. We’re in a city with old transformers and frequent brownouts. Ghost Controls boards on units without a surge protector take the hit, and the remote stops talking to the opener. We inspect the board for scorched traces, replace it with OEM Ghost Controls parts when the unit is under warranty, and install an inline surge protector so it doesn’t happen again.
• Arm bracket bolts backing out on the swing-arm kits. Ghost Controls swing arms use a hardened bolt through an aluminum bracket, and over a few thousand cycles that bolt walks loose. The arm then slaps against the bracket and eventually cracks it. We re-torque with thread locker and replace the bracket if it’s already stressed. It’s a fifteen-minute fix that prevents a $200 part failure.
• Water intrusion into the control box on aftermarket installations. We see a lot of Ghost Controls openers installed by handymen who didn’t seal the conduit entry. Rain gets in, the board corrodes, and the customer is told they need a whole new opener. We open the box, clean the corrosion, replace what’s actually failed, and seal the entry properly with a drip loop.

One thing worth knowing: Ghost Controls parts are not always stocked at Los Angeles supply houses. We keep the common failure parts on the truck, because driving across the Valley to hunt for a limit switch wastes your afternoon and ours.

Our Ghost Controls Gate Motor & Opener Process

Here is how a Ghost Controls job goes from your call to the gate working right.

1. 1
   You call, a person answers. Not a voicemail, not a phone tree. We ask what the gate is doing, what model opener you have if you know it, and when you need us there.
2. 2
   We arrive and diagnose in the driveway. Hal or one of his crew checks the arm geometry, the limits, the battery voltage, the sensor alignment, and the board. We figure out what failed and why, not just what part to swap.
3. 3
   You get a firm price before we start. We tell you exactly what it costs, whether it’s a $40 bracket fix or a full motor swap. You say yes, then we work.
4. 4
   We repair in place. On-site work means your gate stays in your driveway. We carry OEM Ghost Controls parts and proven aftermarket equivalents where they make sense. We don’t haul your gate off unless welding requires it, and even that happens in your driveway.
5. 5
   We test under load, not just on a bench. The gate cycles ten times with weight on it. We check the auto-close timing, the obstacle reversal, and the safety edges. If the opener fights the gate at any point, we find the bind and fix it.
6. 6
   You get the 90-Day Done Right Promise in writing. If something isn’t right within 90 days, one call brings us back. No runaround, no re-quote.

What Ghost Controls Gate Motor & Opener Costs in Los Angeles

Here are the numbers we actually quote on Ghost Controls work around Los Angeles. These are installed prices with labor included, not parts-only figures.

• Sensor realignment and cleaning: $85 to $145. Usually same-day.
• Limit switch adjustment and recalibration: $120 to $190.
• Receiver board replacement (OEM): $210 to $340 depending on the model.
• Battery replacement and load test: $140 to $220 installed.
• Full opener motor replacement: $680 to $1,250 depending on the Ghost Controls model and whether the arm, brackets, or wire need replacing too.
• Complete new Ghost Controls installation with new gate: $2,400 to $4,800, measured and scheduled, not a same-day job.

What moves the price: whether the post is still solid, how far the gate traveled before it died, and whether the previous installer left us a mess to undo. We quote it all upfront. Call (877) 610-2993 for an exact number, and remember the estimate is free, with no trip charge inside the county.

Why Los Angeles Homeowners Call Gatewood Fence & Gate for Ghost Controls Work

We’re not the biggest gate company in Los Angeles, and we don’t want to be. We’re the one where the owner’s name is on the shop and the shop is down the road, not in a different state. Hal Gatewood has been fixing gates since 2001, and if you call, the person who picks up is someone who can actually answer your question.

Every Ghost Controls job carries the 90-Day Done Right Promise in writing. No fine print, no “in most cases.” We also service LiftMaster, Mighty Mule, and DoorKing, so if your Ghost Controls opener is truly at the end of its life and you want to switch brands, we can talk you through what that actually costs and whether it’s worth it. We’ll tell you straight if the repair is the better money.

For over 29 years we’ve served Los Angeles homeowners with a published address, a license number anyone can look up, and standing offers that don’t require haggling: $40 off any repair over $200, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. The name is on the shop. That’s the oldest accountability there is.

FAQs