Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Oxnard
Gate repair in Oxnard usually costs between $160 and $520 for hinge and post work, $240 to $680 for electric opener repair, and $300 to $900 for weld and rust repair on ornamental iron. Most jobs on our side of Oxnard are done the same day we look at them, and no crew leaves a gate that won’t close and lock. If you’re in Hollywood Beach, Oxnard Shores, central Oxnard, or out toward the Oxnard Plain, call (877) 610-2993 and a live person picks up. Not a phone tree. Hal Gatewood has been fixing gates since 2001, and the name on the invoice is the guy who shows up.
Key Takeaways:
- Same-day service across Oxnard for most hinge, latch, and opener failures.
- On-site welding means your gate gets fixed in your driveway, not hauled to a shop.
- Free estimates, upfront pricing, and the 90-Day Done Right Promise in writing.
- Marine-grade hardware is standard on every job near the 93035 coastal zone.
Why Gatewood Fence & Gate Is Oxnard’s Preferred Gate Repair Company
We’ve pulled up to enough Oxnard driveways to know what the marine layer does to a hinge pin. Hollywood Beach and Oxnard Shores salt air corrodes iron faster than almost anywhere else in Ventura County, and central Oxnard’s older tract homes carry gates that were hung in the 1960s and haven’t been touched since. That local knowledge means we start every job by looking at the post, not the panel. A gate sags in the hinge post, not in the middle, and that’s where we start.
Hal Gatewood is owner-operated, locally owned, with a published address and a license number anyone can look up. Calls are answered by a live person around the clock, seven days a week. When you call about a gate dragging on concrete in El Rio or an opener that reverses in RiverPark, you talk to a person who knows the territory. The person who shows up is background-checked, uniformed, and works for Hal, not a subcontractor passing through.
We’ve been at this since 2001, and the 90-Day Done Right Promise is stamped in writing on every job. If it’s not done right, one call brings us back. No fine print, no “in most cases.”
Our Gate Repair Services in Oxnard
Electric Gate Repair
Electric gate repair in Oxnard means dealing with operators that have been breathing salt air. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, and we stock boards, arms, and capacitors for the brands Oxnard homeowners actually have. A gate that opens a few inches and reverses is usually a safety sensor seeing something that isn’t there, or a board that’s been infiltrated by salt fog. We diagnose on-site, quote the repair before any work starts, and stand behind it.
Automatic Gate Repair
Automatic gate operators along the 93035 corridor fail early. Salt gets into the housing, corrodes wire terminals, and trips safety photocells. Out in the agricultural flatlands, operators on farm gates deal with dust and wide spans instead of salt, and they need a different setup entirely. We repair the operator, the loop detector, the safety edges, and the wiring run, and we’ll tell you plainly if an operator is worth repairing or should be replaced. You’ll get that opinion from someone who welds on site.
Hinge & Post Repair
The hinge post is where most Oxnard gate problems begin. In older central neighborhoods and along the coast, rust seizes the hinge pin until the gate binds, then the post starts leaning and the gate drags on the driveway. We reset posts in concrete, weld new hinge barrels, and realign the gate so it swings true. Fix the panel without the post and you’ll fix it twice. We’d rather fix it once and see you at the hardware store as a neighbor, not as a callback.
Gate Realignment
Gates drag, bind, and fail to latch when the weight shifts off the hinge line. That happens fast in Oxnard because the soil under older posts settles, and because wide farm gates on the Oxnard Plain were often hung on posts that were never set deep enough for the span. We cut, rehang, shim, and weld until the gate closes with two fingers. If rust has eaten the frame at the welds, we address that before we realign, so you’re not paying for alignment on a frame that’s about to fail.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Oxnard
We service and stock parts for nine major gate brands, and in Oxnard we keep Viking, Ghost Controls, and DoorKing components on hand because that’s what the coastal and acreage properties run. If your opener is a Ghost Controls arm on a solar battery bank out past Hueneme Road, or a Viking slide operator on a Harbor property, we’ve got the parts and we know how the salt affects them. We don’t make you wait two weeks for a board to ship from a warehouse in another state. We either have it locally or we tell you exactly when it lands, before you pay anything.
Common Gate Repair Problems We See in Oxnard Homes
- Salt-seized hinges in beachfront zones. In 93035, the marine layer deposits salt on hinge pins and weld points daily. Hinges that would spin for a decade in Camarillo seize up in two or three years in Hollywood Beach.
- Circuit board corrosion in automatic operators. Salt fog wicks into control boards and corrodes terminals, causing phantom reversals, dead keypads, and safety sensor trips. Coastal Oxnard sees this failure earlier than any inland Ventura County city.
- Sagging wide-span farm gates. On the Oxnard Plain, field gates and acreage entrances sag because the hinge post was undersized or set too shallow for the soil and the span. The panel bends, the latch misses, and the operator strains until it eats a gear.
- Rust-through on ornamental iron. Channel Islands Harbor waterfront properties run ornamental iron gates that look fine on the outside but rot from the inside at the frame welds. By the time you see rust bubbling the paint, the steel underneath is already failing.
Pricing for Gate Repair in Oxnard, CA
What you pay in Oxnard depends on what failed and where it lives. These are honest ranges for our market, and the price is quoted and agreed before any work starts, never after.
| Repair Type | Typical Oxnard Range |
|---|---|
| Hinge replacement and post reset | $160 - $420 |
| Electric opener repair (board, sensor, wiring) | $240 - $680 |
| Gate realignment | $180 - $450 |
| Weld and rust repair on ornamental iron | $300 - $900 |
| Full operator replacement with marine-grade hardware | $1,200 - $3,400 |
There’s no trip charge inside the county, and you get $40 off any repair over $200 as a standard offer, no haggling. A permanent 10% discount applies for seniors and veterans. Call (877) 610-2993 for a free estimate, and you’ll get a number you can hold us to.
We Also Serve Cities Near Oxnard
Our Gate Repair team works all over Oxnard, and we regularly run calls to Port Hueneme, El Rio, Camarillo, and Ventura. If you’re just outside the city line, call anyway. We’re already on the road, and the same local pricing and 90-Day Done Right Promise apply across the whole area. See our Gate Repair in Oxnard page for more on coverage.
Serving Oxnard, CA - Our Local Coverage Area
We’re based in the Oxnard area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Oxnard
Hollywood Beach sits directly on the Pacific, and the daily marine layer carries salt that settles on hinge pins and weld points. Salt-laden moisture accelerates corrosion fast enough that a wrought iron hinge that lasts a decade in Camarillo seizes and binds in two to three years in the 93035 zone. The fix is marine-grade stainless hardware and powder-coated frames, which is what we spec on every coastal Oxnard job. Call (877) 610-2993 and we’ll tell you if your current hardware is worth saving or needs an upgrade.
Yes, we install solar-powered gate openers on Oxnard Plain acreage where running mains power is impractical or cost-prohibitive. A solar opener with battery backup handles a wide farm gate when it’s sized correctly and the panel gets honest sun, which you have plenty of off Hueneme Road. We handle the panel mount, battery bank, operator, and safety edges as one job, quoted up front. Call (877) 610-2993 for a free estimate on your specific entrance.
In coastal Oxnard, that symptom is usually a safety sensor or loop detector tripping because salt corrosion has fouled the signal, or a control board with corroded terminals. The gate opens, reads a false obstruction, and reverses. We test the sensors, open the board housing, and tell you whether it’s a cleaning and rewiring fix or a board replacement, and you get that price before we touch it. Call (877) 610-2993 and we’ll get you scheduled.
You prevent rust through by cutting out the failing section, welding in new steel, and coating everything with marine-grade primer and powder coat before the salt gets another season at it. Wrought iron near Channel Islands Harbor rots from the inside at frame welds, so we grind back to clean metal, rebuild the welds, and seal the joints, not just paint over the bubbling. Call (877) 610-2993 for an assessment, and we’ll give you a written price for the repair.
In 93033 and 93030, the most common repair is a hinge post that has rusted or shifted and let the gate sag until it drags on the driveway. Those 1950s and 1960s tract homes carry original steel gates, and decades of soil settling plus years of deferred maintenance put the entire weight on one worn hinge. We reset the post, replace the hinge hardware, and realign the gate, and the price is agreed before the concrete is mixed. Call (877) 610-2993 for an exact quote, and estimates are free.
Call Gatewood Fence & Gate for Gate Repair in Oxnard
If your gate is sagging, seizing, or refusing to open for the delivery truck, call (877) 610-2993. You’ll get a live person, a straight answer, and a price that doesn’t change when we pull up. Hal Gatewood’s name is on the shop and on every invoice, and we’ve been fixing gates across Oxnard since 2001. Free estimates, upfront pricing, and the 90-Day Done Right Promise in writing. If it’s not done right, we make it right. That’s the whole deal.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Oxnard since 2001.