Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Ocoee
Gate repair in Ocoee typically runs $150 to $650 depending on what failed, and most jobs are finished the same day we show up. If your gate is binding, sagging, or the operator just hums and won’t move, call us at (877) 610-2993 and a live person picks up, day or night. We know Ocoee’s subdivisions, its lake air, and the specific ways its gates fail after twenty years of Florida weather, and we fix them in your driveway instead of hauling them off.
Why Gatewood Fence & Gate Is Ocoee’s Preferred Gate Repair Company
Hal Gatewood has been at this since 2001, and his name is on the shop, the truck, and every invoice. That means something in Ocoee, where folks have already paid a national outfit one price on the phone and a different one at the door. We don’t work that way. You get a written price before any work starts, and it doesn’t change unless the gate tells us something new when we open it up, and then we stop and call you first.
Our Gate Repair team works Ocoee routes every week. We know the builder-grade LiftMaster and Linear operators in the HOA subdivisions off SR-50 and SR-429, and we know which of them were wired right at the start and which weren’t. The crew shows up in uniform, background-checked, and they’ll tell you plainly if a part needs replacing or just adjusting. The 90-Day Done Right Promise is stamped in writing on every job, and it means what it says: if it’s not done right, one call brings Hal back, no runaround.
Our Gate Repair Services in Ocoee
Electric Gate Repair
When an electric gate in Ocoee won’t open or won’t stop opening, it’s usually the board, the loop detector, or the limit switches. In this city, add lightning to the list. May through October, daily thunderstorms roll across the SR-429 corridor and a close strike sends surge straight through the operator’s control board. We replace the board, add proper surge protection, and test the whole system under load before we leave. We service Viking, Ghost Controls, DoorKing, Elite, LiftMaster, Linear, and four other major brands, and we carry boards and parts for most of them on the truck.
Automatic Gate Repair
Automatic gate repair in Ocoee often means troubleshooting the interaction between the operator, the arms, and the safety edges. We see a lot of gates that stop mid-cycle or reverse for no reason, and nine times out of ten it’s a photo eye out of alignment or a loop detector that’s ghost-triggering from the sandy soil and metal rebar under the drive. If you’re in a lakefront subdivision around Lake Olympia or Lake Lotta, your operator is also fighting humidity that corrodes terminals and connections faster than drier parts of Orange County. We correct the alignment, replace corroded wiring, and set the limits properly so the gate closes fully without slamming.
Hinge & Post Repair
Here’s the truth about Ocoee gate failures: the panel sags because the hinge post moved, not because the gate got tired. Sandy soil shifts seasonally under the weight of the gate, especially near the lakes, and a post that was plumb at installation is visibly racked within a decade. Our crew digs out the post, re-sets it in proper concrete with proper drainage, and welds new hinge plates if the old ones have rusted thin. This is on-site welding, in your driveway, not a phone call to a fabricator who’ll have the gate for three weeks.
Gate Realignment
A gate that drags on the ground or won’t close square has a realignment problem, and in Ocoee it usually traces back to that same shifting sandy soil. We re-level the gate panel, adjust the hinge placement, and re-set the operator’s travel limits so the gate runs smooth without binding. If the bottom rollers on a slide gate have worn flat from years of lake humidity and grit, we replace them while the gate is off its track and check the track mounting hardware for rust at the same time. The goal is simple: the gate should open and close with one hand, every time, without the operator straining.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Ocoee
We’re certified on nine major gate brands, including Viking, Ghost Controls, DoorKing, and Elite, plus LiftMaster, FAAC, BFT, Linear, and Mighty Mule. For Ocoee customers that means we don’t have to special-order every part from a warehouse in another state, and we don’t tell you to replace a perfectly good operator because we don’t stock its board. We keep common boards, arms, loop detectors, and safety edges on the truck, and Hal will tell you straight if a brand has turned into a headache and it’s time to switch.
Common Gate Repair Problems We See in Ocoee Homes
- Surge-fried control boards. Ocoee sits in Florida’s lightning corridor, and storms from May through October send surges through the 1990s-era LiftMaster and Linear operators still running in many HOA subdivisions. The board fails, the gate goes dead, and replacing the board without adding surge protection means you’ll replace it again next summer.
- Rusted bottom rollers and hinge pins. The ring of freshwater lakes around Ocoee keeps humidity high year-round. Gates near Lake Bennet, Lake Olympia, and Lake Lotta chew through ferrous hardware roughly twice as fast as gates in drier parts of the county, and the panel binds before the operator even fails.
- Racked hinge posts on sandy soil. Ocoee’s sandy soil shifts seasonally, and a post set without deep enough concrete or proper drainage will move over time. The gate sags, the operator strains, and eventually the rack and pinion strips out from running out of plumb.
- Undersized builder-grade operators. Many of Ocoee’s HOA subdivisions were built between 1990 and 2010, and the developers put in the cheapest operator that met code at the time. Twenty-plus years later those units are past their service life, and no repair will make a worn-out motor run like new.
Pricing for Gate Repair in Ocoee, FL
Here are straight numbers for Ocoee. A hinge and post re-set runs $180 to $400 depending on whether we need to pour a new footing. Board replacement, including the part and the surge protection we recommend, runs $250 to $550. Roller and hinge pin replacement on a lakefront slide gate runs $150 to $300. Full operator replacement with a new unit and proper wiring runs $800 to $1,800 depending on brand and gate size. You get the exact price in writing before we start, and we honor it. We also offer $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. Call (877) 610-2993 and we’ll quote it over the phone as close as a phone quote can be, then confirm it on site before touching a bolt.
We Also Serve Cities Near Ocoee
Our Gate Repair in Ocoee service carries right over into Winter Garden, Orlovista, Pine Hills, and Apopka. If you’re on the edge of Ocoee or just across the line in one of those communities, call the same number and we’ll head your way.
Serving Ocoee, FL - Our Local Coverage Area
We’re based in the Ocoee area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Ocoee
Lake humidity accelerates rust on ferrous hardware, and the sandy soil under Ocoee shifts seasonally, moving gate posts out of plumb within a decade. The combination means hinges, rollers, and posts in lakefront communities fail roughly twice as fast as gates elsewhere in Orange County. When the post moves, the gate binds, and the operator has to work harder until something gives. Call (877) 610-2993 and we’ll inspect the hardware and tell you whether it’s a re-set, a replacement, or a realignment.
If the board has fried more than once and the operator is a 1990s-era LiftMaster or Linear unit, replacement is usually the cheaper long-term call. We’ll still quote both options honestly: board replacement with proper surge protection runs $250 to $550, while a new operator with built-in surge resistance runs $800 to $1,800. We won’t talk you into a new unit if the old one has life left, but we also won’t patch a board the third time without telling you it’ll likely happen again. Call us for a straight answer.
Automating a manual gate means running conduit and branch circuits from the nearest power source, setting an operator on a proper concrete pad, installing safety edges and photo eyes, and programming the limits. Many Ocoee subdivisions built in the 1990s and 2000s never got that infrastructure installed at the build, so the work often involves trenching across the driveway or retrofitting solar if power can’t be run economically. We quote the full scope up front, and the price is fixed before we start. Call (877) 610-2993 for a free on-site assessment.
Slide gates handle Ocoee’s sandy, shifting soil better than swing gates because they ride on a track rather than pivoting on posts that can rack out of plumb. But slide gates demand more attention to their bottom rollers and track hardware, which rust fast in the lake humidity. Swing gates work fine if the posts are set deep in concrete with proper drainage and the hinge hardware is stainless or regularly maintained. We’ll assess your entrance and recommend based on what your soil and lot actually look like, not a rule of thumb. Call for a free on-site look.
UL 325 compliance means your gate has functioning entrapment protection: photo eyes or a contact edge that reverses the gate when something blocks its path, plus proper warning signage and a functioning manual release. If your gate reverses on its own, you may have a failed sensor, and that’s a safety issue that needs attention now. We test entrapment protection on every automatic gate we service in Ocoee and tell you plainly if something’s not up to code. Call (877) 610-2993 to schedule a safety inspection.
If your gate is binding, dead, or just noisy, call (877) 610-2993. A live person answers, we’ll give you a straight price, and we’ll show up when we say we will. Hal’s name is on the shop, and the shop is down the road.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate.