Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Lyndhurst
Gate repair in Lyndhurst runs $185 to $640 for most jobs, with hinge and post work at the lower end and full panel replacement or weld repair at the higher end. We get to Lyndhurst the same day you call in most cases, and you’ll always reach a live person at (877) 610-2993, not a voicemail. Our shop is set up for what Lyndhurst’s gates actually go through: brackish air off the Hackensack, saturated ground after storms, and 1950s frames that have outlasted their original hinges by a generation.
You’re not calling a national outfit. You’re calling a local owner-operator who has been fixing gates since 2001. Hal Gatewood’s name is on the shop and on every invoice. If the gate is sagging, seized, or stuck open after a storm, we look at the post first, not the panel. That’s what keeps the fix from failing again in six months.
Key Takeaways:
- Most Lyndhurst gate repairs cost between $185 and $640, quoted before we start.
- Hinge and post problems are the most common calls we get, especially near Riverside Drive and the low streets off it.
- We weld on site, so the gate stays in your driveway. No hauling it to a shop forty miles away.
- Every job carries our 90-Day Done Right Promise in writing.
- Call (877) 610-2993 for a free estimate. If you have a written quote from another company, we’ll give you a second opinion free.
Why Gatewood Fence & Gate Is Lyndhurst’s Preferred Gate Repair Company
We’ve been called to Lyndhurst enough times to know the map without looking at it. Riverside Drive, Stuyvesant Avenue, Valley Brook, the blocks below Kingsland Avenue that sit low against the Meadowlands. Those are the streets where gate trouble starts earliest and hits hardest. Salt in the air, water in the ground, and iron that’s been standing there since Eisenhower was in office.
When Lyndhurst homeowners call us, a live person answers. Not a recording. Not someone reading a script from another state. You speak to a person who can talk you through whether a gate is safe to leave alone overnight or needs attention now. And that matters at 9 p.m. when a storm has left your driveway gate half off its hinge post.
The person who shows up is Hal, or a background-checked crew member he’d vouch for personally. Uniformed, licensed, and insured. We coordinate scheduling from our New York City office, and crews serve Lyndhurst directly. The address is published. The license number is public. Look us up before you call, that’s fine by us.
We carry the 90-Day Done Right Promise on every ticket. If something isn’t right, one call brings us back. No runaround, no arguing about whether the warranty covers it. It’s in writing, stamped on your invoice.
Our Gate Repair Services in Lyndhurst
We built our Gate Repair service around what actually fails in this town. Here are the four we see most in Lyndhurst:
Electric Gate Repair
Electric gate repair in Lyndhurst typically runs $210 to $420. The most common failure we find is a control board that’s gotten damp from humid Meadowlands air, or a motor that’s been working harder than it should because the gate was already dragging before the opener was installed. We check the gate’s travel first. A motor that strains against a sagging gate burns out fast, and fixing the opener without fixing the travel is a short-term patch.
Automatic Gate Repair
Automatic gate repair in Lyndhurst means dealing with operators that live outdoors in one of the harsher spots in Bergen County. We service LiftMaster, Viking, Ghost Controls, and more. When an automatic gate stops responding after a storm, we test the photo eyes first, then the limit switches, then the board. Most Lyndhurst jobs are diagnosed within an hour and fixed the same visit.
Hinge & Post Repair
Hinge and post repair is the bread-and-butter call around here. A gate sags in the hinge post, not in the middle. When a 1960s driveway gate in Lyndhurst starts scraping the ground, it’s usually the post that’s moved. Saturated soil near the Hackensack heaves footings. We pull the post, re-anchor it with a deeper helical or concrete footing, and re-hang the panel. If you skip the post and just shim the hinges, you’ll fix that gate twice.
Gate Realignment
Gate realignment in Lyndhurst runs $165 to $300 for a standard single swing gate. Wind load on solid infill gates during coastal storms is real stress, and old wrought iron doesn’t spring back. We bring the panel back to plumb, tighten the hinge barrels, and adjust the latch strike so the gate closes and locks without having to lift it. If the frame has cracked at a weld, we handle that too, on site.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Lyndhurst
We’re certified on nine major gate brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. In Lyndhurst, we see a lot of LiftMaster operators on the post-war colonials and a fair number of Viking and DoorKing units on commercial and light-industrial gates along the river side of town. We keep common parts for these in the truck, which means we fix most jobs in one visit. You don’t wait a week for a board to ship from a warehouse.
Common Gate Repair Problems We See in Lyndhurst Homes
- Heaved gate posts near the Hackensack River. After a nor’easter or sustained rainfall, saturated soil shifts under shallow concrete footings. The post cants or lifts, the gate drags, and the latch won’t catch. We remove the old footing, set a deeper helical anchor, and re-hang the panel. This is standard work in the flood-prone blocks off Riverside Drive, not an exotic repair.
- Corroded hinges and latch hardware from salt-laden air. The Meadowlands microclimate pushes brackish air over Lyndhurst year-round. Tubular steel swing gates that would last 20 years in Paramus often seize or sag here within 8 to 12 years. We replace hinge barrels and latch strikes and recommend a protective coating that actually holds up in this air.
- Weld cracks on 1950s and 1960s wrought-iron frames. Wind load during coastal storms stresses old ornamental iron. We see cracks at the stile welds, where the frame bends under pressure. We weld on site, grind the repair smooth, and repaint. The gate stays in your driveway.
- Swing gates that won’t close after a power cut. Automatic gates lose their safety sensor alignment during strong storms. We realign photo eyes, reset limit switches, and test the manual release. More on that below.
Pricing for Gate Repair in Lyndhurst, NJ
Here’s what we charge for common gate repair in Lyndhurst. We quote the price before any work starts, and we stick to it. No trip charge inside the county. $40 off any repair over $200. Permanent 10% discount for seniors and veterans.
- Gate realignment: $165-$300
- Hinge replacement (single gate): $185-$350
- Post reset with new concrete or helical footing: $350-$700
- Electric opener repair (board, motor, or sensor): $210-$420
- On-site weld and rust repair: $150-$400 depending on the extent
- Full panel replacement on a 1960s driveway gate: $500-$1,400
The bigger ticket items in Lyndhurst are almost always post related. Ground conditions near the river make footing work more involved than a simple hinge swap. That’s the honest explanation for why a post reset costs more than a hinge replacement. Both are quoted upfront. Both are backed by the 90-Day Done Right Promise.
Storm and Wind Exposure: The Lyndhurst Gate Problem Nobody Else Addresses
Lyndhurst sits directly on the edge of the New Jersey Meadowlands along the Hackensack River. That’s not just a line on a map. It’s the reason your gate fails differently here than it would in Rutherford or North Arlington. Brackish tidal air moves over the whole town. Floodwater sits in the low streets after big storms. Wind gusts off the open water hit solid infill gates with full force. A gate in Lyndhurst lives a harder life than the same gate five miles inland.
Here’s one that stays with us: after a nor’easter pushed brackish water up from the Hackensack, we reset a twisted swing gate on Riverside Drive where the hinge post had pulled three inches out of plumb. Our crew drove a helical post footing past the softened topsoil, re-hung the LiftMaster operator, and added a fresh safety photocell before the homeowner’s next high tide. That’s not a page from a manual. That’s what we actually do here.
If your automatic gate loses power during a storm in Lyndhurst, most operators have a manual release handle, usually a small lever or pull ring on the motor housing. Pull it and the gate will swing freely by hand. The danger to understand: never force a gate that resists. If it won’t budge, the post may have shifted and the panel can pinch or fall. Call a professional rather than risk injury. A trained person knows where to look and what to move. For anything beyond everyday operation, call us. Gates are heavy enough to break bone.
This is where Lyndhurst-specific experience matters. A tech who works only in Ridgewood or Paramus doesn’t see post-heave from saturated Meadowlands soil. We do. We know which blocks flood first, which gates have been under water, and what a post looks like when it’s been sitting in briny soil for sixty years. That’s the difference between a repair that holds and a repair that repeats.
We Also Serve Cities Near Lyndhurst
We work all around Lyndhurst and into the surrounding towns. That includes Gate Repair in Lyndhurst proper, plus North Arlington, Rutherford, Nutley, and Belleville. If your gate is in one of those towns and you’re sorting out a sagging post or a dead operator, the same phone number works: (877) 610-2993.
Serving Lyndhurst, NJ - Our Local Coverage Area
We’re based in the Lyndhurst area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Lyndhurst
Because Lyndhurst sits on the Meadowlands floodplain, where the soil is saturated and unstable by nature. When the Hackensack rises, the ground under shallow post footings turns soft and shifts, which pushes posts out of plumb. This is routine in the low blocks off Riverside Drive. Towns on higher ground, like Rutherford, don’t get the same soil movement. If your gate is suddenly dragging or the latch won’t catch, the post is usually the culprit. Call (877) 610-2993 for a free estimate, and we’ll bring the post back to plumb and anchor it properly.
It shortens it considerably. Salt-laden air off the estuary corrodes ferrous components faster than inland air. In Lyndhurst, we routinely see hinge barrels and latch strikes fail within 8 to 12 years where the same hardware would last 20 years in Paramus or Ridgewood. That’s a direct consequence of the brackish air. We replace hardware with corrosion-resistant options and can advise on coatings that hold up here. If your hinges are squealing or the gate has started to sag, call (877) 610-2993 for a quote.
First, find the manual release on the operator, usually a pull handle or ring, and activate it so the gate can move by hand. If it won’t move freely, don’t force it. The post may have shifted and the panel could be binding. That’s a job for a professional. Once the gate is manually open or closed, secure it so it can’t swing in the wind and call (877) 610-2993. We’ll come out, check the motor, the safety sensors, and the posts, and get it running again.
Not always, and the older the gate, the more vulnerable it is. Solid infill gates catch wind like a sail. A 1950s or early 1960s wrought-iron frame with original welds and shallow concrete footings can crack at the stiles or pull a post under sustained coastal gusts. If your gate has started to lean or the frame has a visible crack, that’s wind stress. We repair the weld on site and reset the post if needed. Call (877) 610-2993 for a free estimate before it gets worse.
Usually it’s worth it, and that’s the repair-first approach we stand behind. If the frame is structurally sound and the rust is at hinges, latch points, or surface scale, we can grind it, weld any weak spots, and refinish the panel. A full panel swap for a 1960s driveway gate runs $500 to $1,400 in Lyndhurst. Most rust repair costs well under half that. We’ll tell you straight if a panel is too far gone, but more often than not, the gate has another twenty years in it. Call (877) 610-2993 and we’ll give you an honest read.
If your gate is sagging, seized, dragging, or dead after a storm, call (877) 610-2993. We answer live, we show up on time, and we quote the price before we touch a bolt. The name is on the shop, and the shop is down the road. That’s the oldest accountability there is.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Lyndhurst and surrounding Bergen County communities since 2001.