Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Greenbrier
Gate repair in Greenbrier, TN usually starts with one question: is this a power problem or a post problem? On most acreage lots here, it’s the post. Robertson County clay expands and contracts with every wet season, heaving hinge posts out of line and dragging slide gates out of track. We’ve been fixing both since 2001, and we work on everything from a 16-foot Viking slide gate on a paved driveway to a pipe livestock gate that’s been leaning since the last ice storm. If you’re in Greenbrier and a gate won’t close, won’t open, or won’t stop grinding, call (877) 610-2993 and a live person answers.
Why Gatewood Fence & Gate Is Greenbrier’s Preferred Gate Repair Company
We’re not a franchise and we don’t route calls through a call center. Hal Gatewood started this shop, his name is on every invoice, and the person who quotes your repair is often the same person who welds it. Gatewood Fence & Gate has been locally owned and owner-operated since 2001, which means the accountability is simple: if the work isn’t right, you know where to find us.
Greenbrier sits in a unique spot. Drive down Highway 41 or Greenbrier Road and you’ll pass a 2000s subdivision gate on one side and a working farm entrance with a chain-and-pipe gate on the other. A lot of national outfits only know one of those. We know both, because we’ve been servicing Robertson County long enough to recognize the failure patterns that come with clay soil, ice storms, and a decade of DIY solar operators. We stock common parts for LiftMaster, Viking, Ghost Controls, DoorKing, and Elite, and we carry what’s needed to fix the post and rack instead of just swapping a motor and hoping it holds. Work is covered by our 90-Day Done Right Promise in writing. If it’s not right, one call brings us back.
Greenbrier homeowners tend to appreciate that we answer the phone with a live person 24/7, and that pricing is stated plainly before any work begins. We don’t quote one number and show up with another.
Our Gate Repair Services in Greenbrier
The gates around Greenbrier fail in predictable ways, and the fix usually comes down to four areas of work. Here’s what we actually do on the ground, and why it matters on a Robertson County lot.
Electric Gate Repair
An electric gate that won’t respond usually traces back to one of three things: a failing control board, a dead battery, or a power source that’s not delivering. On Greenbrier properties where the nearest receptacle is 300 feet from the gate, solar and battery systems do a lot of the heavy lifting and wear out faster than mains-powered units. We test the full circuit, replace what’s actually failed, and we’ll tell you straight if a part doesn’t need replacing. A typical electric gate repair in Greenbrier runs $180 to $450 depending on the component.
Automatic Gate Repair
Automatic gate repair means diagnosing the operator and the gate together. A motor that strains against a sagging post will burn out again, which is why we won’t just swap a motor and leave. If your slide gate jerks, stops mid-travel, or reverses for no reason, we check the rack alignment, the limit switches, the chain tension, and the post footing. For automatic gate repair in Greenbrier, expect $220 to $600 for most operator and alignment work.
Hinge & Post Repair
This is the most common service we perform in Greenbrier, and it’s the one that gets overlooked the most. A swing gate doesn’t sag in the middle; it sags at the hinge post. In clay-heavy soil, posts shift with the seasons. We cut, relevel, and set new concrete footings so the post stays put. Fixing the panel without fixing the post means you’ll be calling us again next spring. Hinge and post repair in Greenbrier typically runs $250 to $700 depending on post size, gate weight, and whether we’re doing on-site weld repair.
Gate Realignment
After a winter ice load or a few seasons of clay settling, a gate that once opened smoothly starts dragging on the gravel or binding against the latch side. Realigning a gate means adjusting the hinges or the track so the gate hangs square and travels without resistance. On Greenbrier driveways with a slope, this sometimes requires re-welding the gate frame at the hinge mounts. Gate realignment runs $150 to $400 for most residential and acreage gates.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Greenbrier
We’re certified to service nine major gate brands, and around Greenbrier we see a lot of Viking, Ghost Controls, and DoorKing hardware on the newer automated systems, along with Elite on heavier farm and estate entrances. It’s not enough to know the brand; you have to know the installation mistakes that went along with some of the 2010s rural builds. We keep common parts in stock and if we don’t have it, we order it by the next morning. We don’t tell you to replace a whole operator because one board failed.
Common Gate Repair Problems We See in Greenbrier Homes
- Clay-shifted hinge posts on swing gates. Robertson County’s heavy clay absorbs winter moisture and expands, then contracts in summer heat. The post moves a fraction of an inch each cycle, and within a year or two the gate is dragging on the latch side. We relevel the post and set a deeper concrete footing, and the gate hangs right again.
- Ice-strained welds and seized hinges on pipe gates. Middle Tennessee’s periodic ice storms deliver sudden heavy loads. Older pipe farm gates pick up ice, welds crack at the corners, and hinges seize. We weld on-site in your driveway, so the gate never leaves your property.
- Underpowered solar operators on wide acreage gates. Many of the automated gates installed around Greenbrier in the 2010s boom were paired with cheap solar-powered operators that can’t handle a 14- to 16-foot gate once the post shifts even slightly. The owner replaces the battery, then the motor, and it still fails. The real fix is the post and track alignment, and that’s where we start.
- Slide gates dragging on gravel drives. Greenbrier driveways are long, and many are gravel. When a slide gate’s rollers wear down or the post at the motor end shifts, the gate drags or binds against the rack. We’ll reshim the track, replace rollers, and if the motor post has moved, we’ll reset that too.
Pricing for Gate Repair in Greenbrier, TN
Here’s honest pricing for Greenbrier. A service call inside the county carries no trip charge. Most hinge and post repairs land between $250 and $700. Automatic gate repair runs $220 to $600, electric gate repair $180 to $450, and gate realignment $150 to $400. Weld and rust repair is typically $100 to $350 for most crack repairs and reinforcement work. What affects the price is the weight of the gate, whether we’re replacing a component or repairing one, and whether the post needs a new footing. Every price is quoted and agreed to in writing before any work starts. You’ll also get $40 off any repair over $200, and a permanent 10% discount for seniors and veterans.
We Also Serve Cities Near Greenbrier
Our Greenbrier crews also cover Millersville, White House, Springfield, and Goodlettsville. If you’re just outside the Greenbrier area and need Gate Repair from someone who knows Robertson County, call us and we’ll get you scheduled. For full details on our Greenbrier coverage, see our Gate Repair in Greenbrier page.
Serving Greenbrier, TN - Our Local Coverage Area
We’re based in the Greenbrier area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Greenbrier
The gate isn’t sagging; the hinge post is moving. Greenbrier’s clay soil holds water through winter and shifts as it freezes and thaws. The post leans a fraction of an inch, and the gate follows. We fix it by releveling the post and setting a new concrete footing deep enough to get below the worst of the expansion. Then the gate hangs true again. If yours is sagging, call (877) 610-2993 for a free estimate.
You can often keep solar, but the operator has to be sized to the gate and the post has to be plumb. A solar operator on a gate with a shifted post is working against itself, and no new motor fixes that. We’ll evaluate the load, check the alignment, and tell you if solar still makes sense for your driveway. If it does, we’ll install an operator that matches the gate’s actual weight and travel.
Nine times out of ten, the rack and pinion is binding because the motor post or the track shifted in the clay soil. The motor is fighting resistance it shouldn’t have, and that’s the grinding. We realign the rack, reset the post if needed, and the jerking stops. The longer it runs like that, the more damage it does to the gear teeth. A repair is cheaper now than a full gearbox replacement later.
Both. Hal started this shop working on agricultural gates, and we still weld pipe gates and livestock entrances on Greenbrier farms and acreage parcels. The same crew that services a Viking slide gate on a subdivision entrance will weld a cracked hinge on a pipe gate down a gravel lane. On-site welding means the gate stays where it belongs.
Yes, photo-eyes are required safety equipment on automatic gates, and they need to be tested regularly. You can test them by placing an object in the gate’s path while it’s closing; the gate should stop and reverse. If it doesn’t, the photo-eyes are misaligned or failed. That’s a safety issue, not a convenience issue, and it should be fixed right away. We test every safety device on every automatic gate we service.
Call Gatewood Fence & Gate for Gate Repair in Greenbrier
If your gate is sagging, grinding, or dead, call (877) 610-2993 and talk to a real person, any hour of any day. We’ll give you a straight answer, a free estimate inside the county, and a price you can hold us to. Hal’s name is on the invoice, and the 90-Day Done Right Promise is on there too.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Greenbrier and Robertson County since 2001.