Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Repair Across Centennial
Gate repair in Centennial, CO typically runs $180 to $340 for a hinge or latch fix and $450 to $900 when an operator or control board needs replacing. Most residential calls are done same-day; commercial gate work in the Meridian corridor is usually scheduled within 24 to 48 hours. If your gate won’t open, sags into the latch post, or the keypad stopped working, call (877) 610-2993 and a live person will answer. We know the difference between a quick panel fix and a post problem that’s been developing for three winters, and we won’t sell you the wrong one.
Centennial is different from the older Denver neighborhoods. Our Gate Repair crews work these subdivisions every week, from the Homestead Farm neighborhood off Arapahoe Road to the developments behind Southglenn. The gates here were built in the 1980s and 1990s with HOA spec sheets attached to the original permits. That changes how we repair them, and it’s why a Colorado Springs flyer company can’t show up and do it right. We’ve been at this since 2001 with a published address, a license number you can look up, and Hal Gatewood’s name on every invoice.
Key takeaways:
- Same-day gate repair available across Centennial and the 80112 corridor
- Live person answers the phone 24/7, not a voicemail queue
- On-site welding means your gate stays in your own driveway where you can see the work
- 90-Day Done Right Promise in writing on every job, not a verbal “we’ll see”
- Free second opinion on any written estimate, no trip charge inside Arapahoe County
Why Gatewood Fence & Gate Is Centennial’s Preferred Gate Repair Company
Hal Gatewood started this shop in 2001 and still runs it like he did on day one. When you call about a gate that’s sagging off its hinge post, the person you talk to knows what a hinge post is. That matters in Centennial because the gates here aren’t random. They were installed in spec-built waves, and a lot of them share the same builder shortcuts. We’ve repaired enough 1990s-era Homestead Farm and Willow Creek gates to know which ones had undersized hinge plates from the start.
Our reviews from Centennial customers tell the same story: someone showed up in the window they promised, fixed the gate in the driveway, and charged what they said they would. Response to Centennial is same-day for most residential repairs. The crews working your neighborhood are background-checked and uniformed, and they carry the 90-Day Done Right Promise in writing. If it’s not done right, one call brings Hal back. No runaround, no “that’s not covered.”
We answer the phone around the clock because a stuck-open driveway gate at midnight is a security problem, not a business-hours inconvenience. Scheduling for Centennial is coordinated from our Denver-area operations, but the work is handled by crews who know these streets and these gate styles.
Our Gate Repair Services in Centennial
Electric Gate Repair
Electric gate repair in Centennial runs $280 to $750 for most operator, control board, and safety sensor issues. Builder-grade operators in these 1980s and 1990s subdivisions often have undersized low-voltage wiring with no dedicated conduit, so the control board browns out and quits. We trace the power run, replace the wire if it’s undersized, and install the current operator with full entrapment protection. Viking, Ghost Controls, and DoorKing operators are the most common in this area, and we stock parts for all of them.
Automatic Gate Repair
Automatic gate repair in Centennial typically costs $350 to $850, depending on whether it’s the operator, the loop detector, or the safety edges. Commercial properties along the I-25 corridor in the 80112 zip code need faster turnaround because a failed gate disrupts deliveries and employee access. Residential automatic gates here are frequently the original equipment from a 1990s builder package, and the failure is usually the logic board or a dead transformer, not the motor itself.
Hinge & Post Repair
Hinge and post repair is the repair Centennial needs most often. Our crews cut out the fatigued hinge, weld in a heavier gauge on site, and re-set the post if the clay movement pulled it out of plumb. A repair like this runs $220 to $450 in this market, and doing the post without the panel is how you end up fixing the same gate twice.
Gate Realignment
Gate realignment in Centennial costs $180 to $320 for a standard residential swing gate. The work means pulling the frame back square, re-hanging the gate, and setting the latches so they catch without slamming. If you call before the gate starts dragging, this is a one-trip fix. If the panel has been scraping the post for six months, the hinge plates are likely ovaled out and you’re looking at the repair range above.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Centennial
We’re certified to service nine major gate brands, and in Centennial we see a lot of Viking, Ghost Controls, DoorKing, and Elite operators on both residential and commercial properties. Because these subdivisions repeated the same gate styles and hardware for entire blocks, we stock the common hinge plates, latch sets, and control boards that keep coming back. That means less “waiting on a part” and more “it’s done before dinner.” Elite swing gate operators are especially common on the ranch-style lots off Arapahoe and University, and we keep their board inventory current.
Common Gate Repair Problems We See in Centennial Homes
These are the failures we actually see in this city, week after week:
- Undersized hinge plates from 1990s builder packages. The same gate spec was repeated across entire subdivisions, so an undersized hinge shows up on every third gate on a street. This is a systemic design flaw, not a one-off failure.
- Freeze-thaw clay heave pushing posts out of plumb. Centennial sits on Arapahoe County clay that expands and contracts every winter. Posts move, latches misalign, and a panel-only repair won’t stop it from coming back next spring.
- Builder-grade operators with undersized, unburied low-voltage wiring. The operator quits intermittently, and only a proper power run fixes it. We trace the wire, replace it with a heavier gauge through conduit, and the problem goes away for good.
- Chinook wind racking on swing gates. Front Range wind events gust past 60 mph and twist gate frames sideways. Over two or three seasons, the frame racks and the gate stops latching. This is a repair we do regularly in the open-lot neighborhoods south of County Line Road.
Pricing for Gate Repair in Centennial, CO
Here’s what we quote in Centennial, and the price is agreed in writing before we start:
| Service | Typical Centennial Price |
|---|---|
| Gate realignment | $180 - $320 |
| Hinge replacement (welded on site) | $220 - $450 per hinge set |
| Electric gate / operator repair | $280 - $750 |
| Automatic gate diagnostic + repair | $350 - $850 |
| Lock repair / latch replacement | $140 - $260 |
| Weld & rust repair (frame section) | $250 - $500 |
What moves you from the bottom to the top of a range is usually the post condition. If the clay heave has moved the post out of plumb and it needs re-setting, that adds material and labor. We tell you before we touch it. Estimates are free, there’s no trip charge inside Arapahoe County, and you get $40 off any repair over $200. Seniors and veterans always get 10% off. Call (877) 610-2993 and you’ll get a real person and an exact number before the work starts.
We Also Serve Cities Near Centennial
Our crews cover the south metro corridor, including Castlewood, Dove Valley, Lone Tree, and Southglenn. If you’re just across the Centennial line, the same live-answer phone, same-day service, and written 90-Day Done Right Promise apply. Call (877) 610-2993 and we’ll tell you when we can be there. Read more about Gate Repair in Centennial to see how we work in the communities along Arapahoe Road and the I-25 corridor.
Serving Centennial, CO - Our Local Coverage Area
We’re based in the Centennial area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Repair in Centennial
Sagging gates in Centennial are almost always a hinge post issue, not a panel issue. The Arapahoe County clay under your post heaves through freeze-thaw cycles, moving the post out of plumb enough that the gate hangs low off the hinges. Straightening the panel doesn’t fix the post. Welding in a heavier hinge and re-setting the post does. A gate sags in the hinge post, not in the middle, and that’s where we start. Call (877) 610-2993 for a posted price.
Yes, because we build HOA compliance into the job before we order parts. Our techs photograph the existing gate and confirm the exact powder-coat color, picket profile, and hardware finish against the community’s architectural guidelines. That step doesn’t happen in unincorporated Arapahoe County, but in Centennial’s HOA-dense subdivisions it’s the difference between a finished repair and a violation notice. We do this on every residential gate job in this city.
Because your whole subdivision was built with the same gate spec. If the original builder package used an undersized hinge plate or a light-duty operator, every house on the street has the same parts and the same weak points. We see this all over Centennial, especially in 1990s developments. Once we identify the systemic flaw, the fix generally holds long after the 90-Day Done Right Promise expires. That promise is in writing, by the way.
Yes. The right way is to run low-voltage wire through liquid-tight conduit to the post footing, not zip-tied along the fence line. That’s what we did last month on a 1990s home in Homestead Farm off Arapahoe Road. The original builder had a LiftMaster operator wired through undersized 14-gauge outdoor line with no conduit, and the wiring had to be replaced before we could mount the new operator. We ran 12-gauge through conduit, set the limits to match the HOA’s swing arc, and no wire is visible. That’s standard on our Centennial automation calls.
It can be. The high-plains clay around the 80112 corridor holds moisture differently through freeze-thaw, and loop detectors under shifting drive lanes can drift out of spec. But more often it’s a loop wire that was nicked during a paving job or an aging detector card in the operator. We diagnose it on site, test the loop resistance, and fix it the same day if it’s a detector issue. Call (877) 610-2993 for a commercial gate service call in Meridian or the corridor.
Call Gatewood Fence & Gate for Centennial Gate Repair
If your gate is sagging, dead, or stuck halfway open, call (877) 610-2993. You’ll get Hal or one of his crew, not a recording. We’ll give you a straight price, show up in the window we promised, and write the 90-Day Done Right Promise on the invoice. Free estimates, no trip charge inside Arapahoe County, $40 off any repair over $200, and a permanent 10% discount for seniors and veterans. The name is on the shop, and the shop is down the road. That’s the oldest accountability there is.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Centennial and the south metro since 2001.