Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Motor & Opener Across Pomona
A gate motor repair in Pomona typically costs $185 to $480 depending on whether we’re replacing a circuit board, a capacitor, or the full operator arm. Most calls in the 91766 and 91767 ZIP codes are same-day or next morning, because a gate that won’t open isn’t just inconvenient. It’s a security gap on a property full of tools, vehicles, and family. Call (877) 610-2993 and you’ll get Hal or one of his crew on the line, not a phone tree. We’ve been working on Pomona gates long enough to know which neighborhoods have the old DoorKing operators from the 90s and which ones went with FAAC slide motors that never quite liked the heat.
Why Gatewood Fence & Gate Is Pomona’s Preferred Gate Motor & Opener Company
Hal Gatewood started this shop in 2001, and his name is still on the door, the invoices, and the truck that shows up in your driveway. That matters to Pomona homeowners because a lot of you have been burned by a company that quoted one price over the phone and handed over a different invoice at the end. We don’t do that. Our Gate Motor & Opener work is quoted before we touch a single bolt, and the price doesn’t move unless we find something structural and stop to show you first.
Pomona carries an unusual stock of aging security gates. Walk any block near Garey Avenue or down through the neighborhoods off Holt Boulevard in 91767, and you’ll see wrought-iron driveway gates that went in during the 80s and 90s. Those gates are now 30 to 40 years old, and their motors are failing in waves. We see it every week. A homeowner calls because the gate stopped mid-cycle, and when we open the operator cover, the board is cooked from years of Pomona heat and the wires are brittle from UV. Other companies want to sell a full replacement. We repair what’s repairable and tell you straight when it isn’t.
Every job carries our 90-Day Done Right Promise in writing. If something isn’t right, one call brings us back. No runaround. No fine print. We also answer the phone with a live person 24 hours a day, seven days a week. That’s not a call center in another state. It’s us.
Our Gate Motor & Opener Services in Pomona
Motor Repair
Motor repair is the bulk of what we do in Pomona. A gate motor here runs hard: Santa Ana winds force the gate against its stops, clay soil movement throws the track or hinges out of alignment, and the motor works harder every cycle until something gives. Most repairs in Pomona run $185 to $480 and include diagnosing the board, checking capacitor health, re-aligning the gate, and replacing only what actually failed. We fix LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule.
Motor Installation
When a motor is genuinely beyond repair, we install new. A full operator replacement in Pomona typically runs $900 to $2,400, depending on gate weight, swing versus slide, and whether you want battery backup or intercom integration. We don’t push replacement when repair will hold. But when the motor is 35 years old and the manufacturer stopped making parts a decade ago, you’ll get a straight recommendation and a written price before we order anything.
Linear Motor Service
Linear operators are common on Pomona’s older slide gates, and they have a specific failure pattern here. The arm or belt assembly takes extra strain when expansive clay soil heaves the track out of level after a wet winter. We re-level the track, check the rack and pinion, and replace the Linear motor or arm only if it’s truly shot. In many cases, the motor itself is fine and the track was the problem all along. That’s the kind of finding that saves you $1,000 versus what a replacement-first company would charge.
Slide Motor Service
Slide gates in Pomona take a beating from two directions. The clay soil under the driveway moves with every drought-and-rain cycle, and the Santa Ana winds push the gate panel sideways against its rollers and track. That combination binds motors, burns contactors, and strips gears. We service cantilever, V-track, and rack-and-pinion slide systems across 91768, 91769, and the rest of Pomona. If the track is out of level, we fix the concrete pad and re-set the track before we touch the motor. Fix the alignment first, then the motor lasts.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Pomona
We’re certified to service nine major brands, and in Pomona we see a lot of FAAC slide motors on the older custom gates, BFT operators on the mid-2000s installations, and Linear arms on the tract-home swing gates from the 90s. We also work on Viking and Ghost Controls for the newer residential installs. Because we’ve been doing this in Pomona for years, we know which parts fail on which units in which neighborhoods, and we keep the common replacement boards, capacitors, and photo-eyes on our trucks. That means fewer return trips and faster fixes for you.
Common Gate Motor & Opener Problems We See in Pomona Homes
- Burned-out operator boards from Santa Ana wind stress. When a gust forces the gate against its mechanical stops, the motor draws locked-rotor current and fries the board. It happens in a single weather event. We see a spike in board replacements every fall and early winter across Pomona.
- Slide gate motors that bind after a wet winter. The expansive clay under Pomona driveways swells, lifting one end of the track. The gate tries to climb a grade it wasn’t designed for, and the motor overheats. Re-leveling the track fixes the root cause. Skip that step and you’ll replace the motor again next spring.
- Photo-eye sensors failing in summer heat. Pomona regularly tops 100°F, and the UV load here is brutal. Sensor lenses cloud, internal components degrade, and the gate reverses for no reason. We replace sensors with higher-temp-rated units and shield the wiring from direct sun where we can.
- Brittle, cracked wiring insulation on 30-year-old gates. Original wiring from the 80s and 90s wasn’t meant for decades of Pomona sun. Insulation breaks down, shorts develop, and the gate behaves erratically. We re-run low-voltage control wire and re-terminate connections during motor repairs, which eliminates half the ghost problems those old gates develop.
Pricing for Gate Motor & Opener in Pomona, CA
Here are real numbers for the Pomona market, not vague ranges pulled from a national chart:
- Motor repair (board, capacitor, or limit switch): $185-$480
- Full operator replacement (swing or slide): $900-$2,400
- Linear arm or belt replacement: $300-$700
- Photo-eye sensor replacement: $120-$260 per set
- Battery backup installation: $350-$800 depending on motor type
- Intercom and keypad integration: $400-$1,100 per entry point
Every price is quoted and agreed before any work starts. If you’re inside the county, there’s no trip charge. We also take $40 off any repair over $200, offer a free second opinion on any written estimate from another company, and give a permanent 10% discount to seniors and veterans. Call (877) 610-2993 and tell us what your gate is doing. We’ll give you a real number.
We Also Serve Cities Near Pomona
While this page is for Gate Motor & Opener in Pomona, we regularly run calls into San Dimas, La Verne, Charter Oak, and Diamond Bar. If you’re on the edge of Pomona near the 57 or the 10, you’re still well inside our service area. Same live person on the phone, same no-trip-charge policy inside the county, same written quote before any work begins.
Serving Pomona, CA - Our Local Coverage Area
We’re based in the Pomona area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Motor & Opener in Pomona
Because Pomona’s expansive clay soil swells when it gets wet, and that swelling lifts sections of the concrete pad under your slide gate track. The track goes out of level, the gate starts climbing a subtle grade, and the motor draws more current every cycle until the thermal overload or the board gives out. The fix starts with re-leveling the track and re-setting the pad, not with bolting on another motor. If you replace the motor without fixing the track, you’ll be replacing it again next spring. Call (877) 610-2993 and we’ll check the track before we touch the motor. Estimates are free.
Usually not. A gate sags at the hinge post, not in the middle, and Pomona’s shifting clay is often what moved the post in the first place. We re-set the post in concrete, re-weld the hinge points if they’re cracked, and re-square the gate frame before adjusting the opener. That repair typically runs $400 to $900 depending on how far the post has moved. The gate steel from that era is often still solid, and welding on site in your driveway is faster and cheaper than hauling it off. Call us first; you might save yourself a few thousand dollars.
Yes, and they do it in a specific way. The wind loads the gate panel sideways and forces it against the mechanical stops while the motor is still trying to drive. That creates locked-rotor current, which burns boards and strips gears in a single event. We replaced a LiftMaster slide operator off Garey Avenue in 91766 after clay movement shifted the track and the rack stripped under wind load. We re-set the post footing, re-aligned the track, and installed a new motor with battery backup. It has cycled smoothly through two Santa Ana seasons since.
Pomona heat and UV are the culprits. Temperatures above 100°F bake the sensor housing, cloud the lens, and degrade the internal electronics far faster than in coastal cities. The sensor starts giving false obstruction signals, and the gate reverses halfway through its cycle or refuses to close. The fix is a higher-temp-rated sensor and, where possible, relocating it out of direct afternoon sun. A typical sensor replacement runs $120 to $260, and we include re-aiming and wiring checks in that price. Call (877) 610-2993 for an exact quote. Free estimates, no trip charge in the county.
Yes, in most cases. We can add intercom and keypad entry to older FAAC, BFT, Linear, and DoorKing operators as long as the motor’s control board has a dry-contact input for an external access device. If the board doesn’t have that input, we can swap in a compatible board or install a standalone receiver that triggers the existing motor. Intercom and keypad integration in Pomona typically runs $400 to $1,100 per entry point depending on wire runs, gate position, and whether we need to trench under the driveway. Call (877) 610-2993 and we’ll tell you what your specific gate can take. The estimate is free.
Call Gatewood Fence & Gate for Gate Motor & Opener Work in Pomona
If your gate motor is clicking, grinding, or dead quiet in Pomona, call (877) 610-2993. You’ll talk to a live person. We’ll ask what the gate is doing, give you a straight answer on what it probably needs, and schedule a visit that fits your day. Hal has been at this since 2001, the shop address is published, and the license number is available to anyone who asks. The name is on the shop, and the shop is down the road. That’s the oldest accountability there is.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Pomona since 2001.