Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Calverton
A new driveway gate in Calverton, MD typically runs $2,400-$5,800 installed, depending on whether you’re replacing an existing gate or starting fresh with new posts and an operator. Most single swing gate replacements take a day on site, while full driveway gate systems with automation run two to three days. Call (877) 610-2993 and we’ll give you a written price before any work starts.
If you live off Briggs Chaney Road or along Powder Mill, you already know Calverton’s gates are older than most. The subdivisions went up between 1965 and 1985, and a lot of those original gates are still standing on their first set of posts. Some are worth saving. Some should’ve been replaced fifteen years ago. We’ll tell you which one you have, and we’ll tell you straight.
Why Gatewood Fence & Gate Is Calverton’s Preferred Gate Installation Company
Hal Gatewood started this company in 2001 because he kept finding gates that other outfits had botched and walked away from. That’s still the reason we show up. When we install a gate in Calverton, we’re not doing a drive-by swap. We’re checking the post, the hinges, the operator mounting, the photocells, and the ground the post sits in. Because around here, the ground matters as much as the gate.
Our shop carries parts for Viking, Ghost Controls, and DoorKing operators, so when a Calverton job needs a new control board or a safety edge, we’re not emailing a distributor and hoping. We keep common components on the truck and uncommon ones within a day. That matters when your swing gate is stuck open and your dog has other plans.
The person who answers the phone at (877) 610-2993 is a live person, any hour. Not a menu that says press two for parts. When Hal says he’ll be there Tuesday, he means it. His name is on the shop and the address is published, which is the oldest accountability there is.
Our Gate Installation Services in Calverton
We install and replace pretty much every type of gate Calverton homes use. Here’s how the common ones shake out around here.
Swing Gate Installation in Calverton
Most Calverton properties with gates have swing gates, and most of those are single-leaf ornamental iron or chain-link hung on posts that went in with the original house. A typical swing gate replacement here runs $1,800-$3,900, including new posts when the old ones have heaved. If you’re adding an operator, a LiftMaster LA400 or similar adds roughly $900-$1,400.
Here’s what the national chains don’t tell you: a swing gate sags in the hinge post, not in the middle. Fix the panel without the post and you’ll fix it twice. We re-plumb the post first, then hang the gate.
Driveway Gate Installation in Calverton
Driveway gates in Calverton cover everything from a 10-foot single swing to a 20-foot double leaf. Full installation with automation (posts, gate, operator, photocells, and wiring) typically runs $4,200-$7,800. Double driveway gates on the split-levels off Briggs Chaney tend to run toward the high end because the two leaves double the hardware and the wiring.
One thing we see constantly: homeowners order a slide gate kit online, the clay soil against the old post footing has shifted, and the rack and pinion binds on the first cycle. Then the manufacturer blames the install. Save yourself that phone call and let us set the post right the first time.
Pedestrian Gate Installation in Calverton
Pedestrian gates run $700-$1,600 installed for a standard 4-foot metal gate with a proper post set in concrete. These are the gates people use every single day, usually more than the driveway gate, so the hinge wear shows up faster. We install them with welded hinge plates and set posts in concrete footings sized for the clay here, not the pea gravel standard from a box-store instruction sheet.
Security Gate Installation in Calverton
Security gates are the heavier cousins: steel frame, reinforced posts, sometimes a mag lock or keypad. In Calverton these run $5,500-$9,500 depending on gauge, height, and access control. If you’re putting in a security gate, we’ll talk you through Montgomery County’s requirements for safety edges and entrapment protection before we quote it. Better to know up front than to fail an inspection later.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Calverton
We’re certified to service nine major gate operator brands, and for Calverton homes that most often means LiftMaster, Viking, Ghost Controls, and DoorKing. Those are the operators we see on 1980s swing gates, newer security installs, and everything between. We stock common replacement boards, safety edges, and remote transmitters locally, which means if your DoorKing board dies on a Tuesday, you’re not waiting a week for freight. We also handle Elite swipe/entry systems for the few Calverton properties that have them.
Common Gate Installation Problems We See in Calverton Homes
- Posts heaved out of plumb. Calverton’s heavy clay shrinks and swells with every season. A post that was perfectly plumb in September can be visibly tilted by March. We check and re-plumb posts every spring rather than grinding the latch to make it work.
- Rotting wood posts under older gates. Homes built from 1965 to 1985 often have original 4×4 wood posts holding a steel gate. The clay holds water against them for decades. We pulled a 1978 ornamental iron gate off its original post on Powder Mill Road and found the wood rotted 14 inches below grade. The gate looked fine. The post was gone.
- Obsolete operators with no safety features. Pre-UL 325 operators have no entrapment protection. If we install a new gate on a Calverton property with an old opener, you’re getting new photocells and a current operator. There’s no grandfather clause for a gate that can crush a kid.
- Underground cable failing in freeze-thaw cycling. UF cable run under driveways in the 1980s develops insulation cracks from decades of ground movement. The operator keeps tripping the breaker, and the fix isn’t another reset. It’s a new conduit run.
Pricing for Gate Installation in Calverton, MD
Straight numbers, Calverton:
- Pedestrian gate, installed: $700-$1,600
- Single swing driveway gate, no operator: $1,800-$3,400
- Swing gate with operator: $2,700-$5,300
- Double driveway gate with operator: $4,200-$7,800
- Security gate with access control: $5,500-$9,500
What moves the number is post condition, the size of the gate, whether we’re reusing the operator or starting fresh, and access. A gate at the back of a narrow side yard takes more time than a straight driveway pull-up. Every quote is written, itemized, and agreed before we start. We don’t come back with a different number at the door. Estimates are free. Seniors and veterans get 10% off, every job. Inside Montgomery County, there’s no trip charge.
We Also Serve Cities Near Calverton
Our Gate Installation crews cover Calverton and the surrounding Montgomery County communities. If you’re in Calverton, we’re close. We also do regular work in Beltsville, Burtonsville, Fairland, and Hillandale. Same crews, same written pricing, same 90-Day Done Right Promise. More on what we do at our main Gate Installation page.
Serving Calverton, MD - Our Local Coverage Area
We’re based in the Calverton area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Calverton
No. A gate that drags in spring after being plumb in fall is almost always the post heaving in Calverton’s clay soil. The clay swells with winter moisture and freezes hard, pushing the post out of vertical. Hinge adjustment might buy you a few weeks, but until the post is re-set in a proper concrete footing, it’ll do it again next winter. Call us at (877) 610-2993 and we’ll check it. If it’s the post, you want to fix it before the gate stresses the hinges into failure.
Yes, in most cases. A 1960s chain-link gate is usually steel and can handle a modern operator like a LiftMaster LA400 or LA500 as long as the post is solid and the gate moves freely. We may need to add a welded steel mounting plate, and the electrical run usually needs new conduit, not just new wire on the old run. We handle the whole thing: gate prep, operator mounting, wiring, and safety photocells. Estimates are free.
Often yes. Calverton is unincorporated, so all gate work runs through Montgomery County DPIE, not a township office. A simple like-for-like gate replacement usually sails through. A new gate with deeper post footings than 36 inches or a new electrical run for an operator often requires a county review and sometimes an inspection. We know the forms and the process and we’ll handle the paperwork on your permit. What’s a quick swap in Burtonsville can need two county reviews a mile west. That’s just how DPIE works.
Yes. If there’s an operator on the gate, Montgomery County requires entrapment protection that meets current UL 325 standards. That means photo-eyes, a reversing edge, or both depending on the gate. If we’re installing a new gate in Calverton, the operator gets current safety equipment. No exceptions. Your 1980s opener had none of this, and we won’t leave a gate in your driveway that could hurt a child or a delivery driver.
Usually, yes, it can be saved, and you should think twice before you replace it. These older ornamental iron gates are often better steel than what’s sold today. The sag is usually in the hinge post or the hinges themselves, not the gate panel. We weld on site, so the gate stays in your driveway. If the panel is rusted through or the scrollwork is fatigued, then replacement makes more sense. We’ll give you our honest read and a written price either way. Call (877) 610-2993 and Hal will tell you what he’d do if it were his gate.
Call Gatewood Fence & Gate for Gate Installation in Calverton, MD
You don’t need a gate company that quotes one number on the phone and another at the door. You need someone whose name is on the truck. Hal Gatewood has been doing this since 2001, and the 90-Day Done Right Promise is written on every invoice. If it’s not done right, one call brings him back. No runaround.
Call (877) 610-2993 for a free estimate on gate installation in Calverton. We’ll answer. We’ll show up. We’ll write the price down and stick to it.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate.