Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Tigard
Gate access control in Tigard usually means one of three things: adding a keypad or card reader to a gate that’s been manual since the ’80s, replacing a builder-grade operator that never worked right, or wiring a phone entry system into an HOA subdivision where the original conduit was never run. We handle all three. Hal Gatewood has been fixing gates since 2001, and the crew works through Tigard’s 97223 ZIP every week. Call (877) 610-2993 and a live person answers, any hour.
Our Gate Access Control team works on keypads, remote controls, phone entry, card readers, video intercoms, and the wiring that ties them together. If you’re in Tigard, we’ll be there in a truck with parts on board, not a sales pitch.
Why Gatewood Fence & Gate Is Tigard’s Preferred Gate Access Control Company
This is not a franchise operation. Hal Gatewood’s name is on the shop, his address is published, and his cell number gets handed out like a business card. That matters in a town like Tigard, where half the service calls we take are from homeowners who got burned by a national outfit that quoted one price on the phone and showed up with another number on the invoice.
Tigard customers call us because we show up in the window we promised and we don’t swap parts that don’t need swapping. The 90-Day Done Right Promise is stamped in writing on every job. If it’s not right, one call brings us back. No runaround, no fine print. We’ve been doing it this way since 2001.
Response time to Tigard neighborhoods like Greenburg, Metzger, and the Durham Road corridor is typically same-day for access control failures. If a keypad is dead or a gate won’t open from your phone and you’re blocked out of your own driveway, we treat that as urgent. A live person answers 24/7, and we dispatch from the Portland office straight to your street.
Our Gate Access Control Services in Tigard
Keypad Entry
Most Tigard keypad installs we do are retrofits on gates that were never wired for access control. The original builder ran power to the operator, maybe, but nobody thought to stub out low-voltage conduit for a keypad. We surface-run conduit clean along the post or bore a retrofit pocket through the post cavity, then match the keypad finish to your existing hardware so it doesn’t trigger an HOA architectural review. A typical keypad entry retrofit in Tigard runs $425-$780 including the keypad, wiring, and programming.
Remote Control
Adding or replacing remotes on a Tigard gate usually means matching the receiver to the operator brand. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, so we’re not guessing at compatibility. If your remote worked last week and quit today, the fix is often a failing receiver board or a blown fuse from wet-season moisture, not the remote itself. Replacement remotes and receiver programming run $95-$225 depending on the brand and how many you need programmed.
Phone Entry
Phone entry systems are growing fast in Tigard’s HOA subdivisions because they let a homeowner buzz a visitor in from a cell phone without walking to the gate. The catch: most of these gates were built in the 1980s and ’90s with no low-voltage wire run to the post. We handle the full retrofit, including the cellular or VoIP module, wiring, and programming so the system talks to your phone. Plan on $650-$1,350 for a phone entry retrofit that includes the conduit run and programming.
Card Reader
For Tigard properties with multiple users, a card reader or fob system stops the code-sharing problem that happens when a keypad code gets passed around a neighborhood. We install standalone card readers and tie them into existing operators from DoorKing, Viking, and Elite. A basic card reader install starts around $500-$900, and we program the cards with you on site so you know exactly who has access.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Tigard
We’re certified to service nine major gate brands, but the ones we see most in Tigard tract homes are Viking, DoorKing, and Elite. These builders-grade operators were often undersized for the job from day one, especially on wood privacy gates that soak up Willamette Valley moisture and gain weight every winter. We keep common boards, remotes, and receivers stocked for Tigard calls so we’re not waiting on a parts shipment while your gate sits open. If it’s a Viking gearbox or a DoorKing loop detector, we usually have it on the truck.
Common Gate Access Control Problems We See in Tigard Homes
- Winter operator faults from wet posts: Saturated soil through the October-to-April wet season rots wood hinge posts at the ground sleeve, tilting the post and pulling the operator out of alignment. The safety photocells trip and reset every cycle, and you’re standing there holding the remote like it’s the problem. It’s not. The post is.
- Builder-grade operators failing early: Tigard subdivisions built between 1975 and 1995 went up fast, and many got undersized 1/2 HP swing operators. When the original cedar or Douglas fir gate absorbs water and gains weight, the operator’s gearbox burns out or the internal clutch trips repeatedly. The operator didn’t fail because it’s cheap. It failed because the gate got heavier than the operator was ever rated for.
- No low-voltage wiring for retrofit: Manual gates installed during the build wave were never roughed in with conduit. Adding a keypad, card reader, or phone entry means running surface conduit across a sidewalk or driveway unless we can bore a retrofit pocket through the post. We do both, but the job is different than a new-build install.
- HOA architectural review issues: In Tigard’s planned subdivisions, CC&Rs often specify gate materials, heights, and finishes. A homeowner who replaces a cedar gate with a metal one without approval can trigger a variance review. We match hardware finishes and materials so the repair flies under the review threshold.
Pricing for Gate Access Control in Tigard, OR
Keypad entry retrofits in Tigard run $425-$780. Phone entry systems with conduit runs are $650-$1,350. Card readers start around $500-$900. Full operator replacements on a standard single swing gate run $950-$1,850 including labor, and that number goes up if the hinge post needs to be re-set first. The price you’re quoted is the price you pay. We agree on the number before any work starts, and it’s in writing. Estimates are free, there’s no trip charge inside Washington County, and we take $40 off any repair over $200. Seniors and veterans get a standing 10% discount. Call (877) 610-2993 and we’ll give you a straight number.
We Also Serve Cities Near Tigard
If you’re in Garden Home-Whitford, Beaverton, Cedar Hills, or Raleigh Hills, you’re still in our service area. We run calls through the whole Tualatin River basin side of Washington County, so your gate access problem won’t wait just because you’re one ZIP over.
Serving Tigard, OR - Our Local Coverage Area
We’re based in the Tigard area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Tigard
It depends on your HOA’s CC&Rs, but in most Tigard subdivisions built between 1975 and 1995, architectural review is required only for changes to visible materials, heights, or gate styles, not for adding a keypad or card reader to the existing post. Adding a keypad or phone entry that matches your current hardware finish usually does not trigger a review. Replacing the gate panel or changing the material from wood to metal often does. We route wiring through existing post cavities and match finishes specifically so your access control upgrade stays below the review threshold. If you’re unsure, call (877) 610-2993 and we’ll help you read what the CC&Rs actually say before you spend a dollar.
In most Tigard cases we see, the operator is faulting because the hinge post has rotted at the ground sleeve from Willamette Valley wet-season saturation, letting the post tilt and bind the gate. When the gate binds against the strike, the safety photocells trip and the operator resets, which looks like an electrical problem but is actually a structural one. Fixing the post first, then re-truing the panel, solves the fault without replacing the operator. If the operator has been cycling against that bind for multiple winters, the gearbox may already be damaged. Call (877) 610-2993 and we’ll diagnose it on site, not over the phone.
Yes, but it requires a retrofit conduit run because Tigard gates built in the ’80s and ’90s were rarely stubbed out for low-voltage wire. We surface-run rigid conduit across the driveway or bore a retrofit pocket through the post cavity, then pull the wire clean and terminate it properly. The job takes a half day to a full day depending on the run. A typical phone entry or video intercom retrofit in Tigard runs $650-$1,350 including conduit, wiring, and programming. Estimates are free, so call (877) 610-2993 and we’ll give you the exact number for your driveway.
A manual-to-automatic upgrade in Tigard starts with the post. If the hinge post is original and has been sitting in saturated soil since the Reagan administration, it needs to be excavated, re-set in a deeper concrete footing, and checked for plumb before any operator gets mounted. From there we install the operator, run low-voltage conduit for keypad or remote control, mount safety photocells and a loop detector if needed, and set the travel limits. Plan on $1,200-$2,400 for the full conversion depending on gate size, operator brand, and how much post work is required. The operator brand matters less than the post it’s bolted to. Call (877) 610-2993 for a free measure and written price.
With proper weather sealing and a galvanized post plate, a keypad or card reader in Tigard typically lasts 7-10 years before moisture intrusion becomes a problem. Phone entry and video intercom modules last 5-8 years depending on exposure. The component that fails first in Tigard is almost never the electronics, it’s the wood post they’re mounted to. When the post rots at the ground sleeve, every component bolted to it shifts out of alignment and starts misbehaving. We’ve re-set posts where the original keypad was still working fine at 12 years old. If you’re seeing intermittent faults, call (877) 610-2993. The diagnosis is free, and the fix is usually smaller than you think.
Call Gatewood Fence & Gate for Gate Access Control in Tigard
If your gate won’t open from the keypad, the operator faults out every time it rains, or you want phone entry so you can buzz someone in from the couch, call (877) 610-2993. A live person answers. We’ll give you a free estimate in writing, and the price we quote is the price you pay. Hal Gatewood’s name is on the shop and on every invoice. The shop is down the road, not three states away. That’s the oldest accountability there is.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Tigard since 2001.