Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Spokane
Gate access control in Spokane means keypads, card readers, phone entry, and video intercoms that keep working through basalt bedrock installs and -10°F winter nights. Most Spokane systems we service fail because the post underneath moved, not because the electronics quit. We’re Gatewood Fence & Gate, and Hal Gatewood has been fixing gates since 2001, with a live person answering the phone 24/7 at (877) 610-2993. Spokane’s frost heave and basalt rock create access control problems that a Sacramento or Dallas installer has never seen. We deal with them every week.
Why Gatewood Fence & Gate Is Spokane’s Preferred Gate Access Control Company
Hal Gatewood’s name is on the shop and on every invoice. That’s the oldest accountability there is. When a Spokane homeowner calls about a keypad that stopped reading codes after the ground thawed, the person who shows up knows what South Hill basalt does to a post set at 14 inches. We’re not guessing.
Spokane customers call us because we repair what others want to replace. A Viking keypad that shorts out after snowmelt doesn’t always need a new keypad. Sometimes it needs a properly drained conduit and a re-seated connector. We’ll tell you the difference and charge accordingly. Every job carries our 90-Day Done Right Promise in writing. If it’s not done right, one call brings Hal back. No runaround.
We serve Spokane from Dishman to Country Homes to Opportunity and Spokane Valley. Dispatch is coordinated from our Seattle office, but the crews working Spokane gates live here and know these yards. A live person answers around the clock, not a voicemail, not a chatbot. You call, a person picks up. That matters when your gate won’t open and your car is stuck inside at 6:40 on a Tuesday morning.
Certified on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, we stock common parts for Spokane’s most-installed openers. Background-checked, uniformed, and background-checked again. We show up in the window we promised.
Our Gate Access Control Services in Spokane
Here’s what we install, repair, and upgrade across Spokane. Every system starts with the same question: what’s the gate doing, and what’s the ground under it doing?
Keypad Entry
A keypad in Spokane has to survive more than rain. It has to survive freeze-thaw cycles that push its mounting post an inch out of plumb every winter. On the South Hill, the post often can’t go deeper than a foot because of basalt. We surface-mount or core-drill depending on the bedrock, then wire the keypad through sealed conduit that drains, not traps. Keypad entry in Spokane typically runs $450 to $1,200 installed, depending on whether a new post footer is needed and how far the wire run goes from the keypad to the operator board.
Remote Control
Remote controls work until interference or a failing receiver board makes them work half the time. In Spokane’s older neighborhoods with detached garages and long driveways, we see receiver range issues caused by metal siding, stacked stone, and the occasional homemade Faraday cage of a stucco-over-mesh house. We diagnose before we sell you a new remote. A new remote programmed and tested runs $60 to $150. A receiver board replacement runs $200 to $400.
Phone Entry
Phone entry systems let you buzz visitors through from your cell, which matters on Spokane lots where the gate is 150 feet from the house and you don’t want to walk out in February. We install and service GSM-based units that work off a SIM card, no landline needed. Phone entry in Spokane runs $650 to $1,500, depending on the controller and whether we’re tying into an existing operator or starting fresh.
Card Reader
Card readers take the same beating keypads do, with the added annoyance of a misaligned reader missing badge swipes entirely. On Spokane commercial gates and HOA entrances, a tilted stanchion from frost heave is the usual culprit. We re-anchor and re-align the reader, then test it with your actual cards. Card reader installation runs $600 to $1,600 in Spokane, plus the reader hardware. Repairs and re-alignment run $150 to $400.
We also handle video intercoms and smart access systems that integrate with phone apps. Smart access packages in Spokane start around $1,200 and go up with camera count and wiring complexity.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Spokane
We service Linear, Viking, Ghost Controls, and DoorKing systems, among others, and stock the parts Spokane calls actually need. Linear keypads and receivers are common on North Side ranches. DoorKing shows up on commercial and HOA gates in the Spokane Valley. Ghost Controls pops up on older slide gates that someone installed ten years ago and then forgot about until the snow bent the track. We keep replacement boards, loops, and photocells on the truck, so a repair in Spokane doesn’t mean waiting a week for a part from Georgia.
Common Gate Access Control Problems We See in Spokane Homes
- Frost heave shifting the hinge post. When the post moves, the swing gate drags, and the loop detector under the driveway starts misreading vehicle presence. The gate thinks your car is still in the detection zone when it isn’t, so it refuses to close or reverses at the wrong time. We fix the post, not just the loop sensitivity.
- Basalt blocking deep post footings. On the South Hill and parts of 99203, standard augering hits rock before you reach a proper depth. That’s why we quote core drilling as a separate line item on Spokane jobs. A keypad or card reader stanchion set too shallow will tilt within two winters.
- Snow and ice bending slide gate hardware. Spokane averages over 40 inches of snow a year, and when that snow freezes and gets driven over, it can bend rack and pinion hardware and overload the operator board until it locks out. We see this every January on V-track cantilever slides in north Spokane.
- Summer heat warping panels and misaligning photocells. Above 95°F, gate panels move. A photocell that was perfectly aligned in May can throw a false obstruction signal in July. The gate reverses for no visible reason. We re-align and then add a little mechanical clearance so it survives the next heat wave.
Pricing for Gate Access Control in Spokane, WA
Here’s what Spokane homeowners actually pay, in real ranges. A basic keypad on an existing gate runs $450 to $800. Adding a card reader to the same gate runs $600 to $1,200. A full phone entry system with a new controller runs $650 to $1,500. Video intercoms start around $1,200. Loop detector replacement under a Spokane driveway runs $350 to $800, and safety photocell replacement runs $180 to $350 per pair.
What moves the price in Spokane: whether we hit basalt and need to core-drill, how far the conduit run goes from the keypad to the operator, and whether the existing post is still plumb or needs re-anchoring. Every job is quoted in writing before any work starts. You’ll know the number before we touch a tool. We offer $40 off any repair over $200, no trip charge inside Spokane County, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. Call (877) 610-2993 for an exact quote. Estimates are free.
And about that fear of a bigger invoice at the door: we don’t do that. Our price is agreed upfront, written down, and it doesn’t change unless you add scope. Hal Gatewood has been doing this since 2001, and his reputation in Spokane is worth more than padding a bill.
We Also Serve Cities Near Spokane
Our Gate Access Control work covers Spokane and the surrounding communities: Dishman, Country Homes, Opportunity, and Spokane Valley. If you’re in one of those towns and your keypad stopped working, call the same number. We run the same response times there as we do inside Spokane proper, and you’ll still get a live person when you call. See what we do across Spokane and nearby areas any time.
Serving Spokane, WA - Our Local Coverage Area
We’re based in the Spokane area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Spokane
Your keypad stops working every spring because snowmelt gets into the wiring, shorts a connector, and the freeze-thaw cycle has already shifted the post enough to pull a wire loose. In Spokane, spring means water sitting in conduit that wasn’t sealed for our climate, plus a keypad that took 40 inches of snow against its face all winter. We find water in the junction box, corrosion on the board, or a wire pulled out of its terminal. The fix is sealing the conduit properly, replacing the damaged connector, and re-anchoring the post. Call (877) 610-2993 and we’ll sort it in one visit.
Yes, we can install a keypad on the South Hill even with basalt at 12 to 16 inches. On a South Hill property in 99203, our crew replaced a corroded Viking keypad entry post for a swing gate that had heaved after a winter of freeze-thaw cycles. The auger hit basalt at 16 inches, so we switched to a core-drilled post footing and surface-mounted the new keypad, wiring it to a LiftMaster operator with a fresh loop detector and safety photocells. Spokane’s basalt means core drilling or surface-mount anchoring, not standard augering, and we quote that work upfront.
The cause is almost always snow and ice bending the track or rack hardware until the operator board overloads and locks out. North Spokane slide gates catch the full snow load, and when a car drives over frozen buildup next to the track, the gate binds. The board draws more current than it’s rated for and trips its protection. We clear the track, straighten or replace the bent rack, re-set the board, and adjust the force limits so a normal snow event doesn’t kill the gate mid-February. Call us before you replace the operator. Most of these are repairable.
Your loop detector fails to sense your car because frost heave shifted the gate post or the driveway moved enough to change how the loop reads your vehicle. When the post tilts even a few degrees, the gate’s distance from the loop changes, and the detector’s sensitivity setting is no longer right for that geometry. We re-level the post, re-seat the loop in the driveway cut if needed, and re-tune the detector. Sometimes we also find a loop wire that got nicked during a past pavement patch. We’ll diagnose it on site. The phone number is (877) 610-2993.
You prevent sag by making sure the hinge post is anchored below the frost line, not by adjusting the gate panel. In Spokane, frost depth can exceed 24 inches, so any post set shallower will heave, skew the frame, and the gate will drag. If the post is in rock, we core-drill. If it’s in soil, we go deep and use concrete that can handle freeze-thaw. We also inspect the hinge plate welds, because that’s the second failure point after the post moves. A gate sags in the hinge post, not in the middle, and that is where we start. Call us for a free estimate and we’ll tell you exactly what your post situation looks like.
Call Gatewood Fence & Gate for Gate Access Control in Spokane
If your Spokane gate keypad, card reader, phone entry, or video intercom isn’t working the way it should, call (877) 610-2993. A live person answers, day or night. We’ll schedule a time that works, show up when we say we will, and quote the job in writing before any work starts. Hal Gatewood has been doing this since 2001, and the name is on the shop. That’s the kind of accountability you get when you hire someone who isn’t passing through.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Spokane since 2001.