Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Fast, Reliable Gate Access Control Across Rialto
If you’re searching for gate access control in Rialto, here’s the short answer: we install and repair keypad entry, phone entry, card readers, and smart access systems throughout 92376 and 92377, usually with same-week scheduling. Gatewood Fence & Gate has been owner-operated since 2001, and Hal Gatewood’s name is on the shop and on every invoice. We answer the phone with a live person, 24 hours a day. Call (877) 610-2993 and you’ll get a straight answer about your gate, not a script.
Rialto sits in a strange spot for gate work. The I-10 corridor south of Baseline packs in Amazon, UPS, and BNSF intermodal facilities whose slide gates run 50 or more cycles a day. Two miles north, you hit quiet tract home neighborhoods off Riverside and Alder where a 1980s wrought-iron swing gate has been opening the same way for 40 years. Very few companies in San Bernardino County are set up to handle both ends of that spectrum well. We are.
Why Gatewood Fence & Gate Is Rialto’s Preferred Gate Access Control Company
When a gate keypad fails on a warehouse off Valley Boulevard, the owner can’t just shrug it off. Every hour that gate stays open is an hour of unbilled loading work. The same goes for a homeowner off Cactus Avenue whose phone entry stopped recognizing calls at 8 p.m. on a school night. We treat both with the same urgency. Hal has been working gates since 2001 and still gets irritated when he finds sloppy wiring someone left behind. That irritation is the reason our 90-Day Done Right Promise is stamped in writing on every job.
Rialto customers call us from two zip codes and about a dozen distinct neighborhoods. We’re familiar with the older Rancho West and Las Colinas homes where original 1980s surface-mount keypads sit inches from sprinkler overspray. We also know the north Rialto developments, the ones clustered near the 210, where builder-grade operators came with the tract and underperform from day one. Local knowledge isn’t a marketing line with us. It’s the difference between replacing a keypad twice and fixing the hinge post the first time.
Licensed, insured, and bonded, with a published address in the Inland Empire. The person who shows up is background-checked and wears a uniform. The person who answers the phone at 2 a.m. is the same person you’ll see at the hardware store. That’s not a gimmick. It’s how Hal runs things.
Our Gate Access Control Services in Rialto
Here’s what we actually do in Rialto, week in and week out. This isn’t a list from a national franchise. It’s the work that keeps Rialto gates opening and closing.
Keypad Entry
We install and repair keypad entry systems on residential swing gates across 92376 and 92377. The most common issue we see on Rialto’s 1970s-1990s homes is not the keypad itself. It’s the ribbon cable behind it. Hard water from the San Bernardino basin aquifer wicks into the housing, corrodes the pins, and you get “phantom” codes where the gate opens without anyone pressing a button. We replace the cable, seal the housing properly, and test under load. A typical replacement keypad install in Rialto runs $220-$380, and we’ll tell you if the keypad isn’t actually the problem.

Remote Control
When a remote stops reaching the receiver on a Rialto gate, the culprit is often the receiver antenna placement, not the remote. On houses along the Santa Ana wind corridor through the Cajon Pass, vibration loosens antenna connections over time. We test signal strength at the receiver, not at the visor clip. We service FAAC, BFT, LiftMaster, Linear, and Viking receivers, and we carry common remotes on the truck so we’re not asking you to wait on a mail-order part. Remote pairing or replacement in Rialto typically runs $75-$190.

Phone Entry
Phone entry systems let a caller ring your cell phone and press a button on the keypad to open the gate. On Rialto’s newer tract homes, builders often install these without a proper network path, leaving the cellular dialer mounted inside a metal enclosure where it can’t get signal. Or the power run was never put in the original build, so the unit runs off a low-voltage run that sags under load. We correct the wiring, position the dialer where it gets signal, and make sure the gate actually closes after the call. Phone entry installation in Rialto runs $550-$950 for a complete system.

Card Reader
Card readers make more sense in Rialto than people think. If you’ve got a multi-car household or an ADU tenant off a shared driveway, a card reader means no codes to remember and no app to babysit. We install them on both residential swing gates and commercial slide gates. The difference is the reader environment. Near BNSF, dirt and diesel grit foul reader heads fast, so we use dielectric grease and sealed housings. A basic card reader add-on for a residential gate in Rialto runs $300-$520 including the first two cards.
We also handle Gate Access Control for video intercom and smart access, including app-based systems that let you open the gate from anywhere. If a full access control retrofit makes sense for your Rialto property, we’ll tell you plainly. If a $350 keypad repair will do the job, we’ll tell you that too.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Rialto
We’re certified to service nine major gate brands, and in Rialto we work most often on FAAC, BFT, and Linear operators, plus the builder-grade DoorKing units that came spec’d in 1980s tract homes. Because we service rather than just swap, we keep a meaningful inventory of boards, limit switches, gear motors, and remotes in our Inland Empire shop. For Rialto customers, that means a failed FAAC gear motor doesn’t strand your gate for two weeks while someone waits on a supplier. If the part exists in our shop, it goes on the truck. If not, Hal will tell you the honest lead time before we start.
Common Gate Access Control Problems We See in Rialto Homes
- Intermittent keypad response after wind events. The Santa Ana winds that push down through the Cajon Pass apply lateral stress to gates and vibrate wiring connections. In many Rialto homes, the keypad ribbon cable is already compromised by hard water, and the wind pushes it over the edge from flaky to dead.
- Builder-grade operators that never close fully. Rialto’s newer developments north of the 210 often came with low-duty-cycle slide operators intended for light use. Add a family with three cars and a delivery driver or two each day, and the operator’s limit switches drift so the gate stops a few inches short of the post. We reset and recalibrate, and if the motor is undersized, we say so.
- Solar operators on exposed 92376 perimeter gates that underperform. This is almost always a missing conduit run from the original build. The Exposed DC wiring degrades under triple-digit UV, and the Santa Ana vibration compounds the damage. We rerun the wiring in sealed conduit and rewire the solar input properly.
- Commercial slide gates near BNSF that stay open or reverse mid-cycle. The constant truck traffic and fine dirt from the intermodal yards foul the loop detector field. Gates stall open because the detector can’t see a vehicle at the right threshold. We clean or replace the loop and recalibrate the sensitivity for a high-traffic surface.
Pricing for Gate Access Control in Rialto, CA
Every job gets a written quote before we touch a tool. Here’s what Rialto pricing actually looks like, based on the work we’ve done across 92376 and 92377.
| Service | Typical Rialto Range |
|---|---|
| Keypad replacement or repair | $220-$380 |
| Remote replacement or pairing | $75-$190 |
| Phone entry system install | $550-$950 |
| Card reader add-on | $300-$520 |
| Smart access retrofit (app-based) | $650-$1,200 |
| Commercial slide gate operator service (BNSF corridor) | $350-$1,800 depending on operator class and parts |
Two things drive cost in Rialto more than anywhere else nearby. One, the age of the wiring. A 1980s home whose original gate conduit is still in place often needs a new low-voltage run before a keypad or phone entry will work reliably. Two, the duty cycle. A gate that runs 50 times a day wears limit switches and gear motors fast, and the parts aren’t the cheapest on the shelf. We don’t pad the invoice. We show you the part cost, the labor, and the exact scope. And the price we quote is the price you pay, agreed before any work starts. Call (877) 610-2993 for a free estimate.
We Also Serve Cities Near Rialto
Our crews work throughout the Inland Empire, and if you’re in Bloomington, Fontana, Muscoy, or San Bernardino, you’re still close enough that we’ll be there without the runaround. We built our reputation one gate at a time across this part of San Bernardino County, and we’re glad to take a look at yours. Learn more about Gate Access Control in Rialto or ask us about service in a neighboring city when you call.
Serving Rialto, CA - Our Local Coverage Area
We’re based in the Rialto area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Rialto
The wind event is the symptom, not the cause. Santa Ana winds from the Cajon Pass vibrate the gate and its wiring, but the keypad was likely already compromised by hard water corrosion in the ribbon cable or a loose connection at the receiver. The wind just finishes the job. We see this pattern in Rialto homes built from the 1970s through the 1990s more than anywhere else in the county. Call (877) 610-2993 and we’ll test the actual wiring, not just hand you a new keypad.
It’s common, but it’s not normal. The operator’s limit switches were calibrated once, probably at install, and daily use plus summer heat expansion knocks them out of spec. The gate stops a few inches short or reverses because the operator thinks it hit an obstruction. It’s a calibration and limit switch issue, not a failed motor. Call (877) 610-2993 and we’ll recalibrate it and check the settings against your actual gate weight.
Every 6 to 8 months. Slide gates near Rialto’s logistics parks run 50 or more open/close cycles a day. Gear motors and limit switches on that duty cycle burn out in 18 to 24 months unless they’re caught early. A semi-annual service catches the wear before your gate strands a truck at the apron. We service the BNSF corridor for local businesses, and we’ll schedule you on a calendar, not just come out when it breaks. Call (877) 610-2993 to get on the schedule.
Yes, and we do it a lot in 92376 and 92377. The hinge posts on those gates have often been seized by hard water for years, so we check the post and hinge condition before we mount an automation system. A keypad on a gate that can’t move freely will burn out the motor. We’ll tell you if the post needs work first, and we’ll give you a price for the whole job before we start. Typical manual-to-automated conversion in Rialto runs $1,400-$2,800 including the keypad and operator.
Not necessarily. The motor runs, so it’s usually the gearbox or the hinge. On Rialto’s older swing gates, that’s almost always the hinge post. Hard water seizes the hinges over 30 or 40 years, and the motor stalls against the resistance. We pull the post, set a new one in concrete, and correct the sag. Sometimes the gearbox is worn too, but we’ll show you the failed part before we quote the repair. Call (877) 610-2993 and we’ll diagnose it in person.
If your gate access control isn’t doing what it should, call (877) 610-2993. You’ll get Hal or someone who works directly for him, a straight answer, and a written price before any work starts. Free estimates. No trip charge inside the county. And every job carries the 90-Day Done Right Promise in writing.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Rialto since 2001.





Before
After
Before
After
Before
After