Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Farragut
Gate access control in Farragut usually means one of three things: a keypad that stopped reading codes after a winter freeze, a community entrance system the HOA needs upgraded without angering the architectural committee, or a homeowner who wants phone entry on a 25-year-old ornamental iron gate. Most Farragut jobs take us half a day, and we stock the boards, keypads, and safety edges for the brands this town actually runs. Call (877) 610-2993 and you’ll reach a live person who knows the difference between a DoorKing slide operator from 1998 and the current model.
Why Gatewood Fence & Gate Is Farragut’s Preferred Gate Access Control Company
Hal Gatewood has been working on gates since 2001, and a big part of that work in Farragut has been un-engineering the shortcuts somebody else left behind. Farragut’s subdivisions went up fast in the 1990s and 2000s, and a lot of the original gate access installs were done by crews that are long gone. We see the same patterns over and over: boards wired with the wrong gauge, keypads caulked over rust, safety eyes bypassed because the photo beam kept tripping. Fixing the access system properly means fixing the hardware underneath it too, because a new keypad bolted to a dying operator is just a new keypad over the same problem.
Our crew works Farragut regularly, from 37934 and the corridor along Kingston Pike out to the lakefront streets near Fort Loudoun. Dispatch is coordinated from our Memphis office, but the technicians who show up in Farragut live and work in East Tennessee. We answer the phone 24/7, and the person who picks up can tell you whether we have a Linear control board on the truck or need to grab one from the shop. Every job carries the 90-Day Done Right Promise in writing, and we offer a free second opinion on any written estimate the moment a homeowner feels something sounds off.
Our Gate Access Control Services in Farragut
Farragut’s gate access work splits into two worlds: single-family driveway gates and shared community entrance systems. Both run on the same fundamentals, but the HOA world adds a layer of coordination that changes the whole workflow. Here’s what we handle most often in Farragut.
Keypad Entry
Keypad entry is the workhorse of Farragut gate access, and the keypads in this town are often 15 to 25 years old. Codes stop working, buttons wear out, and water gets behind the faceplate during East Tennessee’s freeze-thaw cycles. We replace keypads with units that match the original footprint whenever possible, because Farragut’s HOA boards often want the visible hardware to look the same as it did in 1998. In Farragut, a basic keypad replacement typically runs $250 to $450 installed, and a full keypad plus receiver upgrade runs $450 to $750.
Phone Entry
Phone entry is common on Farragut’s community gates and on larger lakefront estates off Choto Road and Concord Road. An entry panel calls a homeowner’s cell phone or a house line, and the homeowner buzzes the gate open. The tricky part on older Farragut properties is that the original phone entry systems were analog, and the new cellular and VoIP replacements need a different wiring path. We’ve done enough of these conversions in Farragut to know which panels play nice with AT&T and T-Mobile coverage out here. Phone entry systems for a single gate in Farragut usually run $600 to $1,400 installed, depending on whether the existing wiring can be reused.
Video Intercom
Video intercom keeps coming up in Farragut, particularly from homeowners who bought a place in a subdivision like Saddle Ridge or Farragut Commons and want to see who’s at the gate before buzzing them in. Most of the 1990s-era operators in Farragut can support a video intercom add-on, but the wiring matters: we check whether the original install left spare conductors or whether we need to run new low-voltage line. A single-family video intercom with a gate release in Farragut typically runs $900 to $1,800, and the work is scheduled, not same-day dispatch.
Card Reader
Card readers are everywhere on Farragut’s commercial and HOA common gates. The most common call we get is a reader that suddenly stops accepting cards that worked last week, which usually traces back to a ground fault, a failing power supply, or a board that lost its programming. On Farragut’s older DoorKing and Viking systems, we’ll often recommend a card reader retrofit that keeps the existing operator but updates the reader to handle modern proximity cards. Card reader replacement in Farragut runs $400 to $1,000 depending on the operator type.
We also handle gate access control repairs on brand-new installs that were never configured right, and we’ll fix the work other companies walked away from.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Farragut
We’re certified on the major gate access control brands, and in Farragut that mostly means Linear, Viking, Ghost Controls, and DoorKing. Those four names cover the overwhelming majority of residential and small-HOA gates in this town. We keep common parts for these brands stocked, which means a Linear board swap or a DoorKing receiver does not turn into a two-week wait. When we do need a specialty part, we know which suppliers actually have legacy stock in the Southeast, not just what shows on a website. That matters in Farragut more than most places, because these HOAs want the replacement hardware to look and function like the original install.
Common Gate Access Control Problems We See in Farragut Homes
Farragut’s climate and housing stock create a specific failure pattern. These are the problems we get called out for most often:
- Ice-locked operators. East Tennessee winter ice storms coat slide gate tracks, hinges, and photocells with freezing rain. The operator tries to force the gate open against frozen hardware and burns out its own motor. We see this every January in Farragut, and the fix usually involves replacing the operator and adding a heater strip or track dam where the ice accumulates.
- Discontinued control boards. The LiftMaster and FAAC-era boards installed during Farragut’s 1990s and 2000s subdivision boom are reaching end-of-life at the same time. A community gate off Cedar Bluff or Parkside Drive might have a board that was discontinued in 2012. We track down exact legacy replacements or spec a current equivalent that fits the same enclosure, so the HOA doesn’t get surprised by a visual mismatch.
- Rust at weld points. Farragut’s summer humidity, especially on properties near Fort Loudoun Lake, accelerates rust where ornamental iron welds meet the hinge post. When rust takes hold, the gate starts binding, and the access control system works harder because the gate is fighting the hardware. We cut out and reweld the bad section on site, so the gate keeps working without a full replacement.
- Keypad faceplates that fail the freeze-thaw cycle. Farragut gets enough freeze-thaw cycles in a typical winter that water seeps behind keypad and intercom faceplates, freezes, expands, and cracks the plastic or pops the seal. A keypad that works fine in September can be dead by February. We reseal and reflash when we install, which is a detail a lot of the original subdivision installs skipped.
Pricing for Gate Access Control in Farragut, TN
Farragut’s access control pricing reflects two realities: the hardware is often aging and needs more than a bolt-on fix, and HOAs may require specific finishes or footprints that limit which parts we can use. A straightforward keypad replacement in Farragut runs $250 to $450. A keypad with a new receiver runs $450 to $750. Phone entry runs $600 to $1,400. Video intercom runs $900 to $1,800. Card readers run $400 to $1,000. A full HOA community entrance upgrade with new operator, phone entry, and video intercom can run $3,500 to $9,000 depending on the gate size and wiring condition. Every price is quoted and agreed in writing before any work starts, and the estimate we give is the price you pay. We also offer $40 off any repair over $200, no trip charge inside the county, and a permanent 10% discount for seniors and veterans. Call (877) 610-2993 for a free estimate.
We Also Serve Cities Near Farragut
Our access control work takes us all over the Knoxville metro. We serve Farragut and the surrounding areas including Lenoir City, Alcoa, Knoxville, and Oak Ridge. If your gate is in one of those communities and you’re dealing with an HOA board that wants documentation, call us. We know how the local covenants read and what gets approved.
Serving Farragut, TN - Our Local Coverage Area
We’re based in the Farragut area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Farragut
Yes, in many Farragut subdivisions you need written architectural committee approval before changing any visible gate access hardware, including a keypad or intercom faceplate. The town’s 1990s and 2000s subdivision boom standardized ornamental gate aesthetics, and many HOAs still enforce the original specs. We recommend you pull your covenant documents and submit the request with photos of the proposed hardware before we schedule the swap. We’ll document the original specs with photos too, which helps the board see exactly what’s changing. Call (877) 610-2993 and we’ll walk you through what the committee usually asks for.
Likely, but it depends on the operator model and what your HOA approved originally. Many Farragut covenants specify a particular powder-coated finish on operator housings, and a mismatched housing color is a common violation notice trigger. We match the existing finish and can document the exact color code for the HOA file before installation. In the Saddle Ridge subdivision, our crew replaced a failing DoorKing slide gate operator on a community entrance and matched the existing powder-coated finish on the operator housing, coordinating with the HOA’s management company throughout. We also photographed the original keypad entry faceplate before swapping it, because the board required pre-approval on any visible access control change. That workflow is standard for Farragut.
Yes, we do it regularly. For community entrance gates in Farragut, the workflow is different than a residential job: we review the HOA’s architectural guidelines, identify what hardware is visible and subject to approval, and document the existing specs with measurements and photos. Then we coordinate with the property manager or board liaison to get written sign-off before we order parts or touch the gate. This can add a week or two to the timeline, but it prevents a mismatched part from becoming an HOA violation notice and a do-over. Call (877) 610-2993 and we’ll help you build the submission package.
Usually it’s both. When freezing rain coats a keypad in Farragut, the immediate problem is that water has gotten behind the faceplate and frozen, which cracks seals and shorts the contact points. But the root cause is often a missing or degraded weather seal and a faceplate that was never properly flashed. We replace the keypad and reseal the mounting surface, and on repeat offenders we’ll add a small heater strip or weather hood. If the keypad freezing is paired with a gate that won’t move, check whether the operator was trying to force the gate against ice-locked hardware, because that’s how Farragut operators burn out. Call (877) 610-2993 for a diagnosis and a fixed price.
Most 20-year-old swing gate operators in Farragut can support a video intercom add-on, but the limiting factor is usually wiring, not the operator itself. The original installs from the 1990s and early 2000s often used thin low-voltage cable with no spare conductors. We check the cable gauge and conductor count before recommending a specific video intercom, and if the wiring can’t carry the new system we’ll run new line. Some of the oldest Viking and DoorKing boards also need a relay adapter to talk to a modern intercom. A video intercom retrofit on a Farragut swing gate typically runs $900 to $1,800 installed, and the work is scheduled, not same-day dispatch. Call (877) 610-2993 for a free measure and written quote.
If your gate access system in Farragut is acting up, not reading codes, or your HOA is asking for documentation on a proposed upgrade, call Gatewood Fence & Gate at (877) 610-2993. We’ll show up, diagnose it, and give you a written price before any work starts. The name is on the shop, and the shop is down the road, and that’s the oldest accountability there is.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Farragut and the surrounding communities since 2001.