Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Fast, Reliable Gate Access Control Across Dixon
Gate access control in Dixon means keypads, remotes, phone entry, card readers, and video intercoms wired into a gate that has to survive the Delta breeze. We fix and install all of it, usually the same day we hear from you. For Gate Repair in Dixon, we’re often on-site within hours. If your gate opener stopped listening to the remote after last week’s wind, or the keypad on the dairy gate won’t lock anymore, call (877) 610-2993 and Hal or one of his crew will be out to Dixon fast.
The Gate Access Control work we do here leans heavy on retrofit: older boards, worn posts, gates hung before modern safety rules existed. We don’t sell you a whole new system when a control board and two hours of honest wiring gets you back to working. That’s how we’ve handled Gate Access Control in Dixon for a long time now, and it’s why folks around town keep our number in their phone.
Why Gatewood Fence & Gate Is Dixon’s Preferred Gate Access Control Company
Hal Gatewood’s name is on the shop, and the shop is down the road from Dixon, not three states away. That’s the oldest accountability there is. We answer the phone with a live person around the clock, not a voicemail queue. When you call at 6 a.m. because the gate won’t open and the milk truck is waiting, someone picks up.
Dixon customers deal with the same person from quote to finish. No faceless crew, no background-checked strangers who’ve never seen a dairy gate. Our uniformed techs have been background-checked, but more than that, they know what a wind-racked Viking operator on Pitt School Road looks like before they pull into the driveway.
We don’t charge a trip fee inside the county, and we give $40 off any repair over $200. Seniors and veterans get a permanent 10% discount. A free second opinion on any written estimate is always on the table. And every job carries the 90-Day Done Right Promise in writing: if it’s not done right, one call brings us back, no runaround.
Our Gate Access Control Services in Dixon
Keypad Entry
A keypad on a Dixon gate takes a beating. Sand, sun, and the daily wind cycle work on the membrane until buttons quit registering. We install weather-sealed keypads rated for exactly this, wired into your existing opener or a new one. If you’re starting fresh, we also handle Dixon Gate Installation from the ground up. On dairy swing gates around the Yolo County line, the real problem is usually the post footing loosening in sandy loam, which shifts the strike plate so the deadbolt can’t extend even though the keypad reports a valid code. We fix the post first, then the electronics, because fixing the panel without the post means you’ll fix it twice.

Remote Control
Remote range drops off when a gate frame flexes in the wind and the receiver antenna gets knocked out of alignment. We re-aim the antenna, replace pitted relay contacts in the receiver, and program new remotes on site. If your old remote still works from ten feet but not from the road, that’s usually a receiver issue, not a remote issue, and we don’t sell you a handful of new remotes hoping it helps.

Phone Entry
Phone entry systems in Dixon need a cellular connection that holds up when storms roll through the Delta. We install and service the full run: the call box at the gate, the relay to the opener, and the phone line or cellular module behind it. If you want the gate to ring your cell when a delivery truck pulls up on Pedrick Road, that’s a phone entry job, and we do it clean.

Card Reader
Card readers on Dixon properties range from simple proximity fobs on suburban driveways to full credential systems on rural commercial parcels. We wire them into the opener, set the access schedule, and make sure the reader doesn’t drift out of alignment on a gate that flexes in the wind. When the reader stops reading, it’s usually a wiring connection that vibrated loose, not the reader itself.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Dixon
We’re certified to service nine major gate brands, including FAAC, BFT, Linear, and Viking. We keep common control boards, receiver modules, and safety photocells on the truck so a Dixon call doesn’t turn into a two-trip job. If you have an older FAAC board that’s no longer manufactured, we’ll match it or retrofit a modern equivalent rather than sending you back to the manufacturer for a whole new operator.
Common Gate Access Control Problems We See in Dixon Homes
- Control boards failing from wind-driven motor stall. Dixon’s Delta wind corridor pushes gate panels laterally, which makes the motor work harder, which pulls more current through the board, which arc-pits the relay contacts and welds them. We see dead boards on operators with motors that still test fine. Board-level diagnosis is a more frequent first repair here than in sheltered neighbors like Woodland.
- Pre-UL 325 operators faulting into lockout. Gates installed on 2000s-era tract homes around Dixon often lack entrapment protection. A wind-blown panel trips a non-existent safety input, the board faults, and you’re locked out. We retrofit safety photocells and edge sensors to bring those older operators up to code, and they stop faulting.
- Solar openers draining fast on rural parcels. Solar gate openers out on the rural routes south and west of Dixon lose charge faster than any spec sheet predicts. The Delta breeze causes continuous micro-cycles against wind resistance all day, and the battery drains before the panel can recover. We upgrade the panel, the battery, or both, and adjust the close-cycle settings so the opener isn’t fighting the wind.
- Keypads and card readers going intermittent during summer heat. When Dixon hits 100°F, metal gates expand and gaps shift. A keypad that reads a valid code still can’t lock the gate if the strike plate moved. The electronics are fine; the alignment isn’t. We re-hang the gate, shim the strike, and the keypad works again.
Pricing for Gate Access Control in Dixon, CA
A keypad replacement or new keypad install in Dixon typically runs $180 to $450 depending on whether the existing wiring is usable and whether the gate post needs attention. Remote programming and receiver repair runs $90 to $220. A full phone entry system install starts around $650 and goes up with cellular module and power run distance. Card reader installation runs $250 to $600 per reader. Safety photocell retrofit on a pre-UL 325 operator runs $220 to $475, which is almost always cheaper than a new operator and keeps your gate legal. The price is quoted and agreed before any work starts. No trip charge inside the county, and $40 off any repair over $200. Call (877) 610-2993 for a free estimate.
We Also Serve Cities Near Dixon
We cover Dixon and the surrounding communities, including Davis, Winters, Woodland, and West Sacramento. If you’re just over the county line or a few miles down the road, the trip charge still applies the same way: none, inside the county.
Serving Dixon, CA - Our Local Coverage Area
We’re based in the Dixon area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Dixon
Because the wind is moving the gate panel or the post, not the keypad. The keypad reads the code fine. What fails is the lock or the strike plate on the other side. When the gate frame flexes in sustained gusts, the deadbolt can’t line up with the strike, so the keypad reports a valid code and nothing happens. We fix the post, re-hang the gate, and the keypad works in any weather. Call (877) 610-2993 and we’ll take a look.
Yes, and we do it regularly. Pre-UL 325 operators on 2000s-era Dixon tract homes have no entrapment protection, which is both unsafe and the reason the board faults into lockout when a wind-blown panel trips a non-existent safety input. We retrofit a monitored photocell pair and edge sensor, wire it into the existing board where the board supports it, or install a retrofit safety module where it doesn’t. Runs $220 to $475, and the gate stops faulting. Call (877) 610-2993 for a free estimate.
Normal for Dixon, but not inevitable. The Delta breeze makes the opener cycle against wind resistance all day, so the battery drains faster than the solar panel can recharge. When 100°F heat adds battery degradation, you get a dead opener by mid-afternoon. We upgrade the panel, replace the battery with a higher-capacity unit, and adjust the closer’s sensitivity settings so it isn’t fighting the wind every five minutes. If the issue is deeper, we also service the Gate Motor & Opener - Dixon units directly. The fix usually runs $300 to $650 depending on components. Call (877) 610-2993 and we’ll size it right.
Both, and the dairy part matters. Rural routes south and west of Dixon toward the Yolo County line have heavy livestock-rated swing gates with slam-latch hardware that almost never shows up on a suburban call sheet in Davis or Fairfield. We keep heavier hardware stock on the truck for exactly those gates. If a dairy gate post is loose in sandy loam, we dig it out and re-set it properly before we touch the electronics. Call (877) 610-2993 and tell Hal what gate you’ve got.
Probably not. If the keypad works but the remote doesn’t, the operator’s motor and logic are still functioning. What failed is likely the receiver board or the antenna wiring. We replace the receiver board, re-program the remotes, and you’re back in business for a fraction of a new operator. On a 2005 DoorKing in Dixon, we’d also check the safety photocell wiring while we’re inside the housing, because if that never got retrofitted, it’s a fault waiting to happen. Call (877) 610-2993 for a free estimate before you price out a new operator.
Call Gatewood Fence & Gate for Gate Access Control in Dixon
If your gate access control is acting up in Dixon, call (877) 610-2993. Hal or one of his crew will answer, ask what the gate is doing, and tell you honestly whether it needs a board, a post, or a whole new operator. The name is on the shop, and the 90-Day Done Right Promise is on every invoice. Free estimates, no trip charge inside Solano County, and a real person on the line right now.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Dixon since 2001.





Before
After
Before
After
Before
After