Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Weston
Gate installation in Weston isn’t like most of Broward County. Nearly every neighborhood here is a gated community, and most of those gates were built between 1995 and 2005. That means we’re not usually installing a single driveway gate for one homeowner. We’re replacing or upgrading a community entry system that an HOA board approved two decades ago, using operators that are now past their service life. If you manage or live in a Weston community and the gate is failing weekly, the fix usually isn’t another patch. It’s a proper installation, done with current safety codes, and scheduled around a board meeting. Call us at (877) 610-2993 and we’ll walk the site with you.
The gate systems across Weston are hitting end of life at roughly the same time. That’s not coincidence. The city was master-planned and built out almost entirely between the mid-1990s and mid-2000s, so thousands of Linear, Elite, and FAAC operators went into the ground within a ten-year window. Now they’re 15 to 25 years old. The wave of replacements we’re doing in Weston right now isn’t happening at this scale in Pembroke Pines, Cooper City, or anywhere else nearby. It’s a Weston problem, and we’ve been deep in it.
Why Gatewood Fence & Gate Is Weston’s Preferred Gate Installation Company
Hal Gatewood has been installing and repairing gates since 2001. His name is on the shop, his crew shows up in uniform, and when something isn’t right, one call brings him back. That matters in Weston, where most gate work funnels through HOA property managers who need a vendor they won’t have to chase. We’re on pre-approved vendor lists for several Weston communities, and we understand how Broward County permitting works for community gate systems. A technician who doesn’t know that process will get locked out of most available work here, no matter how good they are with a welder.
We answer the phone with a live person, 24 hours a day. That’s not a small thing when a gate on Bonaventure Boulevard fails at 11 p.m. and residents can’t get in. We coordinate with property managers in Weston, we show up when we say we will, and every job carries our 90-Day Done Right Promise in writing. If it’s not done right, we make it right. No fine print, no runaround.
Weston residents call us for the same reason they stick with a local mechanic. The person who quotes the job is the person who stands behind it. Hal will tell you to drive to the shop and look him in the eye if you want to. That kind of accountability is getting rare, but it’s how we’ve operated in South Florida for over 29 years.
We’re also not shy about welding on site. That changes the math on a lot of Weston gate jobs. Instead of hauling a gate off to some shop and leaving the community entry open for three days, our crew sets up in the driveway or the gatehouse lane and does the work right there. For HOAs worried about security during a replacement, that’s the difference between a one-day job and a week-long gap.
Our Gate Installation Services in Weston
Every Weston community gate is different. Some are dual-swing entries with guard booths. Some are sliding gates on racks that have worn past adjustment. Some are pedestrian gates that were installed manual and need automation added without replacing the existing posts. We handle all of it. Here’s what we install most often in Weston.
Driveway Gate
Weston has fewer single-driveway gates than most Broward cities, but the ones that exist tend to be in the estate sections of Windmill Ranch Estates and The Ridges. These are wide, heavy gates, often Spanish-style wrought iron or solid panel construction on concrete posts. We install driveway gates sized for the vehicle traffic they actually carry, not what a catalog says is standard. That means measuring the post spacing, checking the hinge weight rating, and running the right gauge wire for the operator.
Pedestrian Gate
Pedestrian gates in Weston are usually part of a larger community entry, not a standalone install. But we do a fair number of HOA jobs where a manual pedestrian gate needs automation added, usually because residents want keypad or card-reader access without staffing a guard booth. The trick is usually the existing posts. We can often add a Viking or Ghost Controls operator to the existing post structure without replacing the masonry, which saves the HOA real money. In Weston, that’s the kind of thing boards ask about specifically because they don’t want a construction project, they want the gate to work.
Sliding Gate
This is the big one in Weston. Most community entry gates here are vehicular sliding gates, and most of them ride on racks and rollers that have been in service since the Clinton administration. When we install a new sliding gate in Weston, we’re usually replacing the rack, the rollers, the operator, and the safety loop system at the same time. The gate panel itself might be fine. But the hardware underneath it is done. We also check the power run from the operator cabinet to the gate, because undersized or corroded wire from the original build is one of the most common causes of new operators stalling.
Swing Gate
Dual-swing entry gates are common at the smaller Weston communities and at estate properties on larger lots. These gates put enormous stress on the hinge posts, especially during summer storms when wind catches the gate face. We install swing gates with reinforced post brackets and operators sized for the full leaf weight, not a guess. If the gate sags, we start at the hinge post. Fix the panel without the post and you’ll fix it twice.
Security Gate
In Weston, security gate work usually means upgrading an entry system to meet current UL 325 entrapment protection standards. Older Weston gates often lack the safety photocells and edge sensors that are now required. We install security gates with modern entrapment protection, card readers, telephone-entry systems, and backup battery capacity so the gate stays operational during the afternoon thunderstorms that knock out power along Glades Parkway.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Weston
We service and install nine major gate brands, and in Weston that matters because the original buildout used commercial-grade equipment. Most communities have Linear, Elite, or FAAC operators. When we replace those, we often spec DoorKing or Viking units because they hold up to the rain, heat, and humidity we get out here at the edge of the Everglades. We also work on Ghost Controls and BFT for smaller and residential-scale gates. We keep common parts on the truck for Weston jobs, so you’re not waiting a week on a control board while the gate sits in fail-safe mode. Call us at (877) 610-2993 and we’ll tell you straight what your gate needs.
Common Gate Installation Problems We See in Weston Homes
- Builder-grade operators lacking modern entrapment protection. Many Weston community gates went in with operators that met code in 1998 but wouldn’t pass a UL 325 audit today. No safety photocells, no edge sensors, and a control board that doesn’t support them. Weston HOAs are increasingly replacing these outright rather than retrofitting, because the cost difference is small and the liability difference is not.
- Undersized power runs causing voltage drop. The original builders in Weston didn’t always run heavy enough wire from the operator cabinet to the gate. Twenty years of corrosion later, a new operator draws more current than the line can deliver, and the gate stalls or trips breakers during rainy season. We check the conduit and wire gauge before we install, not after the gate fails at 8 p.m. on a Tuesday.
- Flooded loop detector conduit. Weston sits on a high water table next to Everglades conservation land. The June through October rains regularly flood underground loop-detector conduit that wasn’t sealed during construction. When that happens, the gate thinks a car is always present and won’t close. A new operator won’t fix a flooded loop. The conduit has to be resealed or rerouted.
- Worn rack and pinion on sliding gates. A sliding gate that shudders when it moves is usually running on a worn rack. This is the single most common failure we see on Weston community gates that are 15 to 25 years old. The operator may still be fine. The mechanical wear is in the rack teeth, and replacing just the operator leaves the underlying problem in place.
Pricing for Gate Installation in Weston, FL
A sliding gate operator replacement in Weston typically runs $1,800 to $3,400 depending on the gate weight and whether we’re replacing the rack and rollers at the same time. A full sliding gate installation, including new rack, rollers, operator, safety photocells, and loop detectors, usually lands between $4,500 and $8,000. Adding automation to a manual pedestrian gate runs $1,200 to $2,600 when the existing posts can be reused. A dual-swing community entry gate replacement ranges from $6,000 to $14,000 depending on gate width and whether masonry work is involved. These are real numbers for Weston’s market, not a national average. We quote the job before any work starts, and that number doesn’t change at the door. Senior and veteran homeowners get a permanent 10% discount. HOA board members can call (877) 610-2993 for a free site walk and written estimate.
We Also Serve Cities Near Weston
If your community is just outside Weston, we cover the surrounding areas too. Our Gate Installation crew regularly works in Southwest Ranches, Cooper City, Pine Island Ridge, and Pembroke Pines. Same local knowledge, same 90-Day Done Right Promise, same live person on the phone. You can see more about our work across the area at our Gate Installation in Weston page, or call us directly at (877) 610-2993.
Serving Weston, FL - Our Local Coverage Area
We’re based in the Weston area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Weston
Yes, Weston requires a Broward County permit for community gate operator replacement, and Gatewood Fence & Gate handles the permit process as part of the installation. We coordinate with the HOA and the city so the job doesn’t stall on paperwork. Call (877) 610-2993 and we’ll check what your specific community needs.
Yes, current UL 325 standards require entrapment protection, and most 2002-era Weston installations don’t have it. A new operator installed without photocells and edge sensors won’t pass a code audit and exposes the HOA to liability. We include modern safety components on every operator replacement in Weston. Call us at (877) 610-2993 for a free site assessment.
Because the failure is usually in the loop detector conduit, not the operator. Weston’s high water table floods unsealed conduit during the June through October rainy season, and the gate gets stuck in fail-safe mode. We diagnose the loop system and reseal or reroute the conduit so the new operator actually works through a storm. Estimates are free at (877) 610-2993.
In most cases, yes. We can mount a Viking or Ghost Controls operator to the existing masonry posts if the post structure is sound and there’s a viable power run nearby. This avoids a construction project and keeps the HOA’s costs down. We’ll assess the posts on site and tell you straight if they can carry the load.
Most Weston HOAs require contractors to be on a pre-approved vendor list before they can bid or do work on community gates. Gatewood Fence & Gate is already on multiple Weston community vendor lists, which means we can start the job without the HOA board having to run a full vendor approval process. If your community needs credentials or insurance documentation, we provide it up front. Call (877) 610-2993 and ask for our HOA packet.
Weston’s Gate Problem Is a Local One
Most gate installation pages give you generic advice about driveway gates. Weston doesn’t have a driveway gate problem. Weston has a community gate problem. Thousands of sliding and dual-swing entry gates were installed between 1995 and 2005 using builder-grade Linear, Elite, and FAAC operators that are now past end of life. They lack the safety photocells and edge sensors that UL 325 now requires. Their power runs were undersized when they went in and have only corroded since. Their loop detector conduit floods every summer. And because every single job runs through an HOA board, the contractor has to understand both the code requirements and the approval process, or nothing gets done.
In The Ridges, our crew replaced a failing Linear slide gate operator with a DoorKing unit after the original’s rack and pinion had worn past adjustment. We also installed new safety photocells and a keypad entry that the property manager had been requesting for two years, coordinating with the HOA board to stay on their pre-approved vendor list. That’s what a Weston gate installation looks like. It’s not a homeowner upgrade. It’s a community-scale replacement, done to current code, with a board that needs to approve every step.
We’re the local company that understands that. Hal Gatewood has been at this since 2001, and his name is on every job. We answer the phone with a live person, 24/7. We quote the job before we start, and that’s the number on the invoice. We stand behind the work with a 90-Day Done Right Promise in writing. Call us at (877) 610-2993 and let’s walk your gate together.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Weston, FL and surrounding communities since 2001.